Question 2) Forces of F1=7 kN in the +y direction and F2=13 kN in the -z direction are acting on the arm from point B in the figure. From the point C, a moment of magnitude M=4 kN.m acts in the +y direction. The lengths of the arm are also given as L1=0.8 m and L2=0.6 m. The radius r in the a-a section taken over the arm is r=0.023 m and it is desired to determine the stress state at point A. The shear modulus of the sleeve material is G=78 Gpa. According to this; Question 2-A) Find the shear stress at point A due to the shear force. (Write your result in MPa.) Question 2-B) Find the shear stress due to the torsional moment at point A. (Write your result in MPa.) Question 2-C) Find the normal stress caused by the normal force at point A. (Write your result in MPa.)

Q: A bent tube is attached to a wall with brackets as shown. A force of F = 480 lb is applied to the…

A: a) Calculate the position vector in the direction of the force. Calculate the unit vector in the…

Q: Determine the moment that is generated at point O by each force that appears in the bar of the…

A:

Q: In the figure, the forces F₁ = 40 N, F₂ = 100 N, and F3 = 87N, i- Determine the sum of the moments…

A: Given data: F1=40 NF2=100 NF3=87 N Need to determine the sum of all moments about the point A and…

Q: Find the magnitude and direction of the resultant force for the system of forces shown in the…

A: Given data: The magnitude of force F1, F1 = 10 N. The magnitude of force F2, F2 = 35 N. The…

Q: Example: Determine the resultant moment of the forces shown in (Figure 1) about point A? F₁ = 250 N…

A:

Q: A 7 m long steel shaft weighing 250 kg is supported at points A and B as shown in the figure. If the…

A:

Q: 500N Example: The resultant of the concurrent forces shown in figure is 300 N pointing up along the…

A: Solution: The above diagram shows the position of the given resultant with x -axis. From the above…

Q: Detemine the resultant force at A. for the figure below Hint : 1- Find the position of all points…

A:

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.