R1 R2 3. Given that the battery has a potential of 12 V, resistors R1 = 1N and R2 = 3N, and Capacitance C = 10 µF, find the current through R2 after the switch has been closed at t = 0 and t = ∞. Once the switch has been opened up after some time (after capacitor is charged), find the time that the current through R1 will reach half its initial value.

R1 R2 3. Given that the battery has a potential of 12 V, resistors R1 = 1N and R2 = 3N, and Capacitance C = 10 µF, find the current through R2 after the switch has been closed at t = 0 and t = ∞. Once the switch has been opened up after some time (after capacitor is charged), find the time that the current through R1 will reach half its initial value.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Write the equation for the capacitor voltage and current equations and the voltage at the R2 end when the switch K is turned to position 2.
Ans all . Will give you upvote...
How to solve given a 0.7-H inductor connected in series with a 9-ohm resistor. If the connection is energized from an 11-V DC source, determine the voltage (in volts) across the resistor at t = 2.75 ms. The initial current is 175 mA.
Four capacitors are arranged in a circuit as shown in the figure. C₁ C₂ What is the charge Q3 on capacitor C3? C₂ What is the equivalent Ceq capacitance of the circuit? What is the potential difference V4 across capacitor C4? What is the potential energy U₂ stored in capacitor C2₂? The capacitors have the values C₁ = 38.5 µF, C₂ = 15.5 µF, C3 = 45.5 µF, C4 = 85.5 µF. The power supply is set at V = 32.5 V. Coq = Q3 = V4 = U₂ = µF с J
In the diagram below, the switch S has been closed for a long time. A) What is the output voltage Vout? What is the charge on the capacitor? b) The switch is opened, so the output voltage increases. What is the time constant that describes the charging of the capacitor in terms of R and C? c) When Vout reaches 10 V, the switch closes and the capacitor begins to discharge. What is the time constant that describes the discharging in terms of R and C? Hint: Apply Kirchhoff's Rules to both loops and the sum of the currents at the junction above the capacitor in the diagram, and use I=dq/dt. If the switch opens when Vout reaches a lower value, say 5V, the capacitor will charge again, and thus one can cycle the voltage with a time constant determined by the circuit: this demonstrates the principle of operation of an electronic timer. 4R S 15 V Vout R
Solve the following. Values:N=3M=7L=6K=4J=6
A battery is used to charge a capacitor through a resistor as shown in the following figure. After the switch is closed the energy supplied by the batteryis E. Find the Joule heat produced in the resistor and the energy which is stored in the capacitor.
VR C R E An R-C series circuit consists of a capacitor with capacitance, C, connected in series with a resistor with resistance, R. The resistance, R, is a circuit parameter that opposes the amount of electric charges Q, passing through the circuit per unit time and causes a drop in potential given by Ohm's Law while the capacitance, C, is a circuit parameter that measures the amount of electric charges that the current carries and stores in the capacitor. Both the resistor and capacitor cause the total drop in electric potential and is equivalent to the total electromotive force, E, which is produced by a voltage source such as batteries. E=+Rat As soon as the switch is opened, the initial charge Q, that is stored in the capacitor varies through time, t. In the given differential equation above, the charge Q and the time t are the dependent and independent variables, respectively. The electromotive force E, the resistance R, and the capacitance C are constants. Using A as the constant…
A capacitor is charged with 0.23 watt-sec of energy at a voltage of 48 volts. What is the capacitance? show solution