QUESTION 6 Two inductors are connected in parallel to a 120 volt, 60 Hz line. The values are 5 H and 2 H. The total inductive reactance is Oa. 289.36 ohms Ob.326.35 ohms Oc 538.07 ohms Od.840.58 ohms

Q: Q4) A 1496 IC balanced modulator has a carrier-level output of 150 pV. The amount of suppression…

A: For the given balanced modulator circuit specifications, the value of the input voltage based on the…

Q: Discuss whether NEC provides the maximum requirements or minimum requirements.

A: NEC is the acronym of National Electrical Code.

Q: Give an example of a screen and an application generator

A:

Q: 6. Determine the approximate values of each of the following quantities in Figure 6. a. b. If C.…

A: an inverting OP-AMP with input resistance of 2.2kohm and feedback resistance of 22kohm is given when…

Q: which the voltage regulation is maximum and the value of this regulation.

A:

Photoconductive Cell

Photoconductive cells are light-sensitive resistors in which resistance is inversely proportionated to light intensity when illuminated. These devices consist of a thin single-crystal or polycrystalline film of composite semiconductor materials. Cadmium sulfide (CdS) is used to make the most commercially available photoconductive particles which are sensitive to light in the visible spectrum. Other less commonly used substances respond to infrared light, but not to the visible spectrum. Such substances are lead sulfide (PbS), lead selenide (PbSe), and lead telluride (PbTe), and so on.