QUESTION 2 In the power system shown below, a three-phase short circuit occurs at point F. Assume that the generators are operating at rated voltage, determine the fault curent. Choose SB = 40MVA and VB = 35kV 22kV, 30MVA, 11% 20MVA, 6% G1 (6 + j8)N F G2 33 kV 1: 3 22kV, 20MVA, 15%

QUESTION 2 In the power system shown below, a three-phase short circuit occurs at point F. Assume that the generators are operating at rated voltage, determine the fault curent. Choose SB = 40MVA and VB = 35kV 22kV, 30MVA, 11% 20MVA, 6% G1 (6 + j8)N F G2 33 kV 1: 3 22kV, 20MVA, 15%

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: 4.A generating station has the following daily load cycle : Time (Hours) 0-6 6-10 10-12 12-16 Load…

A: In the generating system, Daily load curve data are given Find the maximum demand Energy per day…

Q: In a system of 132 kV, the circuit phase to ground capacitance is 0.2 uF and the circuit inductance…

Q: A 6 pole, 3.3 kV, 50 Hz dalta -connected three-phase induction generator has the following…

Q: Which of the following is not a boundary condition for an SLG fault on phase 'a' of a power system?…

A: Since the single line to ground fault occurs on the phase a of the system the fault current of phase…

Q: sformer 1200 KVA, 11000/2200 V, 50 Hz e reactance/phase of the primary winding ar ding values for…

Q: Four conductors meet at a junction. the current are i1= 5sinwt, i2= 3sin(wt + 90) and i3=…

A: The solution can be achieved as follows.

Q: Problem 3 A three-phase short-circuit occurs at F in the system reactances are all in percent.…

A: In this question, find the short circuit MVA rating if fault occured at the point F. Short circuit…

Q: The subtransient reactance of a generator is typically much larger than the steady-state reactance.…

A: 1 ) generally the subtrasient response of a generator is larger than the steady state reactance. So…

Q: D.C shunt generators are most suitable for arc winding

A: The most suitable DC genrator for arc welding is Differential compund genrator.

Q: There are two loads connected in parallel and powered from a 7200-V source. The first load is 50-kVA…

Q: /hat does it mean when the power factor is leading? rue or false: 1) A load with a leading power…

Q: 5. Obtain the symmetrical components of a set of unbalanced currents I-1.7 25°, I,=0.761800 and…

A: In this question we will find symmetrical components of current...

Q: Instantaneous power output of a single phase 60 Hz generator will not be constant under following…

A: Instantaneous Power: Instantaneous power is defined as the electric power available at any given…

Q: Load duration curve Hours 0 500 2000 4500 6000 8760 Mw 50 Load 50 35 30 20 |15 there are two (2) -40…

A: Rating of each generator = 40 MW Energy = power X time Plant load factor = Actual energy generated…

Q: Three synchronous generator are connected in parallel to a an infinite s. G1 only provides active…

Q: A 400 V, 3-phase alternator is subjected to an unsymmetrical fault. The

A: Ia=Ia0+Ia1+Ia2Ia=-j10+j6+j4=0Therefore , it is Double line to ground fault Fault current is -…

Q: During fast decoupled Method load flow analysis in one of the loads the calculated reactive power…

A: The power system analysis has non linear equations of power. The equations are involving voltage…

Q: In long shunt DC generator Series field winding current Ise is equal to

A: -The circuit diagram for long shunt DC generator is given below:

Q: For the circuit shown, if a symmetrical three-phase fault occurs in node 2, determine a. The…

Q: A three-phase generator is connected to three 90 Q load resistors. Each coil generates 120 V ac. A…

A: We need to tell the current value through the neutral line.

Q: What is the difference between load and delta?

A: Delta is a type of connection in which we connect the load or source on delta .

Q: Single Phase and Three Phase Principles

A: As per Bartleby guidelines we are allowed to solve only one question, please ask the rest again.

Q: (d) A non-liner load is connected to a 110 V, 50 Hz power supply. Determine whether the current of…

A: It is given that: V=110Vf=50Hzharmonic=3rd

Q: It has been decided to establish a new electrical machines laboratory. This project includes a new…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: A 100kW generator, 250V, 6 poles have a wave wound armature with 300 turns then the number of…

A: The solution can be achieved as follows.

Q: Question 4 A star connected neutral grounded 3-phase synchronous generator consists of 0.1 p.u of…

A: In this question we need to find a zero sequence reactance of genrator

Q: reactance diagram

A: Transformer- A device that transfers the electrical energy between two electrical circuits which are…

Q: Can you explain regarding shunt reactor and shunt capacitor?

A: Shunt Inductive reactor Inductive reactor absorbs lagging VAR and supplies leading VAR. The…

Q: Which of the following is the rotor fault of alternator? Phase to earth Over current Inter turn Non…

A: Choose the correct option Which of the following is the rotor fault of alternator?

Q: Thyristor regulators A.C TYPE GENERATORS GENERATOR TYPES ACCORDING TO THE NUMBER OF PHASE

A: Thyristor regulators Thyristor power controllers (SCR power controllers) control power & voltage…

Q: 7. Three load units A, B, and Care connected in parallel and take currents that are respectively 11…

Q: Calculate the currents I1, I2 and I0, as well as the active power supplied to the load secondary sid

A: Considering vueltas as turns N1 = 200 turns N2 = 80 turns

Q: 02Agle phae aveltag cnterin the figure elm haaret ad of end the ingut vetape i 1201, se l. The deles…

A: We will derive output rms voltage from the given firing angle. From obtained output rms we will…

Q: ompare between 2-phas notor and universal moto

A: On the basis of the construction and working principle there are various types of motors like…

Q: A 300V, 60kW shunt generator has 1200 turns on each pole of its field wind ing. On load a current of…

A: It is given that: V=300 VP=60 KW=6000 W

Q: Adjustment resistance in rotor system will --------when three phase load .decrease Increase O not…

A: Adjustment resistance is also known as external resistance. Purpose of adding external resiistance…

Q: 210⁰ and Ic=980 cis - 60°. Find the negative sequence of phase B current. 11. The phase B current of…

A: In this question we need to find a current in line B

Q: QUESTION 8 Select all correct answer(s). A 50 MVA RE generator is generating 40 MW active power.…

Q: T or F, modify the wrong part if False, please underline twice your answer if True or False.…

A: In an alternator the armature current is in range of Kamp , so it is difficult to handle the large…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Trending now

This is a popular solution!

Step by step

Solved in 5 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

powe system Q8
7. Two 440V, 60Hz, 6 pole, 30 AC generators are running in parallel. The first supplies the busbars with 525kW of power at a power factor of 0.79 lagging. The second provides the busbars with 415kW at a power factor of 0.96 lagging. An additional load that requires 275kW at a power factor of 0.89 leading is added to the busbars. The two generators have their governor and magnetization controls adjusted so they provide 440V, 60Hz and share the active and reactive powers equally. What is the active and reactive power produced by each and their line currents and speeds?
IL = 0.49 < -25.84° p.u V1 = 0.14286< 41.99° p.u V2 = 0.06897 < 33.09° p.u V3 = 0.0353 < 30.47° p.u V4 = 1< 0° p.u
A three phase power system has a fault level of 500 MVA and Sg = 100 MVA at a 132 kV busbar. What is the pu impedance at that bu O j5 pu O jo.2 pu O 0.264 pu O 3.788 pu
please hellp me solve this one i need to paass this exam please provide a complete and detail solution, please. subject is elecetrical circuts 2. just the number 9.
The figure shows a 3-phase bala Time left 1:06:30 200 /00 Vrms. sequence electrical system. Vcn Vbn %3D al Balanced (-) sequence 100 so a 2000 Vms Select one: O a. 200 /-120 Vrms O b. 200 v2 /0 Vrms O C. 200 /0 Vrms O d. 200 v2/-120 Vrms e. 200/120 Vrms
Solve it quickly please
No Handwriten please
The primary is 3000 turns, while the secondary is 6000 turns a. single-phase b. double-phase c. step-up d. step-down