Question 3: A diesel engine powers a boat. The engine’s cylinders each have a compression ratio (Vmax/Vmin) of 2 and the Vmax is 4ft3. If 1 cylinder is in the isobaric expansion stroke, find the final temperature if the initial temperature is 540F?   From question no. 3, if the gas tank accident happened on top of Mt. Everest’s summit where patm is only 33.7 kpa and the readings obtained are the same, find the new final temperature ?

Q: Oxygen at P1=10 bar and T1=25 oC is compressed to P2=50 bar in a single stage compressor. If the…

A:

Q: Steam enters the turbine at 10 bar. Output pressure P = 1 bar, knowing turbine efficiency is 80%.…

A: GIvenP1=10 barP2=1barηT=80%part awhen T1=250oCPart b when T1=325oC

Q: 5. Dynamic force presents a greater risk of strain than static force. True False

A: “Since you have asked multiple questions, we will solve the first question for you. If youwant any…

Q: 30. The entering air of a diffuser in a jet engine with a velocity of 1850 ft/sec relative  to the…

A: According to the given data P=1.05 Psia V=1850ft/sec T=-60F We need to find The inlet Mach number

Q: Completely solve and box the final answers. Write legibly In a steam turbine plant, a single bleed…

A: The T-s diagram of the given power plant is here, x is the fraction of steam extracted To…

Q: 3. Please consider the isothermal compression of an Ideal Gas from Vo to Vo/8 at 100 C. a. Please…

A:

Q: Air is compressed in a diesel engine cylinder. The initial pressure and temperature are 105 kN/m and…

A:

Q: 10 m3/min of free air is to be compressed to 8 bar gauge in two stages. Assuming a 2 bar gauge…

A:

Q: The refrigerant leaving the .7 compressor follows

A: This question is based on the concept of refrigeration process and refrigeration cycle.

Q: There are compressed 1122 lb/hr of oxygen by a 13.92" x 14", double acting, motor driven compressor…

A: Given dataP1=14.7 Psi=101.35kPaT1=106F=314.26KP2=45 Psi=310.264 kPaN=100 rpmm˙=1122 lb/hr=0.1539694…

Q: The air standard given in the figure is the pressure ratio 7 of the regenerative Brayton cycle and…

A: Write the given values using suitable variables. Here rP signifies pressure ratio, P1 signifies…

Q: hermodynamic cycle diesel solutions. You need a solution after 30 minutes

A:

Q: The following parameters are recorded on a gas turbine test rig. Stage-1: Inlet temperature is…

A:

Q: Q1: The ideal otto engine working on the air standard has a temperature and pressure at the…

A: GIVEN DATA PRESSURE P1 = 1bar = 100KPa TEMPRATURE T1 = 25'C = 25+273 = 298K THERMAL EFFICIENCY η =…

Q: Ql: The ideal otto engine working on the air standard has a temperature and pressure at the…

A: Given Data P1=1 bar T1=25°C=298 K Thermal efficiency= 48% K=1.4

Q: Quiz 1: An indicator diagram taken on a dlesel engine shows that the compression curve follows the…

A: Data given -  Diesel engine  Pv1.4 = C  Pb = 10 bar  Pa = 1 bar

Q: a) Find the actual and isentropic temperature of the exit from the 1st stage. b) Find the actual…

A: As per honor code and answering guidelines I can answer 1st. 3 subparts of the question.If you want…

Q: The Otto engine intakes 0.4 kg of air at 100 kPa and 300 K. The air is compressed compression ratio…

A: Disclaimer: “Since you have posted a question with multiple sub-parts, we will solve the first three…

Q: 1. An adiabatic expansion of air occurs through a nozzle from 828 kPa and 71°C to 138 kPa. The…

A:

Q: At the beginning of the compression process of an air standard Otto cycle, p1 =1 bar, T1 = 300 K.…

A:

Q: QI: The ideal otto engine working on the air standard has a temperature and pressure at the…

A: Given data: The initial temperature at the compression is T1=25°C=298 K The initial pressure at the…

Q: Q3/ Answer the following question: A turbocharged, 4 cylinders and 2 liters engine operates with…

A: The number of cylinder, k = 4 The volume of the cylinder, V = 2 liters The speed of the engine, N =…

Q: odynamics Instructions: Draw the T-s and Sch

A: P1=10MPaT1=600CP2=0.2MPa To-Find:- a) Enthalpy at exhaustb) Quality at exhaustc)Workd) Heat ratee)…

Q: A sample of steam is at a pressure of 500 kPa (x=0.9) before entering a condenser then exiting it…

A:

Q: OTTO CYCLE At the start of an air-standard Otto cycle's compression process, P1 = 1 bar, T1 = 300…

A:

Q: Vaporsat enters a throttling valve at 0.42 MPa and leaves at 0.69 MPa. What is the state and…

A: Answer: (a) The temperature of the exit stream is 164.356 ℃. (b) The state of the exit stream is…

Q: Determine the mean effective pressure in kPa of a certain air -standard Diesel cycle which has a…

A:

Q: A saturated liquid-vapor mixture of water, called wet steam, in a steam line at 1500 kPa is…

A: Given        Pressure, P1 = 1500 kPa                         P2 = 50 kPa Temperature, T2 = 100oCFind…

Q: A 2-stage compressor is used to compress from 1.0 bar to 12 bar. The compression is as per the law…

A: Given: P1=1.0  barP4=12 barT1=300 KV1=4m3/min

Q: A four-stage single-acting air compressor running in an atmospheric at 87 kPa and 15°C has a F.A.D…

A:

Q: A turbojet is flying with a velocity of 900 ft/s at an altitude of 20,000 ft, where the ambient…

A: Draw T-s diagram for turbojet cycle.

Q: The pressure ratio of a Brayton cycle with an air-powered regenerator is 8. The lowest and highest…

A:

Q: A boiler operates at a pressure of 70 psi and the water enters at 100°F. Calculate the boiler…

A: Given: Boiler pressure P=70 psi Inlet temperature of water T1= 100oF To find: Boiler efficiency

Q: Q/ reciprocating compressor with single acting single stage, the air entering at 15°C and 2 bar. the…

A: Given Data At state-1 T1=288K P1=2bar At state-2 P2=13 bar Speed of rotation, N=200 rpm L/D=1.5…

Q: A Diesel air-standard cycle has a compression ratio of 17.6:1. The pressure and temperature at the…

A: Given dataDiesel air standard cycle has the following propertiesCompression ratio = CR= 17.6 =…

Q: An ideal gas Diesel engine, that has an inlet temperature and pressure of 19 °C and 102 kPa…

A: Given Data State 1:19°C,102 kPa Tmax=1285°C

Q: 2- Comparison of gas turhines and I.C. engines with Classification and application

A: The internal combustion engine is also known as a heat engine that is capable to generate mechanical…

Q: Fifty (50) kmol per hour of air is compressed from P₁ = 1.2 bar to P₂ = 6.0 bar in a steady-flow…

A: draw diagram? T1=300ku1=10m/sT2=520ku2=3.5m/sP1=1.2barP2=6bar

Q: 26. For a compression ratio of 4.56 (V1/V2), determine the final temperature of air inside the close…

A: