QUESTION: According to OSHA's key forklift loading requirements, when should the forks be tilted forward? The forks can be tilted forward: POSSIBLE ANSWERS: Olf carrying a load that is off-center. Olf the forklift is unattended or powered off. OWhen picking up or dropping off a load. Whenever the forklift is in use.

Q: Define the term the radius of the pedestal?

A: The pedestal is basically a compression member used as a support for columns or other structures

Q: A single fixed pulley simply changes the direction of the pull, but it doesn't ___. A. Change the…

A: A single fixed pulley simply changes the direction of the pull, but it doesn't change the amount of…

Q: QUESTION 2 Which of the following is an advantage with the wire ropes in lang lay? OA Do not kink or…

A: given =multiple choice question

Q: 2) Write introduction and conclusion for Lift Mechanism Bucket Boom Shou Mou Base

A: Parts of lift mechanism is- Base Mount Boom Shoulder Bucket

Q: What is the safest way to drive a forklift in reverse? Keep your eye on the load, but turn around…

A: 11. Steel jacks are mainly needed to provide support to the trailer jack. When the trailer is…

Q: QUESTION 4 A wire rope shown below is made with 1/8-inch diameter wires, and it has an outer…

A: given = multiple choice question

Q: When trying to accommodate only axial loading, which of the following bearings is most likely to be…

A: (a) Tapered roller bearing This type of bearing is used in the places where, vertical and horizontal…

Q: a 1 3/4 inch diameter shaft supported by two sleeve bearings, the total load on the two bearings is…

A: Given Data

Q: The stroke in this mechanism is twice that of the crank length

A:

Q: Identify the zero force members (if any) in 3 kip H. 2 kip T. 8 ft 3 kip -1.5 kip- 4 ft |B C ID -10…

A:

Q: What distributed load provides equilibrium? 12 ft. 200 lbs

A: Given that: A distributed load of w and a concentrated beam of 200 lb are applied to the beam. The…

Q: What happens if the load on an actual column exceeds its critical loading?

A: There are two types of the column, 1. Short Column 2. Long Column The slenderness ratio and length…

Q: Which of the following materials combinations are most likely to fail due to excessive wear in the…

A: 316L Stainless Steel Ultra High Molecular Weight Polyethylene is most likely to fail due to…

Q: Design for 95% male grip force. Use a minimum factory of safety of 2.50. Determine dimensions not…

A: By using the above data and some engineering principles, we can calculate the value of dimension C…

Q: For the manufacture of a pipe wrench would you select: a. Fe-0.4%C steel b. Fe-0.4C steel abs case…

A: Pipe wrenches are available in different sizes from 3 inches to 48 inches or larger. A pipe wrench…

Q: What is the forklift trucks system?

A: Forklift trucks are the industrial vehicles used for transportation of cargo from one point to…

Q: How mary MI4 10.9 bolts used in Vith &s Systen ?

A: ANSWER- 5 BOLTS

Q: What is the method used for specifying the allowable load for a member/

A: Allowable load is defined as the amount of load when applied on a member does not cause any failure…

Buckling of columns

The column is described as a vertical member of the structure that carries an axial compressive load, and buckling is a lateral deformation of the column under the application of load.