Ql:- The coplanar force system shown in Figure below is subjected to a couple moment (M)and three forces. Two forces are known in magnitude and direction and shown in the Figure(150 N and 60 N). The third force is passing through the center of the semi-circle (point C).The resultant of all these forces is a single couple (750 N.m) counterclockwise.a) Determine the magnitude and direction of the third force.b) Determine the magnitude of moment (M).c) Replace the couple (M) by two vertical equal forces acting at D and E.d) Replace the force (150 N) by and single force at D and a couple.Radius = 5 m150 NBO60 N-3.0m --

(a) for 300 N force, sinθ=4/5, cosθ=3/5 its component along OC=300cosθ=300*(3/5)=180 N component…

Answered: Ql:- The coplanar force system shown in…

Similar questions

A car of mass m is rounding a banked curve with radius R and banking angle 0. The curve is icy, so there is no friction between the tires and the surface. At what speed must the car take the turn in order for it not to slide up or down the incline? R Top View. Gravity is into the paper. √8 g Side View. The velocity is into the paper
The vertical and horizontal poles at the traffic-light assembly are erected first. Determine the additional force and moment reactions at the base O caused by the addition of the three 117-lb traffic signals B, C, and D. Report your answers as a force magnitude and a moment magnitude. 22 A 29' 22" B. 117 lb 117 Ib 117 Ib Answers: O = Ilb Mo = i Ib-ft
PRINTER VERSION 1 BACK NEXT Chapter 13, Problem 025 Your answer is partially correct. Try again. A solid sphere of uniform density has a mass of 8.7 x 104 kg and a radius of 1.2 m. What is the magnitude of the gravitational force due to the sphere on a particle of mass 6.5 kg located at a distance of (a) 4.2 m and (b) 0.34 m from the center of the sphere? (c) Write a general expression for the magnitude of the gravitational force on the particle at a distance rs 1.2 m from the center of the sphere. (a) Number 2.139E-6 Units (b) Number 2.36E-6 Units (c) |Fon m = k•r, where k = 2.184E-5 IN/m Click if you would like to Show Work for this question: Open Show Work
Braving the Rotor at the Amusement Park (Circular Motion Due to Normal Force) The Rotor is an amusement park ride where people stand against the inside of a spinning cylinder, as shown below. Once the cylinder is spinning at a certain speed, the floor drops out of the bottom of the cylinder but the people do not fall out of the bottom. A conservative low estimate of the coefficient of static friction between people's clothes and the cylinder wall is 0.45. The radius of the cylinder is 2.4 m. What is the minimum number of rpm that the cylinder can have so that the people do not fall out the bottom? (answer: 29 rpm)
VCM-1 Rommel drives his car straight ahead with a constant speed over a hilltop with circular curvature of radius R. a) Draw the free body diagram for Rommel's car when it is passing the highest point on the hill as shown to the right. b) Apply Fnet ma to Rommel's car for the radial and tangential directions. Use no numbers in these equations. c) Rommel's car has a mass of 1,800kg and is traveling at a constant speed of 15.0m/s. The radius of the hill is R-40.0M. Use your equations from part b) to find the normal force exerted on the car by the road when the car is at the top of the hill. V. R
Macmillan Learning The Atwood machine consists of two masses hanging from the ends of a rope that passes over a pulley. Approximate the pulley as a uniform disk with mass m₂ = 5.13 kg and radius rp=0.450 m. The hanging masses are m = 20.7 kg and mg = 12.7 kg. Calculate the magnitude of the masses' acceleration a and the tension in the left and right ends of the rope, 7₁, and TR. respectively. a= TL = TR = 2 m/s N m₁ 111
A disk of mass M, radius R, is rolling down an incline dragging a box mass M attached with alight rod to attached at the center of the disk. The friction coefficients are the same for both masses: . Draw free body diagrams for each object. Determine the liner acceleration of the box. Determine the friction force acting on the disc. Determine the tension in the rod.
d) At what rate does the cylinder spiñn 2 (8.51). In the amusement park ride shown here, the passengers are against the wall of a cylinder that rotates vertically. The diameter of the cylinder is 16 m. The cylinder rotates once every 4.5 sec. a) Draw a force diagram for a 55-kg passenger at the top of the ride. Show the weight and normal force vectors. b) What is the normal force? How many "g's" will the passenger feel? c) Draw a force diagram for a 55-kg passenger at the bottom of the ride. Show the weight and normal force vectors. ) What is the normal force? How many “g's" will the passenger feel? ation e the ride above is going at the minimum speed for passengers not to fall off. peed, what would the normal force be on a passenger at the top? What would th