Question 8: For the common base configuration of the circuit below, determine: re, rins, ro, Ay and A;? Note that: a = =0.998, RL = 1MN and VBE = 0.7V GV -10V 4.7kO 6.8kQ 10HF 10µF Vi H

Q: The JFET of has gm0 = 6000μS. If IDSS = 12 mA, Find the value of drain current at VGS = -2 V?

A: Need to find drain current from given data

Q: Solve the collector-emitter voltage (VCE) of Figure 612. VCC T8V Beta = 110 R2 3.9kQ Figure 612…

A: We need to find out collector to emitter voltage for given circuit

Q: For the following self-bind cåveuit, find equivalent circuit acpas Bale aud ground. •Vcc RI Baul 3Re

A: The Thevenin equivalent across base and ground:

Q: Assuming a JFET has an Ipss = 9 mA and VGs(off) = -8 V (maximum). Using these values, determine the…

A: By drain current equation we will find out drain current .

Q: Given the following specification for the JFET in the circuit below (ldss = 10 mA and Vp =-3 V),…

A: We need to find out the resistance value for given circuit for given current and voltage .

Q: How do we know current flows in source terminal? Is this common for n-type mosfet? What is an n-type…

A: How do we know current flows in source terminal? Is this common for n-type mosfet? What is an n-type…

Q: M1 and M2 are matched, what is the output common mode voltage? Draw the output wave form if Vi is a…

A:

Q: 1.draw the small signal model of this circuit. 2. Show how Ron was derived

A: According to the question, for the given circuit as shown below We need to determine, 1.Draw the…

Q: B Figure 1 (for numbers 6 to 9). VB is 3V, Vcc is 9V, RB is 10K and RL is 1K and (beta)=100. IE R₂…

A: Given data Vb=3v Vcc=9v Rb=10k Rl=1k Beta=100

Q: V1 -12V till $1 Key - A R3 www 24kQ R2 2400 Q1 2N3904 D1 1N4739A Vz=9 LED1 Q2 2N3904 R1 33002

A:

Q: Solve the emitter voltage of a voltage-divider bias circuit with Vcc=9V, R1=560k ohms, R2=560k ohms,…

A: Types of biasing for Transistor  Fixed bias Self bias Voltage divider bias Collector bias Emitter…

Q: we can see the following signal at which point of the modulator? 6 A Modulating signal D Carrier -…

A:

Q: Consider a 9.4-bit ADC and full scale voltage measurement range of (-41V to 41V).The Resolution will…

A: Resolution given by R = v range/ (2n -1) Vrange = 41-(-41) = 82 n = 9.4 bits

Q: By using graphical approach, find Ipo and VcsQ for the figure shown, where VDp = 9V, Rp = 3KN, Rp =…

A: Given circuit: VDD=9 VRD=3 kΩRF=11 MΩIDon=7 mAVGSon=4.5 VVT=3.5 V To find: By using a graphical…

Q: Assume Icq = 3mA, Vceq = 10V for the given transistor circuit. Find the R1 and Rc values. 22V Rc…

A: consider the given question;

Q: Exp:- For the circuit s hown- the transi'sto has B ,50 VBE = 0.6 v cakulate R required to Set Vc= 5…

A:

Q: What will be the MOSFET operation if Vth = 1.2V and k = 0.5 mA/v^2?

A: In this question,   We need to check the mosfet is working or not?

Q: Assuming a JFET has an Ipss = 5 mA and VGs(off) = -7 V (maximum). Using these values, determine the…

A: By drain current equation we will find out drain current.

Q: ECE Topic: Thyristor 4. What holding current would you use in the design of an SCR circuit if you…

A:

Q: 1-The output voltage of an emitter follower is a-In phase with Vin . b-Much greater than Vin. c-180°…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: The transistor shown in the crout below has a oument gain of p-100. You may assume the voltage…

A:

Q: VC R1 RC C1 Q1 Ry C2 ER2 RE

A:

Q: In a N-Channel JFET if the voltage across the drain and source (VDS) is increased then explain in…

A: This question is from "Advance Analog Electronics". Under which we are going to study(learn) the…

Q: (CLO-3, C3, C5 , C4) a. Draw a Thevenin equivalent circuit of the circuit shown in the figure below…

A: This is a very simple question based on voltage divider bias . In this all the 3 steps are described…

Q: Find the voltage drop across the 150resistor and 300resistor.

A:

Q: The SCR operation characteristic is plotted for la (anode current) vs lg (gate current), Va (anode –…

A: Silicon Controlled Rectifier (SCR) is the most important and widely used member of the thyristor…

Q: 8.5 A JFET has a specified pinch-off voltage of 5V. When VGs = 0, what is the Vos at the point where…

A: In this question , we will write about JFET drain to source voltage where drain current becomes…

Q: For an N-channel JFET Idss = 8mA and Vp = -6V, if Vgs = -2V then what is the value of the Drain…

A:

Q: TM S UTM (b) SUTM (1), the output voltage, Va TM SUT (ii) the voltage drops across series…

A:

Q: Please check

A:

Q: F. The main types of fielde D BJT and FET UJT and FET JEET and MOSEET

A: Since you have asked multiple question ,we will slove the first question for you .If you want any…

Q: 4. Given VDD-3.3V and VT-0.55V find Vout for the following Vin voltages (a) 0.6V(b)3.8V(c)8V(d)0.22V…

A:

Q: In the voltage divider bias find the value of emitter voltage and emitter to collector voltage if we…

A:

Q: Q-2: Explain the saturation of a transistor. Find the given unknowns for the figure below. a. Rc. b.…

A: The solution can be achieved as follows.

Q: Fill in the following blanks 1- for normal operation of a PNP , the base must be -------- with…

A: We have to answer one question at a time.So Solving the question first only.

Q: A fixed bias n-channel JFET with Vdd= 12V, Rd= 1.2k ohms. Idss=12mA and Vp=-4V. Determine Id.…

A:

Q: QUESTION 8: A Widlar current source has the configuration shown in the following figure. Assume the…

A:

Q: Based on the truth table generated, what logic function is performed by this circuit? Explain. Draw…

A: Need to design the given logic circuit in the tinker CAD software.

Q: Transform and draw the equivalent small signal circuit model using ONLY the HYBRID-PI model.

A:

Q: Consider an NMOS with tox=9 nm, Un=500cm²/Vs, Vt=0.7V, and W/L=10. Find the drain currents for the…

A:

Q: P By using mathematical approach fin! @VGS O ID © VDS For the figure 16 V 2k- Vi 2 M2 VP= -8 V

A: