Question-3 A gate having the triangular shape shown in the figure below is located in the vertical side of an open tank. The gate is hinged about the horizontal axis AB. The force of the water on the gate creates a moment with respect to the axis AB. Determine the magnitude of this moment. Vertical wall Water Gate -6m

Question-3 A gate having the triangular shape shown in the figure below is located in the vertical side of an open tank. The gate is hinged about the horizontal axis AB. The force of the water on the gate creates a moment with respect to the axis AB. Determine the magnitude of this moment. Vertical wall Water Gate -6m

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A 7 m long steel shaft weighing 250 kg is supported at points A and B as shown in the figure. If the weight of the shaft acts at point G, determine the moment of the weight about point A in Cartesian form. Assume the point G is located at the coordinates (1m,3m,1.5m) & if the support at B creates a reaction force Bx and By as shown, determine these reaction forces. Assume B is located at 3 m from the origin O along the z-axis
Determine the magnitude of the resultant force (in N) of the coplanar force system shown in the figure below where the horizontal force P = 191 N and the couple M = 535 Nm.
The wheelbarrow with a load weighs 118 kg, and its center of gravity is located at point A. (The entire weight can be considered to act at point A. Use g = 9.81 m/s².) How much vertical force F is needed to lift the wheelbarrow's handles?
4) Determine the total moment caused by the forces Fp4 and Fca about the plate diagonal that goes through point B (the dashed line). Write your answer in cartesian vector notation. FCA= 500 lb 14 ft FRA = 350 Ib FDA= 400 lb 3 ft-> 3 ft 3 ft 2 t 6 ft
1) What is the resultant summation of forces FCA and FDA? Write the resultant force in Cartesian vector notation. Please retain your answer as it will needed for other problem(s) (1 PA=500 lb 14 fi FA=400 lb D>
Example (2-13): The plate is subjected to the two forces at (A) and (B) as shown. Determine the magnitude of the resultant of these two forces and its direction FA= 8kN measured clockwise from the horizontal. Solution : Parallelogram Law : The parallelogram law of addition is shown in Fig. a. Trigonometry: Using law of cosines (Fig. b), we have: B F8 6 kN
(g) Strain _cannot be determined at a point because it requires a reference length. _is not dimensionless but is in units of %. _is always the response to a controlled stress, not the other way around. _tensors are not symmetric like stress tensors are. None of the above (h) What is the strain energy density for polycrystalline Cu (E = 130 GPa) under a normal stress of 11.4 MPa? _100 J/m^3 500 J/m^3 1 kJ/m^3 1 MJ/m^3 _None of the above
Find the magnitude and direction of the resultant force for the system of forces shown in the figure. Where F1 =10 N, F2 =15N, F3 =10 N, F4 =55N, F5 = 70N & F6 =70N. The angles ϴ2 =20ᵒ, ϴ3 =35ᵒ , ϴ4 = 40ᵒ, ϴ6 = 45 ᵒ (1) The horizontal component of the given system (unit is in N) = (2) The Vertical component of the given system (unit is in N) = (3) The resultant of the given force system is (unit in N) = (4) The direction of Resultant is (degrees) =
Determine the magnitude of the force exerted by the cable at B of the bar shown in Figure. 260 3.5 m 2300 N 2.8 m 3.3 m
The weight of the base is negligible What is the moment of the weight of Part G3 about Point A? What is the moment of the weight of Part G3 about Point B? Are the two moments equal? Explain
a2/ A square plate of 10 cm side is subjected to five forces, applying at the corners, the mid- points, and quarter-length point of the side, as shown. Determine the moment about left-below corner? S00 Left bellow corner 300 I300