QUESTION 5) Two elastic bodies made of different materials are placed in a rigid cavity and their surfaces are in full contact. In the vertical direction, a uniform pressure force acts on body 1 with 120MPA and on body 2 with 40MPA. Calculate all the stresses in objects 1 and 2 and the length changes in the z-axis direction.

QUESTION 5) Two elastic bodies made of different materials are placed in a rigid cavity and their surfaces are in full contact. In the vertical direction, a uniform pressure force acts on body 1 with 120MPA and on body 2 with 40MPA. Calculate all the stresses in objects 1 and 2 and the length changes in the z-axis direction.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

The solid rod shown in the figure below has radius of 0.63 in. If it is subjected to the force of 435 lb, determine the state of stress at point A using superposition. 8 in. 10 in. 15 in. В 435 lb
Determine the strain energy stored in the frame shown in the figure. Take EA=GA=EI=1
The stresses shown in the figure act at a point in a stressed body. Determine the normal and shear stresses at this point on the inclined plane shown.
The following stress element represents the stress state at point A of the structure in the figure below. Determine the principal stress angle in this condition. 52.8 MPa 26.4 MPa O a. 15.80 degrees O b. 30.25 degrees O. 36.15 degrees O d. 22.50 degrees
Determine the strain energy stored in the frame shown in the figure. Take EA=GA=EI=1.
In the cylindrical coordinate system, stress component Trz = 23 N/m². Trz acts on a surface (shown below) whose normal direction points in the positive r direction. The area of the surface is 40 in². a) How much is the magnitude of the force acting on this surface due to trz? b) What is the direction of this force? c) Identify the other two components of stress on this surface and draw their directions if they are positive. 10
The bars shown below, with solid circular cross-sections, are made of a material with an elastic modulus E = 20,000 ksi and a coefficient of thermal expansion α=(15×10^(−6)) 1/°F Bars AB and BC are subjected to a temperature change in addition to the applied forces. If the reaction at C is 8 kips in compression, determine the temperature change ∆T
A wire of 2 mm diameter is wound round a circular shaft of 1 m diameter. What are the maximum normal and shear stresses in the wire? Specify the planes of their occurence. E = 1 x 10 N/mm², Assume no applied tensile pull on the wire.
Problem The maximum stress produced by a pull in a bar of length 1 m is 150 N/mm2. The area of cross-sections and length are shown in Fig. 4.3. Calculate the strain energy stored in the bar if E = 2 x 105 N/mm2. 200 mm 100 mm 200 mm A C D 475 mm 50 mm 475 mm
The following stress element represents the stress state at point A of the structure in the figure below. Determine the principal stress angle in this condition. 52.8 MPa 26.4 MPa O a. 22.5 degrees O b. 30.25 degrees O c. 36.15 degrees O d. 15.80 degrees
The stresses shown in the figure act at a point in a stressed body. Determine the normal and shear stresses at this point on the inclined plane shown. 147 MPa 85 MPa
I need the answer as soon as possible