R2 R, L1 E1 E2 L2 RA '4 R3 E4

Q: Problem 4 A horizontal metal bar falls under the influence of gravity. The central half of the bar…

A:

Q: Abattery is comprised of 10 cells connected in series, each cell has an EMF with Ecell = 1.4V and an…

A: we need to find out ILoad.

Q: Series-Parallel Circuit For the following circuit, determine: a) The total resistance RT b) The…

A:

Q: Simplify using block reduction method C(s) R(s) G1 G2 H1

A: Move the take off point to left of G2 and using block diagram reduction techniques find transfer…

Q: R1 R2 C2 S +

A:

Q: For a system with three finite poles and two finite zeros no branch goes to infinity 1 branch goes…

A:

Q: Consider the following RL circuit with Vs-200V, R1-100 ohm, R2- 100 ohm, R3- 50 ohm, L-20 H. The…

A: The general expression of inductor current in series RL Circuit Charging…

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.