Question No. 1 (CLO 1) Assume an LTI system has impulse response: (-2 h[n] = 2 n = ±1 n=0 otherwise 0 Apply time-domain analysis to determine the output of this system for input x[n]: x[n] = 2 n=0 3 n = 11 n=2 -2 0 otherwise

Q: f galvanometer is 8 mm / µ A. If the internal re cer is 80 ohm then the deflection of galvanome n…

A: In this question P,Q,R,S given..V given..Current sensitivity and internal resistance of galvanometer…

Q: Since R1=8992.04ohm, R2=8155.31ohm and Ri=Infinite in the circuit given in the figure, write the…

A: The given circuit is, Here,

Q: Water stored in your house tank will have O a. All of these O b. chemical energy O c. potential…

A: The detailed answer is solved below according to the given parameters and instructions in the…

Q: Q2) Explain the The difference between power signal and energy signal (with equations) i) i) Unit…

A:

Q: converts the energy of fluid into mechanical energy and drive shaft

A: In this question we need to complete the given statement.

Q: Determine total charge entering the terminal between t=3 s and t=6 s if the current passing the…

A: In this question,  Current in the terminal is given, find the charges entering in the terminal from…

Q: Based on the response curve, answer the following questions: (a) What can be said about the order…

A: The time response plot subjected to a unit-step input of a spring-mass-damper system. The peak value…

Q: Q1\ An ohmmeter has a moving coil of resistance 25 2 with 5mA full scale deflection current. The…

A: Given,For an ohm-meter,Internal resistance, Rin = 25 ΩFull scale deflection current, IF = 5mABattery…

Q: Current is the flow of charges in a directed path. When we connect your mobile phone charger to the…

A: Charging up a battery is the exact opposite of discharging it: where discharging gives out energy,…

Q: In the figure the ideal batteries have emfs E- 19.3 V, E2 - 9.84 V, and Eg - 5.30 V, and the…

A:

Q: *Chapter 27, Problem 045 In the figure the resistances are R1 1.6 V, and 82 E3 = 4.2 V. What = 0.99…

A:

Q: 12. If overcurrent protection is provided in the transformer of a separately derived system, which…

A: A separately derived system is defined as a premises wiring system in which there is no direct…

Q: 201503131 3. Two batteries with E, 3V and E2 = 5 V are connected with three resisters R₁ = 10 ohms,…

A:

Q: resistors are expected to be 10 ohm according to theory but actual values are dlfferent this is what…

A: Resistor is a passive element which absorb active power and dissipate as a heat. The power factor of…

Q: A device can be modeled with a voltage source in series with a resistace. The device is shown in…

A: A device can be modelled with a voltage source in series with a resistance. The device is shown in…

Q: Briefly explain the relationship between voltage current and resistance. Write your conclusion

A: In this question , we will find relationship between voltage , current and resistance...

Q: b. A heater coil is made using a material of cross section 3x10-“m² and a resistivity of 4 x100-m. A…

A: The power dissipated in the coil is given by :- P = V×II  = PVI  = 455050R  = VI      = 50×504550…

Q: 1. How can you calculate electrical power of a device for DC circuit: a. By multiplying voltage by…

A:

Q: 1. Explain the principle of operation of Figure 1. Derive the equations that govern each block of…

A: The AC powered desktop regulated linear power supply operates by converting the AC mains voltage…

Q: Sir as you can see in the diagram below when the voltage is zero current is maximum at the…

A: The charging and discharging in an AC circuit can be alternatively explained as the storage and…

Q: Problem No.2 group Six group of batteries are in parallel. Each has 10 cells connected in series,…

A: Given that each group has 10 cells and each cell has emf of 6 V and resistance of 0.4 ohm. Total 6…

Q: B F E D

A: Given

Q: Calculate the resistance of 100 meters length of a wire having a uniform cross- sectional area of…

A: We have to find the resistance of the wire by considering all the parameters given in the questions.

Q: Q2: In order to calculate the heat loss through the wall of a building. it is necessary to know the…

A: Given inaccuracy of ±1%  of Full Scale reading Range : 0°C to +50°C Temperature at each side of Wall…

Q: The 555 timer is mounted and connected to the power and ground terminals of the IC. The circuit…

A: The given circuit diagram is of Astable multivibrator using IC 555.   Requirement is R1 > 1kΩ R1…

Q: In the figure R₁ = 140 02, R₂ = R3 = 54.00, R4-76.10, and the ideal battery has emf ε = 6.00 V. (a)…

A: Given circuit, E=6.00 VR1=140 ΩR2=54.0 ΩR3=54.0 ΩR4=76.1 Ω

Q: A linear resistance potentiometer is 50 mm long and is uniformly wound with wire having a resistance…

A: We have an potentiometer with, Length (l) = 50 mm Resistance of potentiometer = 10000 Ω and we have…

Q: In the given circuit, the resistances of each resistor is 2 Ohm. The ideal batteries have EMFS E1=…

A: Redraw the circuit and represent the node voltage.

Q: Medium resistance: This class includes all resistances of values between 10 2 and 100 k Q. Most of…

A:

Q: I-V curve of a hypothetical piecewise linear device is given below. 个工() 2+X Here, x = 03 1. What…

A: As per the guidelines, we can only provide the solution of first three questions in multiparty type…

Q: A lead wire with a radius of 0.5 mm and a length of 20 cm is connected to a potential difference of…

A: Given diagram,

Q: A 15kVA, 440V, single-phase alternator draws a field current of 5A at rated load. With the same…

A:

Q: The table below shows some performance parameters of a certain power transformer. Full-load voltage…

A: In this question,  Choose the correct options What is power factor to become zero voltage…

Q: Input angle, 8) + 50 volts A BIC - 50 volts Output voltage, vt) FIGURE P1.1 Potentiometer

A: Given data: The given diagram is shown below,

Q: an you please appear the solution. Thanks

A: L=5 H,R=16 Ω,E=120 Volts.

Q: Q31 A- A series type ohmmeter, show in figure below uses a 500 basic movement requiring a full-scale…

A: Given Rh =2000 Ω Rm =50 Ω V=3 V Ifsd =1 mA

Q: B: A series-type ohmmeter, designed to operate with 6.1-v battery. The meter movement has an…

A:

Q: Thousands of applications of such as lighting and electrometallurgy are longstanding and…

A: As per the guidelines, we supposed to answer one question at a time so please ask other questions…

Q: A battery with E8.00 V and no internal resistance supplies current to the circuit shown in the…

A: In the given circuit the value of the resistance based on the different conditions of the switch…

Q: 2. Figure 1 shows a voltmeter connection with 15 kO/ sensitivity, connected across Rb. Calculate the…

A: The solution is given below

Q: A PMMC instrument has internal resistance of 0.58 kn and gives full scale deflection for 28 mA. The…

A: we will find voltage across the meter and then we will calculate the voltage across the multiplier…

Q: When you are solving for circuit problems from the data obtained from experiments, what is the…

A: When you are solving for circuit problems from the data obtained from experiments, what is the…

Synchronous Generator

In comparison to an asynchronous generator, it is a machine where the rotor speed is equal to the rotating magnetic field produced by the stator, i.e., mechanical speed is equal to the electrical speed, thus called synchronous, and not asynchronous.

Salient Pole Rotor

Salient pole rotor includes a large number of exposed poles mounted on a magnetic wheel. The construction of a bright pole is as shown in the image on the left. The proposed poles are made of metal laminations. The rotor winding is provided on these poles and is supported by pole shoes.