Questions 1. Draw the TDM signal with 2 signals being multiplexed over the channel? 2. Define guard time & frame time? 3. Explain block schematic of TDM?

Q: What is the main feature in AM modulation , that is used to judge if the modulation is good or not ?…

A: To analyse the given

Q: 3. Which of the following is not an effect caused by multipath in radio channel?

A: The solution is provided in the following section.

Q: Q4: Draw the constellation diagram of 2*4 QAM signal then show the output amplitudes and phases of…

A:

Q: a. Assume that a channel occupies a bandwidth of 250 kHz. We need to multiplex six channels with…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Using Verilog continuous assignment statements or VHDL signal assignment statements, write a…

A:

Q: Which of the following is not an effect caused by multipath in radio channel? a) Rapid changes in…

A: The solution is provided in the following section.

Q: Why SSB is preferred for transmission of good quality signal

A:

Q: Which of the following is true about sample and hold circuit? a. the capacitor is the hold circuit…

A: The Sample and Hold circuit is an electronic circuit that creates the samples of voltage given to it…

Q: 1. With the help of Octave program perform the Modulation and Demodulation (AM) of information…

A: According to the question, We need to perform modulation and demodulation by using the Octave…

Q: In series clippers, when clipping of signal occurs?  In parallel clippers, when clipping of signal…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Calculate the frequency of the TDM pulses for a 4 - channel TDM transmitter  if the maximum…

A: As per Bartleby guidelines we are allowed to solve only one question, please ask the rest again. The…

Q: A major advantage of PRTs is that they are very linear. A disadvantage is that they have poor…

A: PRT stands for platinum resistance thermometer. Platinum is used to determine the temperature in the…

Q: For a 3000 Hz bandwidth channel has a capacity of 30 kbps. The signal to noise ratio of the channel…

A:

Q: 8.a. Which of the following statements about OSNR and BER is correct? A. BER isn't related to OSNR.…

A:

Q: 5. What is the type of demodulation we used to demodulate SSB signal (part-A). Explain your answer.

A:

Q: For a 4000 Hz bandwidth channel has a capacity of 40 kbps. The signal to noise ratio of the channel…

A:

Q: 4 Scope File Tools View Simulation Help O ID 困 m(t) 0.05 0.1 Ready Sample based T=0.150

A: The time period is defined as the time taken by the waveform to complete one full cycle. Here, the…

Q: Discuss the need of filter. Explain the working LC filter. Draw input and output waveform and derive…

A: A Filter is a AC circuit which is used to perform frequency selection. A filter rejects undesirable…

Q: 5. What is the type of demodulation we used to demodulate SSB signal (part-A). Explain your answer.

A:

Q: what happens when the modulation order is increased for a modulated signal?

A: Modulation:- The process in which imposing the signal of input into the carrier signal is called…

Q: Choose the correct answer low HDOP (Horizontal Dilution of Precision) number such as 2 indicates a…

A: In this we have to find low HDOP (Horizontal Dilution of Precision) number such as2 indicates ...