Question4): Find the current passing through the resistance 32 using Thevenins theorem 2 Ohm 3 Ohm 6 V 4 Ohm 4 Ohm 6 A Subject Lecturer : Alya H. Ali Good Luck

Q: € Problem 1 . For the circuit shown below A) Calculate the equivalent resistance of the circuit. B)…

A:

Q: 5002 5002 5002 500Ω BO

A:

Q: is connected to terminals c and s 0.291/Cº. rcuit is energized by a 24V DO

A: The resistance of a conductor and a semiconductor is depends on temperature. The resistance increase…

Q: 4. Find the mistake from the circuit. How would you measure the voltage and current of the 3k Ohm…

A: Voltage  It is the potential difference between two points, which is defined as the work done per…

Q: Question 2 [ Consider the following circuit and answer the questions below. A) B) C) D) A and B. 12V…

A: In this question We need to determine the equivalent resistance across the terminal A and B. And…

Q: the equivalent resistance between terminals a and b. R1 1 Ohm 20 R3 3 Ohms; R4 R. 4 Ohms 50 520 0

A:

Q: 22. a) For the circuit in Figure belowuse KCL to find the branch currents I: to I. 2 A 7A 14 I3 4 A…

A:

Q: b) Suppose the current in the 10 resistor in the following circuit A is 60 mA, flowing from left to…

A: We need to find out the current for given circuit

Q: Given the power dissipated in each resistor in Figure as follows: P1= P5= 4.5W, P2 = 5W, P3= 1.332W,…

A: Redrawing the figure with labeling the voltages across each resistor as shown below:

Q: Using the Circuit below, determine the following: 1. Determine the current passing through the 7K…

A:

Q: -) In the following circuit using Kirchhoff's find: a) The current in each branch of the circuit. b)…

A:

Q: In the following circuit using Kirchhoff's find: a) The current in each branch of the circuit. b)…

A:

Q: A-In a Wheatstone bridge the actual resistance values of ratio arms are not known, but their ratio…

A: A wheatstone bride is a circuit that is used to measure the Unknown resiatance .    Answers below.

Q: 3)A voltmeter with resistance 'RV' is connected in parallel with resistance of 100.6 ohms. The…

A: we need to error and percentage error.

Q: Draw a schematic (circuit) diagram of four resistors connected to a source (EMF) , where should have…

A: The given color codes for the resistors are: Red, black, red, gold. Yellow, violet, brown, gold.…

Q: How many states will there be in a 4-bit ripple counter?

A: In an n-bit counter, the total number of states = 2n.

Q: Using the Circuit below, determine the following: 1. The Power taken by the 3 ohm resistor 2. The…

A: This problem comes under electrical network theory . It is a problem based on the concept of…

Q: I only solve the equivalent resistance of 2 ohms the rest i am so uncertain with the values i…

A: Since you have calculated equivalent resistance between e and d as 2Ω we will not calculate that. We…

Q: There are three switches in the given circuit shown below. The resistance of the lamps is given in…

A:

Q: Problem 20. The current I flowing in a resistor R is measured by a 0-10A ammeter which gives an…

A: Given: Ammeter Measurement range : 0-10A Voltmeter Measurement range : 0-50V Ammeter Reading =…

Q: Find the value of la through the middle resistor Rs using conversion of voltage and current source…

A: Given  R1 =12 ΏR2 =3 ΏR3 =6 Ώ V1 =84 VV2 =21 V

Q: Q4] find the current of the resistance 300 if the value of the source is:V1= 2.6sin(100πt- 58) volt

A: The circuit can be draw

Q: 1. Solve a. RT total resistance b. IT total current c. PT total power d. Current in each resistor e.…

A: Since you have asked a question with multiple sub parts . So we will solve first three sub parts for…

Q: Use the UT33B multimeter and check the voltage of the batteries and the resistance of, light bulb…

A: Multimeter- It is an electronic measuring device which is used to measure electrical parameter like…

Q: Sixteen identical light bulbs are connected as follows. The power of light bulb A is 10 W (B) H) M)…

A:

Q: A lamp filament is to have its resistance measured by the voltmeter/ammeter method. The test voltage…

A: We need to find error in resistance measurement when we use both methods .

Q: If current source is replaced by resistance R then find the value of R, to maintain same current…

A: Given- Voltage V=230 V, Current I=10 A, Frequency f=50 Hz, Circuit is given. To Find- The value of…

Q: Simulated Values R₁ 430 ohms V₁ 428.58 mV or 0.43 V h₂ 996.71 UA R₂ 1.1k ohms V₂ 157.1 mV or 0.16 V…

A: We need to find out the total current, total Voltage and total resistance for given circuit .

Q: For given figure below, find the equivalent resistance between points a and b if R1 = 5.8 Q, R2= 7.7…

A: Given

Q: 2. Two resistance of 100 and 150, each respectively are connected in parallel. The two are then…

A: Given :  Brief description: Here in the question they are talking about an electrical circuit having…

Q: A 24-V battery is used to supply a 3-carbon type resistor network and two lamps. The connection of…

A: This question belongs to network theory . It is based on the calculation of total resistance and…

Q: Problem # 1 a) Determine the equivalent resistance Riotal for the group of resistors to the right of…

A: The obstruction offered to the current's path is called resistance. The electrical element or the…

Q: hat is the total resistance between node

A:

Q: In what ways are integrated circuits better than discrete ones.

A: Brief description: In the above given question they want to know the advantages of integrated…

Q: VS1 A₁ A₂ R₁ www V₁ R₂ V₂ R₂ A V₂ As R₁ VA R$ V₂

A:

Q: 10-Identify all pairs of series or parallel connected resistors, in this circuit. 11-If all the…

A: Here, The resistance R2 and R3 are connected on series and they are connected in parallel with R4…

Q: Based upon the following assumptions: V1 = 13V, V2 = 20V, R1 = 1kQ, R2 = 8700, R3 = 3kQ, R4 = 3.2kQ,…

A: The Thevenin’s Voltage in a Thevenin’s equivalent circuit of a network is open circuit voltage…

Q: Which of the following does not work for Ohm's law? O a. Current value changes O b. Resistance value…

A: We need to tell which option is correct for the given statement.

Q: A parallel combination consisting of resistors A and B is connected across the terminals of a…

A:

Q: The current through each

A:

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.