Question 9: Determine the vertical and horizontal components of force acting on radial gate ABC in figure and their lines of action. What force {F} is required to open the gate when the gate is hinged at point "O". Water A +r-23-0 Gate 2m wide

Question 9: Determine the vertical and horizontal components of force acting on radial gate ABC in figure and their lines of action. What force {F} is required to open the gate when the gate is hinged at point "O". Water A +r-23-0 Gate 2m wide

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: GIVEN: Cantilevered rod shown 500* Rigid bar r-6 inches L- 18 t REO'D: At section where A and B are…

A: At section x in AB Vx = 500 lbs ← Ny = 1000 lbs T Vz = 100 lbs ↓ Mx = 100 ×183 = 600 ft-lb CW My =T…

Q: The gate AB shown in the figure is rectangular and is 1.2m perpendicular to the paper. Compute the…

Q: The gate shown in the figure is in raised position but initially is not filled with water (a.) If…

A: Center of pressure: The mean position of all the pressure applied on a fluid moving body is…

Q: Hught = 6m Width = Lim (into the page as drawn) Radius of Curvature = 6m Centroid 5m below the water…

A: Given :- Height = 6 m Centroid = 5 m below free water surface width= 4 m

Q: 12. A COUPLE CONSISTS OF TWO VERTICAL FORCES OF 70 LB EACH WHICH IS FOUND ON FIGURE 11. ONE FORCE…

A: Given data:- A couple consists of two vertical forces of 70 lb One force acts up through A and the…

Q: The recessed rectangular gate is located at an angle of 45 to the water surface. The gate is 5 m…

Q: Given F = -14î + 84j + 56k and TBA = 1.5î – 3j – k. Determine the magnitude of th | component of…

A: Solution Given Data F⇀=-14i^+84j^+56k^rBA⇀=15i^-3j^-k^

Q: Figure B 2 of 2 As shown, a gate has a parabolic shape that follows the equation y=C-³x², where C =…

A: d = 3.70 ft b = 1.75 ft = 62.4 pcf

Q: Q5: Calculate the force exerted by the piston at A to hold the curved gate in the position shown in…

Q: to The 6-m-wide rectangular gate shown in the figure is hinge making an angle of 45° with the…

Q: (a) (b) (e) A 10' 8 kips B Find critical points 10' 0.25 kips/ft C Calculate moment at these…

A: “Since you have posted a question with multiple sub parts, we will provide the solution only to the…

Q: The jib crane is designed for a maximum capacity of 15 kN, and its uniform I-beam has a mass of 220…

A: Given, R = 160.6x2- 93.526x + 255.46 Operating range x = 0.2 to 3.7m

Q: Three cables attached to the eyebolt apply the forces shown. Determine the resultant force applied…

Q: Find the force P that is applied to keep the 3-m-wide gate in the position shown in the Figure…

A: Figure shows the water contained on the left side of the gate

Q: Gate AB is 7m wide. Determine force F that would keep the gate from rotating at B. Provide your…

A: AB= 7 m widesp. wt of water= 9.79To determine- The force F that would keep the gate from rotating.

Q: Determine the magnitudes of the components of F acting along and perpendicular to segment BC of the…

A: Calculate the position vectors of all the points. The position vector for Point A is: The position…

Q: Problem 2: Determine the magnitude of the resultant force per meter length due to water acting on…

A: We will find horizontal and vertical forces separately and take resultant of them.

Q: Figure shows the side view of a tank with a curved gate. The gate width into the page is 18 in. The…

Q: Please solve using paper:Problem 13. Replace the force system shown by an equivalent resultant force…

Q: the

Q: find support reaction and draw moment and shear diagram ( use by double integration method)

A: GIVEN BEAM

Q: Q9: For the quarter circular gate AB in Figure below find the horizontal force Fx, vertical force…

A: Given data Quarter circle Depth of emersion Radius To find out Horizontal force Vertical force

Q: Determine the magnitude and direction of the smallest force (F) that should be applied at point A to…

A: Given: The moment at point O is 610 N.m. The value of a is 5 m.

Q: 2m A 2m 2m B.

Q: Conduct the force analysis of the structure for the given set of loads (shown in Figure 1), and…

A: To determine:Axial forces in truss elements

Q: Patm Wall Seawater: y= 64 lb /ft 17 ft Gate Patm 7.2ft -9.6ft Hinge FIGURE FOR ITEMS 5,6,8&7: The…

Q: A quarter circular gate (BC) is hinged at the point C under water as shown in the sketch below.…

A: Given data Width of gate (B) = 4m Radius of gate (R) = 2m Find force F.

Q: Given in the Figure, find the best gate design that results in a minimum resultant force on the gate…

A: As the dimension of w shaped gate is not given it is difficult to calculate exact value of resultant

Q: a) Find the location of the shear center for a beam with the cross-section shown in Fig. 6. All…

Q: For the beam supporting the loads, determine the slope and deflection of the free end using AREA…

Q: 3. Draw the internal force diagrams (and include all significant values) for the following system.…

Q: Draw the snear Tor ending ulagr answer the 400 lb/ft B

Q: A water gate is to be reinforced with three horizontal beams (running to the page). If the water…

Q: 5.44 Assuming frictionless, incompressible, one-dimensional flow of water through the horizontal tee…

A: Velocity at section 1 , V1=6 m/s pressure at section-1 , P1=200 kPa=200×103 Pa Diameter of each…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

For questions 1 to 5, consider a bent rod fixed at the wall at A and is acted upon by a 20- N force (parallel to the z-axis) and a 50-N force (parallel to the y-axis) applied at points B and C, respectively. y₁ Z A -4 m- F = (-50j - 20k) N, C = (100i +80j - 200k) N-m F = (-50j) N, C = (100i +80j - 200k) N-m F = (-50j - 20k) N, C = (200i +40j - 100k) N-m F = (-50j - 20k) N, C = (100i + 80j) N-m C -2 m- 50 N 20 N. B 4. Which of the following best valuates the equivalent force-couple set at A of the applied forces 20 N and 50 N? Note: F is the resultant force and C is the resultant couple X he support at A? R are force reactions and M are
-/5 : Two rods and one cable are attached to the supports at O. If two of the forces are as shown, determine the magnitude F and direction of the third force so that the resultant of the three forces is vertically downward with a magnitude of 1400 lb. F 830 lb 300 lb 8 10:38 pm 44 ENG 29°C Mostly cloudy 04/06/2022 0 48° ance is ± 1 in the 3rd nt digit. F = i, Type here to search -1080- Esc 0 35° 44 $ lb O O At % 5 F6 € 6 O & 7 7 8 8 ( ||| E
Pls dont round off intermidiate values, round off in final ans only
Answer in 3 decimal places.
Find the moment (kN-m) at point A if the following data and figure are given: 1 square = 1 sq.meter F1 = 6 kN %3D F2 = 13 kN %3D F3 = 16 kN C1 = 23.kN C2 = 25 kN %3D %3D (Input the value in two (2) decimal places only without the unit) F1 C. 2 F3 C F
calculate the normal forces acting on the 10N, static,beam. 9. Calculate the normal forces acting on the 10N, static, beam. 1m 5m 2m 12N 8N
Answer the following and box your final answer
If the gate was designed to withstand a maximum force of 6,000 lbs, verify the gate will not break when the tank is filled with gas.
If the magnitude of the resultant force acting on the bracket is 650 N, directed along the positive u axis, determine the magnitude of F1.Determine the direction ? of F1. F₂= 650 N F₁ F3 = 500 N No need to draw any diagram
Note:hand written solution should be avoided.
Q2: In Figure below if width of the gate = 2B, find Fy and its line of action 4 circular arc Water
kindly show complete solution: