Question-3 A gate having the triangular shape shown in the figure below is located in the vertical side of an open tank. The gate is hinged about the horizontal axis AB. The force of the water on the gate creates a moment with respect to the axis AB. Determine the magnitude of this moment. Vertical wall Water Gate -6m

Q: SITUATION 7: Three forces P1, P2, and P3 are acting on a semi-circular structure as shown in Fig.…

A: Given:The value of The value of The value of The value of The value of The value of The diagram for…

Q: find the horizontal and vertical forces acting on the block in terms of Q

A: Given:-  To Find:-  horizontal and vertical forces acting on the block in terms of Q

Q: Problem Statement Based on Problem 4-151 from the textbook. The pipe assembly is subjected to the…

A: Given: Here is the given data, Force, F=31.7 N To determine: The system to indicate the position of…

Q: .Find the complete placement reaction in the image below Responso 12 kN 3 m 3 m C D 4 m 8 m ¥15 kN 4…

A:

Q: What is the moment that the water exerts about the bottom edge of the dam (point P)?

A:

Q: Question-3 A gate having the triangular shape shown in the figure below is located in the vertical…

A:

Q: The seawall shown below consists of a flat section AB = 3-m with another section, BC, shaped like a…

A: Given- AB=3m h=5m

Q: A vertical wall is used to separate a reservoir of fresh water (? = 1000 kg/m3) from one containing…

A:

Q: |P-3 KN P3 = 2KN KNi 1 KN/n -2 KN/m 1 AA AB 4.00 8.00 2.00 4.00 2.00

A: Given: In the given picture, a beam is subjected to a system of loading consisting of two…

Q: The hanging structure in the figure below is homogeneous. Its weight (40 kg) is acting at the center…

A:

Q: A 7 m long steel shaft weighing 250 kg is supported at points A and B as shown in the figure. If the…

A:

Slope and Deflection

The slope in a deflected beam is described as an angle in radians made by the tangent of the section with the original axis of the beam. The deflection at any point on the axis of the beam is defined as the lateral displacement of the point before and after loading.