Question 9 Ocount below the maximum count allowed per counter.Ocount beyond the maximum count allowed per counter.Ocount up and count down.Orecord the time of an event.QUESTION 9The output Lot Full Light will be energized when the accumulated count is:Ladder logic programL1 Inputs0000300.O 0.100.150.ENTERSWITCHEXITSWITCHRESETENTERSWITCH36EXITSWITCH36C5:1/DN36RESETQUESTION 10When input PB2 is actuated:CTUCOUNT-UP COUNTERCounterPresetAccumulatedrCTDC5:11500COUNT-DOWN COUNTERCounterC5:1PresetAccumulated1500C5:1(RES)(CU) LOT FULL(DN)LIGHT(CD)(DN)LOT FULLLIGHTC5:1(RES)Output L2

QUESTION 9 The output Lot Full Light will be energized when the accumulated count is: Ladder logic program L1 Inputs ENTER SWITCH potop 300. EXIT SWITCH O-RESET O 0. O 100. 150. ENTER SWITCH 36 EXIT SWITCH 36 C5:1/DN E RESET 36 CTU COUNT-UP COUNTER Counter Preset Accumulated CTD C5:1 150 0 COUNT-DOWN COUNTER Counter C5:1 Preset 150 Accumulated 0 (CU) LOT FULL (DN) LIGHT (CD) (DN) LOT FULL LIGHT Output L2 C5:1 (RES)

QUESTION 9 The output Lot Full Light will be energized when the accumulated count is: Ladder logic program L1 Inputs ENTER SWITCH potop 300. EXIT SWITCH O-RESET O 0. O 100. 150. ENTER SWITCH 36 EXIT SWITCH 36 C5:1/DN E RESET 36 CTU COUNT-UP COUNTER Counter Preset Accumulated CTD C5:1 150 0 COUNT-DOWN COUNTER Counter C5:1 Preset 150 Accumulated 0 (CU) LOT FULL (DN) LIGHT (CD) (DN) LOT FULL LIGHT Output L2 C5:1 (RES)

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

8. Parallel conductors must be installed in sizes no smaller thanA. 1/0.B. 2/0.C. 750 kcmil.D. 4/0.
In an electrical system, each of the service entrance conductors has an area of 750 kcmil. The size of analuminum grounding conductor that will be brought to the service should beA. 250 kcmil.B. 4/0.C. 2/0.D. 500 kcmil
- Loads, Service, and Overcurrent Protection 6.a. The general lighting load is based on a _______ per square foot basis.A. kilowattB. number of circuitsC. volt-ampereD. general illumination6.b. What's the primary disadvantage of using copper conductors?A. AvailabilityB. WeightC. CostD. Durability
11 and 12 , i need this answer
The calculated demand factor for 60 ft. of commercial track lighting is _______. Select one: a. 4500 VA b. 3000 VA c. 2500 VA d. 2250 VA
What is the minimum number of 15-ampere lighting branch circuits required if the dwelling has an occupied area of 400 ft2(368m2)
all elements in a circuit that carry the same current are said to be ______ a. closed-loop b. network c. series d. bilateral
What is the meaning of calculated load?
What is the unit E?
20.a. What's the primary disadvantage of using copper conductors?A. DurabilityB. CostC. AvailabilityD. Weight20.b. The NEC requires that each service-disconnecting means be suitable forA. hazardous locations.B. disconnecting the meter.C. wet conditions.D. the prevailing conditions 20.c. As a general rule, each building or structure is limited to a single service. What's an automatic exceptionto this rule?A. A second service deemed suitable for useB. A second service having the proper markingsC. Emergency systems or fire pumpsD. Higher building occupancy
1. Alternating current systems of less than _______ volts are required to be grounded if they're installed outside as overhead conductors. A. 50 B. 100 C. 75 D. 120
6. Since the voltages across each branch circuit in a residence are the same, these circuits areA. connected in series.B. connected in parallel.C. controlled circuit configurations.D. complex circuit configurations. I'm not sure if it's the letter B or C, could you help me with the correct answer.