Q711. Put a circle around the correct ANSWERC/ Evapo-Transpiration is denoted by a) ET b)PT2/ Evapo-Transpiration means:a) Evaporation + Transpiration3 3/Dimensions of Evapo-Transpiration are:a) (m of water/day) b) (m of water/s) c) (m of water/year)Irrigation Cycle le can be calculated by the following formula:a) (dw)A/ET b) (dw)d/ET c) (dw)A/(dw)dUnits of Ic are:a) (day/Irrigation) b) (hr/Irrigation) c) (s/Irrigation)) Porosity of Porous Soil n can be calculated by:a) n= {1-(G/Gs)}x 100 b) n = {1- (Gs/G)} x 100 c) n = {(G/Gs) - 1}7) Moisture content of porous soil at its saturation condition (wv) s% can becalculated by the following formula:(wv) s%=n% b) (wv)s% = 0.5 n%c) (wv)s% = 2 n%8) Groundwater flow in Subsurface Tile Drain occurs :a) under effect of pressure b) under effect of gravity29) Cross-sectional area of Subsurface Tile Drain is:c) TEb) Transpiration c) Evaporationa) less than the cross-sectional area of secondary open drain.b) greater than the cross-sectional area of secondary open drain.c) equals to the cross-sectional area of secondary open drain.210) Drile means the depth of Tile Drain at:b) at its enda) it's beginningP-8c) at its middle

Note : Since, you have posted a question with multiple sub parts..... We will provide the solutions…

Q71 Put...circle around the correct ANSWER is denoted by a) ET b)PT /Evapo-Transpiration 2/ Evapo-Transpiration means: a) Evaporation + Transpiration 33/Dimensions of Evapo-Transpiration are: a) (m of water/day) b) (m of water/s) c) (m of water/year) c) TE b) Transpiration c) Evaporation

Q71 Put...circle around the correct ANSWER is denoted by a) ET b)PT /Evapo-Transpiration 2/ Evapo-Transpiration means: a) Evaporation + Transpiration 33/Dimensions of Evapo-Transpiration are: a) (m of water/day) b) (m of water/s) c) (m of water/year) c) TE b) Transpiration c) Evaporation

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

QI:- Design a settling tank for a flow of 0.2 MGD if the overflow rate is not to exceed 600 gpd/n. Calculate dimensions if the tank is circular with a depth of 12 ft. Calculate dimensions if the tank is rectangular with a depth of 10 fit and a length to width ratio of 4 to 1 Q2:- The settling velocity of alum floc is approximately 0.0014 f/s in water at 10 C. Calculate the cquivalent overflow rate in gpd/f12. What is the minimum detention time in hours to settle out alum floc in an ideal basin with a depth of 10 ft? Q3:- Two rectangular clarifiers, cach 30 ft long, 15 ft wide, settle 0.40 MGD following alum coagulation. The effluent channels have a total weir length of 60 ft. Calculate the detention time, horizontal velocity, rate of flow over the outlet weir. Do these values meet the GLUMRB Standards for water works? Q4:- Calculate the diameter and depth of a circular sedimentation basin for a design flow of 3800 m3/d based on an overflow rate of 0.00024 m's and a detention time of 3…
• Calculate the Hydraulic rate Vo, and BOD load of a single -stage trickling filter with the following data: Q= 30000m/d, t=3hrs, H=2m and BOD effluent 30mg/l, Recirculation around filter is =25%Q. efficiency of filter 80% . Assume
• Calculate the Hydraulic rate Vo, and BOD load of a single -stage trickling filter with the following data: Q= 30000m3/d, t=3hrs, H=2m and BOD effluent 30mg/l, Recirculation around filter is =25%Q. Assume efficiency of filter 80%.
The moisture condition of a catchment soil previous a storm is known. Its infiltration capacity fp can be expressed using the following Horton's equation f 0.5+ 1.2 e05t f,'s unit is cm/hr, t's unit is hour. Storm recording is shown in the chart below. Please calculate the actual infiltration rate when t=2 hours and when t-5 hours. Time (h) 0-1 1-3 3-4 4 - 6 Intensity 1.3 0.9 0.5 rainfall(cm/hr)
A factory is discharging its wastewater into a slowly moving stream that has a mean velocity of 3 cm/s. The flow rate of the stream is 4 times as that of the wastewater. The ultimate BOD of stream and wastewater are 5 mg/L and 105 mg/L, respectively. And DO of the stream and wastewater are 6 mg/L and 1 mg/L, respectively. The temperatures of the stream and wastewater are 15oC. The deoxygenation rate at 15oC is 0.48 day-1, and the re-aeration rate at 15oC is 0.72 day-1. Draw a DO sag curve to show your clients using Microsoft Excel. Please insert your DO sag curve into your project report (30 points); Based on your DO sag curve, find the location of and travel time to the critical point, and determine the minimum D A type of local fish requires the minimum DO in the river above 2 mg/L. Please evaluate whether the actual minimum DO is acceptable. If not, please qualitatively and quantitatively select appropriate management strategies to allow water quality to reach…
02: Find dimensions (b and h) of wash water channels for one filter, for the followin • Q (discharge of back wash for one filter) = 100 000 1/day. Two wash water channels are used for this filter. • Time of washing with water = 6 minutes. 3 Q2 Use( h = 1.73 b2.g
Solve the following: To determine the daily evaporation at lake, a USWB evaporation pan is maintained. The water level in the pan is 200mm at the beginning and is observed every day. Water is added if the water falls to about 17.5cm to the same depth during the first day. Estimate the daily pan evaporation for the 14-day period for which readings are summarized in the following table