R1 9V R2 ZENER 3k (+ 1

Q: A three-phase bridge rectifier uses diodes rated at IdRMS = 145, VRRM =1000V and VD=0.7V. The…

A: Given: A three-phase bridge rectifier uses diodes rated at IdRMS=145 AVRRM=1000 VVD=0.7 V The…

Q: i) Design and draw the circuit of an adjustable positive voltage regulator with output voltage range…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: 45) We have buck converter, the maximum current of the inductor is Imax, the minimum inductor…

A:

Q: Average de voltage, VacVm(1+cosa) (volts) Rms output voltage,Vms-Vm ((n-a)+sin2 a/2)2 (volts) Where,…

A:

Q: What are the Q-points of the transistors in the oscillator as shown if VDD = 3.3V, IEE = 2 mA, VTN =…

A: The circuit diagram is shown below: We need to calculate the Q point that is the drain current and…

Q: assume that the diodde in the circuit diagram below is reversed, 1.sketch the output waveform (Vo)…

A: In positive half cycle, Si Diode will be On and Vout will be input voltage after subtracting Diode…

Q: (a) Consider a Loaded Zener Regulator as shown with following Basic Parameters: Vz = 5.1 V at lz =…

A:

Q: (a) Figure 1(a) is a sinusoidal oscillator. Given that the feedback factor is: R³ B= 1 5R R³+j²C²²C²…

A: Since you have posted the question with multiple subparts, we will solve the first three subparts…

Q: Design a transformer-fed HWR that provides an output effective voltage of 60V. Use the ideal diode…

A: Design Hall wave rectifier.  Average output voltage = 60V All diode are ideal state.  Find turn…

Q: a. Explain the use of a capacitor filter with the aid of a diagram. b. Draw the V-l characteristic…

A:

Q: A buck regulator has Vsource 15 V. The average output voltage required is Vo=6 V with peak-to-peak…

A: In this question we need to find a duty cycle, value of Inductor and value of capacitor.

Q: Question 2: The output signal from an AM modulator is: OL I noite9n 9aM (t) o ngiz 1uqiuo orT = A…

A:

Q: For a zener voltage regulator for the given circuit if Vin 30 V constant calculate the range of load…

A: I am answering first question as per the guidelines.

Q: las Rs negligibly mV, and Vo= 5V determine: Av, B, Avf (including the units) Rif, Rof if Ri= 5 Kohm…

A: Given, Vi = 100 mVVfb = 99 mVV0 = 5 V Since the given circuit is connected in series-shunt feedback,…

Q: Consider the circuit shown in Figure P12.52 . Determine the values of R1 and RC if a bias point of…

A:

Q: Write an expression for the output voltagein terms of the input voltage for the circuit. Diode D is…

A: Given: Th diode is connected to form the diode connected transistor. The transistor being used are…

Q: If the load current is 5 mA and the filter capacitance is 1000uF, what is the peak- to-peak ripple…

A: In this question,  Choose the correct option What is ripple voltage ∆V = Vm/2fRC = Im/2fC

Q: loaded zener regulator, has the following parameters: Vin= 16V; the ener rated voltage 10V, series…

A:

Q: Q9. Draw Zener regulator circuit to obtain regulated DC voltage 6.8 V. Considering input DC voltage…

A:

Q: Q.2/ Find the value of R2 in figure below so that the circuit will oscillate.

A: We will answer the first question since the exact one was not specified. Please submit a new…

Q: (a) A conventional buck converter has the following parameters: Vs = 24 V D= 0.7 L = 150 µH C= 200…

A: given:    Vs = 24 volt            Duty Cycle, D = 0.7                               L= 150 μH…

Q: Q4. Design a DSB-SC modulator to generate a signal, k m(t) cos(2ax(300)x(10')t). The following…

A: DSB-SC modulator stands for Double Side Band Suppressed Carrier modulator.

Q: 2-) In the circuit of Figure 2, diodes D, and Dz are ideal. (a) Find and plot the transfer…

A: Find and the plot the transfer characteristics of the circuit Sinusoidal voltage is given to applied…

Q: 30°, the average value of output current in A single-phase full-wave transistor rectifier feeds…

A: We need to find a average output current in the given 1 phase full wave rectifier having RLE load

Q: feeds power to motor load. The source A single-phase full-wave transistor rectifier feeds power to…

A: In this question we need to find a average value of output voltage of rectifier.

Q: (a) Consider a Loaded Zener Regulator as shown with following Basic Parameters: Vz = 5.1 V at lz =…

A: Explanation:     For variable load, input current I is given by I = IZK + IL(max) I = IZM + IL(min)…

Q: Q2) 1. A step-up chopper has input voltage of 220 V and output voltage of 660 V. If the conducting…

A: This question belongs to power electronics . It is based on the concept of step up chopper i.e.…

Q: Design a Bridge FWR to supply a load of (1002) with the waveform shown in figure from the main power…

A: Full Wave rectifier Given Vm=Vout=12VVm=12 V(1) Turns ratio V1 rmsV2 rms=N1N2V1 rms=220 VV2…

Q: Design a buck converter and a resistive load operating in CCM mode with the following…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Draw Zener regulator circuit to obtain regulated DC voltage 6.8 V. Considering input DC voltage in…

A: To solve the above question, one should know about Zener diode and its application. A Zener diode is…

Q: A sinusoidsl voltage of 40V and frequency 50Hz is appled to a HWR with R­L=200Ω, Rf=20Ω, Rr=∞. Find…

A: Since there is lot of sub divisions...., we should solve three of it. Vrms =40 vRL=200Rf =20V0…

Q: F 10:1 D1 D3 Output 115 V rms Vpipri) Vp(sec) 60 Hz R1 2.2 kN D2 D4 50 µF lll

A:

Q: IX- A multiple-junction thermocouple circuit that is designed to- a) Decreases the volt generator b)…

A:

Q: QUESTI SOALAN 2 Figure B2 shows a Single Phase Full Wave AC to AC Converter. A voltage source Vs(t)…

A:

Q: Design a Bridge FWR to supply a load of (1002) with the waveform shown in figure from the main power…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Design a Bridge FWR to supply a load of (100) with the waveform shown in figure from the main power…

A:

Q: repeat the example above for RE = lok sz aud B =70 DC Q-Point = (475 MA ,4.5v) l4.5 v) %3D الم مسوحة…

A: We need to find operating point of bjt .

Q: Q3/ A buck-boost converter generates an output voltage of range 10-14V in CCM. The input voltage is…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: D Question 11 For the Zener follower circuit as shown, the transistor has a current gain of 150 and…

A:

Q: Design a Bridge FWR to supply a load of (1000) with the waveform shown in figure from the main power…

A: As you are not mentioning which question you want . we will solve first question for you. Full Wave…

Q: Consider a buck-boost converter that supplies 75W at lo -5A from a 37À de source. Let T= 13 Ms and…

A: As per the guidelines it is instructed to do first 3 subparts for multiple subparts question. Kindly…

Q: P 3.15)A single-phase bridge rectifier is supplied from a 220-V, 60-Hz source. The load resistance…

A:

Q: Design a 15 V Zener regulator for the following conditions: 1) The load current IL ranges from 200…

A: To solve above question, one should know about Zener diode and its application. A Zener diode is a…

Q: Draw and explain in own words the circuit diagram for improved seriest voltage regulator

A:

Q: Q 4.12: The DC converter is used to control power flow from a DC voltage, V. = 110 V to a battery…

A: We are supposed to be answer of first question as per guildlines.

Q: A flyback converter has parameters Vs = 36 V, D = 0.4, N1/N2 = 2, R = 20 Ω, Lm =100 µH and C = 50…

A:

Q: S. The input voltage of a Boost converter is 10v, the duty cycle of the boost converter is 0.25. r a…

A: CIRCUIT DIAGRAM OF A BOOST CONVERTER: Average value of output voltage, Vo=VS1-D voltAverage value…

Q: Design a boost regulator that has an input 12V. The required average output voltage is 30V and the…

A: Note :- Student asked to solve only sub_part (i) & (ii).    Given, A boost regulator has, Input…

Q: B) For the following left circuit, Assume B=200: dc 1. Determine the Q-point and draw the dc load…

A: From the question Beta Dc 200