Q9: What is the proper name of the torsional deformation in the following objects shaft gear shaft segment pulley coupling flange [Choose ] [Choose ] [Choose ] [Choose ] [Choose ] [Choose ]

Q: what would be the order of operations to make this part in the least amount of time and how would…

A: The order of operations to make this part in the least amount of time and how would you hold the…

Q: Define the term distributing force?

A: Distributing force:- Distributing Force is the force acting on the body over a length or surface.…

Q: How did you find out the angle was 90 and how can you find that for other problems?

A:

Q: What is load-displacement?

A: It is related to a ship or a cargo vessel.

Q: Name the 2 types of axial loading?

A: Two types of axial loading are tensile and compressive stress. Both kinds of stresses arise within…

Q: Describe the method of sections?

A: Method of section In this method we deal with the non-concurrent forces. Here, we get three…

Q: What makes new gear special?

A: Given data:- Gear:-A gear is a mechanical device that connects two rotating shafts by transmitting…

Q: the main diference between the prick punch and center punch?

A: Prick punch is a mechanical tool, which is made up of steel and it is used to mark points on the…

Q: Name, draw a neat sketch and explain why each of the following designs of rolling mill are used…

A: rolling mill are used instead of a basic two high rolling mill.i) A mill consisting of four…

Q: Explain revision B?

A: As you can see in below image, at highlighted location, in revision B, there is diameter with upper…

Q: Define the term Angle of Twist?

A: Whenever a twisting moment is applied on the shaft, the shaft's cross-section tends to rotate or…

Q: the various parts? 13. What is the tolerance on "F," the chamfer angle? 13 14. How square must the…

A: 13. 6 ° is the tolerance on "F" the chamfer angle As 20° - 14° = 6°    14. square must the ends of…