Question 14 For C=0.012 µF, calculate the frequency (in unit of kHz using 2 decimal points) of the output voltage Vout H₁₁ R₁ www 22 ΚΩ R₂ 56 ΚΩ R₂ www 18 ΚΩ с -OV

Q: Consider the following circuit. Determine the magnitude of current IT in Ampere. Take frequency of…

A:

Q: I need help calculating these frequencies

A:

Q: A+ Β. Μ 409 20Ω Μ 30Ω 30Ω W 109 50Ω

A: The equivalent connection in delta has R1=20ohm, R2=10 ohm and R3=30 ohm First of all the equivalent…

Q: Consider the circuit below. Notice that the outputs of the first two flipflops are connected to the…

A:

Q: 1. 256 at -40 degrees in rectangular notation is O -196+j165 O -196 - j165 O 196 - j165 196 + j165

A:

Q: The Energy of the signal 10 e-stu(t) in the frequency band [0] Hz is

A: To find the energy of the signal in the frequency band Hz, we can use Parseval's theorem, which…

Q: loov C 18.8 PF R 2171-43~ 30.45H Find, IT, Ic, IR, IL

A: Given that: The circuit is shown below. Find: IT, IR, IL, and IC.

Q: 031811550 0 4211550 031811550 031811550 O81 pu 18115 Devredeki tüm elemanların kompleks 031811550…

A:

Q: Given the information provided in the figure below, determine ß, Vcc, RB. 20 μA RB Vcc •2.7 kΩ VCE =…

A: Note   When BE and CB junction of BJT is reverse biased= Cut off Region When BE forward and CB…

Q: Consider the following circuit. If the required frequency for oscillation is 10 kHz, then the value…

A: The given circuit is a triangular wave oscillator and the frequency of oscillation is based on the…

Q: on -10 -15 -20 20 15 10 5 1 2 3 I 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 t (ms)

A: The given waveform is shown below:  The average value of the waveform is determined from the area…

Q: The equation for the voltage signal below is e = Em Rotation 90° 180 270° 360° - Em

A: A periodic waveform is a wave that repeats itself after definite intervals of time. Such types of…

Q: Q1 (a) Based on electrical DC circuit as depicted in Figure Q1(a), (i) Determine the mesh currents…

A:

Q: I need help checking if the Vertical Deflection and Horizontal Deflection that I answer is correct.

A: Given wave form:Find the vertical deflection and horizantal deflection.

Q: Calculate 11, 12, and 13. The frequency is fixed at 500 Hz, and its output voltage magnitude to 5 V…

A: The circuit diagram,

Q: Plot the following points: Transmissibility Frequency (Hz) 0.03 2 0.09 9 0.6 11 1.5 100 20 200 1 700…

A: We have to plot the points in log paper chart . Log chart is a chart in which both the axis are in…

Q: Vee 27 10 •10.4 V 20A Ve z 100 12 ia

A: To determine various parameters in the given transistor circuit:

Q: 2) Calculate the total current (IT)? î o 14V 15 kHz C1 H 0.1μF C2 0.047μF R1 47052 R2 33052 C3…

A: It is given that:

Q: Determine the impedance of the circuit in Figure 3 at the given frequency. 10 kHz Rw 20 (2 ++ 4.7 ΚΩ…

A: laplace  transfer of capacitor, C→1cs laplace  transfer of  inductor, L→Ls So that Rw and L are in a…

Q: v=35 sin(5000t)?

A: Given: An equation of AC Wave is given as Vt=35 sin5000 t.

Q: MULTIPLY the following sets of complex numbers: 15 – j10  and -25 – j30

A: Given: MULTIPLY the following sets of complex numbers: 15 – j10  and -25 – j30

Q: 1. Consider the circuit below. Notice that the outputs of the first two flipflops are connecte to…

A: The initial state is 000. Given diagram:-

Antenna Characteristics

The antenna is an important concept in the domain of electronics and communication engineering. An antenna forms an integral part of many commonly used devices such as wireless modems, routers, game controllers, mobile phones, bluetooth devices, and so on. In simple terms, any wireless communication makes use of antennas to serve the purpose. An antenna, also known by the term 'arial', is an electrical device that converts electrical signals into electromagnetic waves or electromagnetic waves into electrical signals. An antenna contains a transmission line usually made up of co-axial cable, it then receives the signals and converts them into electromagnetic waves, which are then transmitted via space into their required destination. A communication system essentially makes use of two antennas, a transmission antenna, which converts electrical signals into electromagnetic waves, and a receiving antenna, which receives the electromagnetic waves and converts them back into electrical signals.