Question 2: At a time when rotation is perverted at the lower end of each shaft, an 80 N.m torque is applied to end A of shaft AB. Knowing that G=77.2 GPa for both shafts, Determine: r= 50 mm a) The maximum shearing stress in shaft CD b) Angle of rotation at A r= 75 mm Solution 15 mm 18 mm 240 mm

Q: If the allowable shear strength of aluminum is 45 MPa, determine the minimum thickness, t, of the…

A:

Q: A solid steel shaft will not twist through more than 3 degrees in a 6-m length when subjected to a…

A: Given data: The angle of twist, θ=3°. The length of shaft, L=6 m. The applied torque, T=12 kN·m.…

Q: Q.2) Three solid Brass (G = 44 GPa) shafts along with two sets of meshing gears are used to form…

A:

Q: A 2-m long hollow steel shaft (G = 75 GPa) has an outside diameter of 75 mm and an inside diameter…

A:

Q: Determine a.) the maximum torsional stress, τmax, and b.) the maximum angle of twist, φ, of the…

A:

Q: Determine the maximum torque that can be applied to the shaft, given that the maximum angle of twist…

A: Given,  A beam with two different cross sections. Length of the first portion = 2L diameter of the…

Q: Knowing thát the internal diameter of the HolUW SIlat shown is d= 23 mm, determine the maximum shear…

A:

Q: 600 N-m Given: A solid aluminum shaft with 900 N-m diameter of 50 mm is loaded by torques as shown.…

A:

Q: 4

A: Please see the attached image for the answer.Explanation:

Q: The solid shaft shown is formed of a brass for which the allowable shearing stress is 55 MPa.…

A: if you have any doubts please comment

Q: 3) The electric motor exerts a torque of 600 N.m on the steel shaft ABCD when it is rotating at a…

A: Given Data Modulus of rigidity is : G=77 GPa Length section of BC is : LBC=0.8 m Length section of…

Q: e of rotation of end A of the gear-and-shaft system? unit of Degree)

A:

Q: A motor applies 360 lb-ft of torque which is transferred through gears to shaft BD. At gear C the…

A: Hello. Since your question has multiple sub-parts, we will solve first three sub-parts for you. If…

Q: magnitude T 1000 N.m is applied ess is 60 MPa in each shaft, deter

A:

Q: 3.36 The torques shown are exerted on pulleys B. C, and D. Knowing that the entire shaft is made of…

A: To find the angle of twist

Q: b) The torques shown in Fig. Q1(b) are exerted on pulleys A, B, C and D. Knowing that each shaft is…

A:

Combined Loading

Any functioning component, such as machine parts, structural members, pressure vessels, and so on, are all under the influence of more than one force. When anybody is under the influence of more than one force such as shear forces, bending moments, axial forces, torsion, and so on, then such body is said to be under combined loading. A very practical example of combined loading is the crankshaft of an internal combustion engine (IC engine). The crankshaft of the IC engine is under high rpm, which is caused due to the torsional forces. Due to the presence of piston, counterbalances, and internal imbalances, the crankshaft experiences lateral forces and due to the rise in temperature, the crankshaft undergoes thermal expansion, which pulls the crankshaft along the axial direction and lateral direction. The presence of unbalanced loads along the periphery of the crankshaft also induces a bending moment.