Question 20 A network administrator configures the interface G17 on R1 with the command ip address 178.18.28.234 255.255.255.0. However, when the administrator issues the command show ip route, the routing table does not show the directly connected network. What is the possible cause of the problem? a) The interface Gi7 has not been activated.

Question 20 A network administrator configures the interface G17 on R1 with the command ip address 178.18.28.234 255.255.255.0. However, when the administrator issues the command show ip route, the routing table does not show the directly connected network. What is the possible cause of the problem? a) The interface Gi7 has not been activated.

Database System Concepts

7th Edition

ISBN:9780078022159

Author:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Chapter1: Introduction

Section: Chapter Questions

Problem 1PE

See similar textbooks

Similar questions

A route must be distributed using an EIGRP parameter, correct? Exit interface and IP address of the following hop are two examples of variables that might alter the administrative distance.
Write an access list that denies IP traffic from host 152.5.35.83, permits IP traffic from host 104.2.64.34 and all hosts on networks 185.25.0.0/16, and denies all other IP traffic. Invoke your access list inbound on interface S0/1.
We have an IP address of 100.120.142.34/20 Assuming that the network router is assigned the largest IP address in the range, what is the IP address of the router?
Write the commands to configure the interface FastEthernet0/0 with IP address 192.168.1.1 and subnet mask 255.255.255.0. Given that initially, the prompt is at user mode that is Router>. Show also the prompts. Giving detailed explanations.
Q1
When you do a system scan, you'll notice a session with a host at 208.85.40.44:443. For this session, what protocol is being used?
Suppose you have been given this classful IP address 110.24.33.34. You want to create a network of 1024 (assignable) IP addresses, what will be the length of network and host part?Write down the subnet mask for this IP addressWrite down the Network ID for this network along with prefix lengthWrite down the broadcast IP address in this networkHow many additional (extra) IP addresses do you have in this network? (Whereas the requirement is 1024 IP addresses as mentioned above)
Given the topology below, write the commands to advertise the OSPFv3 networks on the Sohar router. Use the following requirements: - Enable IPv6 routing- Process ID 10 - Router IDs (Sohar router = 2.2.2.2) - Advertise Network address for each interface - LAN interface (G0/0) set to passive interface - Assign Link-Local Addresses (fe80::1) to G0/0
Please written by computer source Write a Snort rule to detect a connection attempt on the telnet server which has an IP address 192.168.32.129 and generate alerts for packets with content ‘Telnet!’ directed to the server.
posted so many multiple times dont waste my question will compliant
Answer this question please
A host with IP address 120.57.28.13 sends a limited broadcast packet to all hosts in the same network. What are the source and destination IP addresses used in this packet?