Answered: Question 22 The average value of the…

Question 22 The average value of the sinusoidal wave current is 15A. The maximum value is... 12.32A 65.98A 36.45A 23.56A

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.10MCQ: The average value of a double-frequency sinusoid, sin2(t+), is given by (a) 1 (b) (c) Zero

See similar textbooks

Related questions

Q: 4. A 107.6 MHz carrier is frequency modulate by a 7-KHz sine wave. The resultant FM signal has a…

A: We need to analyse the given frequency modulated signal .

Q: D5.7. Using the values given in this section for the electron and hole mo- bilities in silicon at…

A: Semiconductors- Semiconductors are used in personal computers, smartphones, digital cameras,…

Q: What is called Fossil Fuels and what are the main 3 types of Fossil Fuels?

A: Fossil fuels Fossil fuels are responsible for providing energy. These fossil fuels are decomposed…

Q: Find the ammeter current. 10 4V 10 ww

Q: Question 1 The maximum value of a sinusoidal voltage is 220 V. it's rms value is 140.02 V 311.17 V…

A: In the above given question they have mentioned maximum voltage of the sinusoidal signal that's 220…

Q: A series RLC circuit is excited by an ac voltage v(t) = Sint. If L=10H and C=0.1F, then the peak…

Q: 8N www Isc 24V Vo 2V₂ www. 452 20 www Rth ܕܢ www a) Determine the Thevenin equivalent of the circuit…

Q: An RLC parallel resonant circuit has a resonance frequency of 1.5 MHZ and a bandwidth of 1KHZ. If C=…

A: In this question, We need to choose the correct options We know Bandwidth in the RLC parallel…

Q: ind the branch currents using (a) Maxwell's Loop Current Method and (b) Nodal Analysis. En

Q: Construct a 5-2-2-1 weighted code for decimal digits. What numbers does 1110 0110 represent in this…

A: To do: a) We have to construct 5-2-2-1 weighted code for decimal digits. b) what numbers does 1110…

Q: Please refer to the photo below. Thank you And please kindly write legibly because I'm having a…

A: In this question we will find ohmmeter reading. .

Q: A load of 10 MW operating at a power factor of 0.5 lagging is connected to a 400 V, 60 Hz source.…

Q: Referring to the given circuit, what is ZTH if R₁ is changed to 220 ?

A: Resistance in parallel- 1/Req=1/R1+1/R2+1/R3+........... Resistance in series-…

Q: 5. A frequency-modulated signal, which is modulated by a 3-KHz sine wave, reaches a maximum…

A: We need to analyse the given frequency modulated signal .

Q: Find Vo for the circuit in Figure using: 1. Mesh analysis 2. Nodal analysis 3. Thevenin's theorem

Q: Question 4: Determine the diode state and the values of I and VR for the circuit below, assuming…

A: Need to determine the diode state and the values of I and VR for the given circuit.

Q: 8. An AM transmitter has a 1-kW carrier and is modulated by three different sine waves having equal…

Q: What size branch-circuit conductor (THHN) is required for a 32A continuous nonlinear load that…

A: Given Conductor type =THHN load current =32 A load type = continuous non linear load

Q: The power in a series R-L-C circuit will be half of that at resonance when the magnitude of current…

Q: Part A You find that if you place charges of ± 1.50 μC on two separated metal objects, the potential…

A: given, In part A, Charge on 2 separated metal object, Q=1.50 μC=1.50×10-6 C, Potential difference…

Q: A load is supplied the complex power S = 60 + j80 VA by a voltage source of 50 cos 377t V. Find the…

Q: DO NOT COPY FROM OTHERWISE Correct and detailed answer will be Upvoted else downvoted. Thank you!

Q: 1. A metropolitan utility company in a western city of the United States expects the consumption of…

A: Given: In this question, the given details are, A metropolitan utility company in a western city of…

Q: Fill in the blanks. I would love to see how to get the correct answers.

Q: For each of the following transfer functions, write, by inspection, the general form of the step…

A: As per Bartleby Policy we can answer only one question at a time. As you have not mentioned so I am…

Q: solve the given question in the image in handwritten no need to type the answer.

A: According to question: Transfer function is of the form ∵G(S)=KN(S)D(S) Zeros of transfer function…

Q: Question 26 Determine VTH when R₁ is 180 and X₁ is 90. R1 90 Ω VS RL 30/0°V 12.220° V —00000) +1₁ XL…

A: In this question we will find thevein voltage....

Q: A 200μF capacitor is connected in series to a 250V, 60Hz source. Assuming its resistance is 2002,…

A: For the given values of resistance, capacitance and frequency we need to compute equivalent…

Q: A three phase 480 V, 50 hp, 6 pole, 60 Hz induction motor has a full load slip of 2.5%. Determine…

A: Given: In this question, the given details are, A three phase 480 V,50 hp,6 pole,60 Hz induction…

Q: Theveni'ns theorem is not applicable when: 1) Load is coupled with the network 2) Linear 3) Time…

A: Thevenin’s theorem : It is possible to simplify any linear complex circuit, to an equivalent circuit…

Q: 4. A co-efficient coupling of 0.58 linked the two inductors with a mutual inductance of 25 uH. What…

A: Given : Coefficient of coupling(K) = 0.58 Mutual inductance (M) = 25 uH Other inductor value (L1) =…

Q: A compound microscope consists of a 8x eyepiece & a 38x objective 16 cm apart. Assuming the final…

A: Given,Magnification of objective, mo=8.Magnification of eyepiece, me=38,Length of the tube, L=16cm.

Q: Voltage-Multiplier Circuits 1. Determine the voltage available from the voltage doubler of Fig. 123…

A: Since, it has been only asked to solve problem 47 in this given question, thus solving the relevant…

Q: A 15 KHz tone is recorded at 8000 Hz. The frequency of the tone when played back at 8000 Hz is ____…

A: we need to find if a 15 KHz tone is recorded at 8000 Hz. The frequency of the tone when played back…

Q: Select the letter of the correct answer from the given problem. *Kindly provide a CLEAR and…

A: Voltage across the capacitor in resonance circuit = Q×( voltage applied)

Q: 9. A 1-MHz, 40-V peak carrier is modulated by a 5-kHz intelligence signal so that m = 0.7. This AM…

A: We need to find out the power for different components of modulated signal .

Concept explainers

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.

Question

100%

Select the letter of the correct answer from the given problem.

*Kindly provide a CLEAR and COMPLETE solution* (Answer should be typewritten)

*Please answer it ASAP

Question 22
The average value of the sinusoidal wave current is 15A. The maximum
value is...
12.32A
65.98A
36.45A
23.56A

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

54. Practical average value of a sinusoidal wave is taken only at three cycles. True False 55. In a sinusoidal waveform, effective value is equal to (1/1.4142) of its peak to peak value. True False 63. For a practical inductor, the voltage leads the current by an angle of more than 90 degrees. True False
13. determine the frequency of a sinusoidal wave that has an equation of e = Emsin270t A. 42.97 Hz B. 24.79 Hz C. 35.14 Hz D. 45.54 Hz 14. The rms value of half wave rectified sine wave is 100A. its maximum value is: A. 198 A B. 202 A C. 200 A D. 199 A
Define the following: a. R.m.s value of a sinusoidal wave. b. Form factor , Peak factor. c. Power triangle ( with figure)
An alternating current varying sinusoidally with a frequency of 50 Hz has anrms value of 20 A.a) Determine the instantaneous value at 0.0025 seconds.b) Determine the instantaneous value, 0.0125 seconds after passingthrough a positive maximum value.c) At what time, measured from a positive maximum value, will theinstantaneous current be 14.14 A?
sinusoidal form
C. Draw a general sine wave V vs t and I vs t plot for a purely resistive and a purely inductive circuit and show leading lagging parameters and clearly mark the phase difference.
For the sinusoidal waveform shown in Figure, determine (a) Time period, (b) its frequency, (c) peak- to-peak voltage, (d) average voltage and (e) r.m.s. voltage
Ooredoo 876% D 9:31 Red Bull MOBILE Assignment EP se..6c205abd8b27a - Saved Q1. A square waveform with following specifications RMS Voltage 163.21 Time for two cycle 35ms Sketch the Square waveform. [1] Q2. A coil impedance of 680 is connected and the circuit has capacitance of 0.002mF is
Find the RMS value..
32
A pure sinusoidal waveform with a period time or 0.02, has a frequency of 50Hz, define the angular frequency of the phasor representing the waveform with a simple phasor diagram.
3-1 to 3-5 and 3-9 to 3-12 please