QUESTION THREE80450A90A604Figure 1130Figure 1 above show2 wire dic distributor0.25 km long. It is loaded at 0.05 km Intervals. Ifmaximum voltage drop is not toexceed 10theand theresistivity of Core of material is 7x2507x12/54 0.7 x 2.54 M 12 cm, determine the maximumCross - SectionalareaofeachConductor.

In distributed DC With a two-wire DC system, there are two conductors, a positive conductor and a…

QUESTION THREE 804 50A 604 90A Figure 1 120 Figure 1 above show a 2 wire dic distributor 0.25 km long. It is loaded at 0.05 km Intervals. It the maximum voltage drop is not to exceed 10v and the resistivity of Core of material is 07*254 07254 0.7 x 2.54 M & cm, determine the maximum Cross-Sectional area of each Conductor.

QUESTION THREE 804 50A 604 90A Figure 1 120 Figure 1 above show a 2 wire dic distributor 0.25 km long. It is loaded at 0.05 km Intervals. It the maximum voltage drop is not to exceed 10v and the resistivity of Core of material is 07*254 07254 0.7 x 2.54 M & cm, determine the maximum Cross-Sectional area of each Conductor.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

For the following magnetic circuit, the flux density is 1 T and magnetic field intensity is 700 At/m. The material of the core is d C cast iron cast steel sheet steel None of the above
what is the introduction for MEASUREMENT USING DC BRIDGES
One disadvantage of low power factor is O Reduces conductor sizes Reduces electricity bills O Increases the voltage drop in the system O Reduces copper losses
The minimum value of current at which the fuse element melts is called
13. Thevenize the bridge circuit across a-b in figure 13.
Determine the following
The losses found in a transformer
A barium titanate crystal has a thickness of 2 mm. Its voltage sensitivity is 12*10-3 Vm/N. It is subjected to a pressure of 0.5 MN/m2. What is the voltage generated ?
Example 1-10 (SI) For the cast-iron core shown in Figure 1-9, find the flux density. It has uniform cross- sectional area. 2A- 240 Turns -4 cm Figure 1-9 Core for Example 1-10. 2 cm
The resistivity of Cu at 0°C is 1.30×10-8 2m. The change in resistivity per degree Celsius is 0.02×10-8 Qm/°C. If resistivity of a Cu-10at%Ni alloy at 0°C is 5×10-8 Om, calculate the resistivity of Cu-40at%Ni alloy at 100°C. O 8x 10-8 Qm O 11 x 10-8 Qm 14 x 10-8 Qm O 17 x 10-8 Qm.
The number of disc insulators used in a suspension insulator setup with string efficiency 90 %, phase voltage 33 kV, and the voltage across insulator nearest to conductor 10 kV is
100 W ans