Rank, from smallest to largest, the pressures in the tank of motionless fluid shown in the figure. {Start with "1" as smallest, followed by "2" as the second smallest, "3" as the third smallest, etc. It is possible to not use all the ranking number available. For locations with the same pressure, use the same ranking number for those locations.} Fluid surface C D

Rank, from smallest to largest, the pressures in the tank of motionless fluid shown in the figure. {Start with "1" as smallest, followed by "2" as the second smallest, "3" as the third smallest, etc. It is possible to not use all the ranking number available. For locations with the same pressure, use the same ranking number for those locations.} Fluid surface C D

Name: Rank, from smallest to largest, the pressures in the tank of motionle
Uploaded: 2024-03-20T06:51:10.000Z
Channel: Bartleby
Description: Rank, from smallest to largest, the pressures in the tank of motionless fluid shown inthe figure. {Start with "1" as smallest, followed by "2" as the second smallest, "3" asthe third smallest, etc. It is possible to not use all the ranking number av

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter11: Fluid Statics

Section: Chapter Questions

Problem 85PE: You are pumping up a bicycle tire with a hand pump, the piston of which has a 2.00-cm radius. (a)...

See similar textbooks

Similar questions

Archimedes' principle can be used to calculate the density of a fluid as well as that of a solid. Suppose a chunk of iron with a mass of 390.0 g in air is found to have an apparent mass of 350.5 g when completely submerged in an unknown liquid. (a) What mass of fluid does the iron displace? (b) What is the volume of iron, using its density as given Table 14.1? (c) Calculate the fluid's density and identify it.
What is the difference between flow rate and fluid velocity? How are they related?
(a) Convert normal blood pressure readings of 120 over 80 mm Hg to newtons per meter squared using be relationship for pressure due to the weight of a fluid (p=hg) rater a conversion factor. (b) Explain why be blood pressure of an infant would likely be smaller than that of an adult. Specifically, consider the smaller height to which blood mast be pumped.
Considering the magnitude of typical arterial blood pressures, why are mercury rather than water manometers used for these measurements?
An ideal fluid flows through a horizontal pipe whose diameter varies along its length. Measurements would indicate that the sum of the kinetic energy per unit volume and pressure at different sections of the pipe would (a) decrease as the pipe diameter increases, (b) increase as the pipe diameter increases, (c) increase as the pipe diameter decreases, (d) decrease as the pipe diameter decreases, or (e) remain the same as the pipe diameter changes.
The human circulation system has approximately 1109 capillary vessels. Each vessel has a diameter of about 8 m. Assuming cardiac output is 5 L/min, determine the average velocity of blood flow through each capillary vessel.
Bird bones have air pockets to reduce their weight—this also gives them an average density significantly less than that of the bones of other animals. Suppose an ornithologist weighs a bird bone air and in water and finds its mass is 45.0 g ad its apparent mass when submerged is 3.60 g (assume the bone is watertight.)(a) What mass of is displaced? (b) What is the volume of the bone? (c) What is its average density?
In an immersion measurement of a woman's density, she is found to have a mass of 62.0 kg in air an apparent mass of 0.0850 kg completely submerged with lungs empty. (a) What of water does she displace? (b) What is her volume? (c) Calculate her density. (d) If her lung capacity is 1.7S L, is she able to that without treading water with her lungs filled air?
Concrete is pumped from a cement mixer to the place it is being lad, instead of being carried wheelbarrows. The flow rate is 200 L/min through a 50.0-m-long, 8.00-cm-diameter hose, and he pressure it the pump is 8.00106 N/m2. (a) Calculate the resistance of the hose. (b) What is the viscosity of the concrete, assuming the flow is laminar? (c) How much power is being supplied, assuming the point of use is at the same level as the pump? You may neglect the power supplied to increase be concrete's velocity.
An airplane is cruising at altitude 10 km. The pressure outside the craft is 0.287 atm; within the passenger compartment, the pressure is 1.00 atm and the temperature is 20C. A small leak occurs in one of the window seals in the passenger compartment. Model the air as an ideal fluid to estimate the speed of the airstream flowing through the leak.
Verigy that the SI of hpg is N/m2.
You are pumping up a bicycle tire with a hand pump, the piston of which has a 2.00-cm radius. (a) What force in newtons must you exert to create a pressure of 6.90105 Pa (b) What is unreasonable about this (a) result? (c) Which premises are unreasonable or inconsistent?