Question: Knowing that each portion of the shafts AB, BC and CD consist of a solid circular rod. If the shear modulus of elasticity is 90 GPa and the shaft has a diameter of 20 mm, determine; (a) the shaft in which the maximum shearing stress occurs (b) angle of twist at A. 90 Nmi 180 Nm 80 Nm D C В A 0,5 m 0,75 m 1,25 m

Q: DETERMINE THE AVERAGE PUNCHING SHEAR STRESS THE CIRCULAR SHAFT CREATES IN THE METAL PLATE THROUGH…

A:

Q: A 116.79 kips (B 172.79 kips 92.79 kips A 119.38 kips B 40 kips 1.5" V 40 kips C From the figure,…

A: dia of rod AB=2''allowable stress in rod AB=55ksi

Q: For the shaft loaded as shown, which point(s) at the section shown experiences the maximum shear…

A: Let's draw the FBD  for first figure At the L shaft observe the stresses and their directions…

Q: The solid aluminum shaft has a diameter of 50 mm and an allowable shear stress of Tallow =60 MPa.…

A:

Q: The 20-mm diameter shaft is subjected to torques as shown. The shaft is made of steel with the…

A:

Q: A B C 80 kN 2 m 50 kN D E F -1m--1 m--1 m--1 m-|

A:

Q: The compound shaft consists of a solid aluminum segment (1) and a hollow brass segment (2) that are…

A: J1 = π32×0.554 J2 = π32×0.354-0.234

Q: 3. Determine the required diameter of the pins at A and B to the nearest 1mm if the allowable shear…

A:

Q: 1. The assembly is shown is attached to supports at A and D. Section BCD is a solid 2" diameter…

A:

Q: Problem 2 (for all students). Determine the state of stress, the principal stress and the max in-…

A: Calculating the moment of inertia: IP=π32504-404    The torque will be:T=6×300=1800 KN-mmThe bending…

Q: 8 kN 4 m 15 kN 5 kN 2 m 2 kN 2m 2m A B с D E The aluminum rod shown has a diameter of 20 mm and is…

A: Given: diameter, D = 20 mm E = 70 GPa

Q: Part 2 * Your answer is incorrect. The z-component of momemt M will cause compression at A and B,…

A:

Q: The shaft is made of A992 steel. It has a diameter of 0.7 in. and is supported by bearings at A and…

A:

British Gravitational Bg System Of Units

Measuring is the comparison of a particular physical quantity with its reference value. A unit is a fixed physical quantity. The length is a physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.