Q7. The pressure is 1642 bar and 1 meter below the surface of awater-filled tank is: what is the density?h = 3 mg = 9.81 m/ s2°K = °C + 273°,/ P1 T2 = P2 T1,/ Q= (M) X (Cp) x (AT),/ P=p xh x g°C = oK – 273,/ °C 5/9 x (°F- 32),/ °F = 32° + 9/5°C,/ PE = m x g x h,/ Ek = ½ mv2

Answered: Image /qna-images/answer/4d17069b-8449-42e8-8903-05b2ea01325f.jpg

Answered: Q7. The pressure is 1642 bar and 1…

Science

Physics

Q7. The pressure is 1642 bar and 1 meter below the surface of a water-filled tank is: what is the density?

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Related questions

Q: A diving bell is to be designed to withstand the pressure of sea water at a depth of 900 m. The…

A: a) Determine the total pressure at the depth.

Q: Tank 1 has a fluid of density ρ filling it to a height h and is located on a planet with gravity g.…

A: We know that the formula of the gauge pressure at the bottom of the tank is given as Gauge…

Q: Liquid of density 945 kg/m is flowing through a pipe as shown in the diagram below. At point A, the…

A: Answer B) -1.36 X 10^6 Pa

Q: A plastic sphere floats in water with 60.0% of its volume submerged. This same sphere floats in…

Q: 800 Pa

A: A. To determine the volume flow rate in the given pipe, we can use the principle of conservation of…

Q: An ebony log with volume 12 ft3 is submerged in water. ( the weight density of ebony is 75lb/ft^3)…

A: Booyant force would be upwards and gravity would be downwards.

Q: tank 14.0m deep is filled with water. The top of the tank is open to the air. What is the absolute…

Q: A pipe of radius 0.9 m, has a volume flow rate of 19. What is the velocity of the fluid in the pipe?

Q: Water flows up a 10 m hill through a pipe. At the bottom of the hill, the pipe has a cross-sectional…

Q: A steel block with a mass density of 7800 kg/m3 is suspended from a string in a beaker of water so…

Q: 04m2. A small hole is the free surface of the 00 of the surface area of s out of the hole. Assume

A: Given: To determine the volume of the fluid which flows out of cup per second as,

Q: What is the final speed of the fluid in a pipe with an initial diameter is 10 cm and the final…

A: Given, The initial speed V1 = 3 m/s Final speed V2 =? initial diameter is d1 = 10 cm final diameter…

Q: A. What is the mass (in grams) of 3 cm³ of a liquid with specific gravity of 0.60? B. Two hundred…

Q: A.) What volume of a helium- filled balloon is needed to just lift a total pay load of 1500 kg? B.)…

Q: In the Figure below, what is the pressure at point A? Open Air y Elev=2m Elev =lm Oil 1.5 m (S=0.85)…

A: (d) No of mentioned

Q: At a depth of 2500 m in an ocean. what is the absolute pressure?

Q: A helium balloon with volume 2.25 L. a) Calculate the magnitude of the buoyant force on the…

Q: A storage tank 20.0 m deep is filled with water. The top of the tank is open to the air. a. What is…

Q: A plastic sphere of density 700 kg/m³ and radius of 20.0 cm floats on the surface of a freshwater…

Q: Q5. A uniform pressure of 5 X 10° Pa is exerted on a Cu block having a volume of 10³ m³. What is the…

A: The value of uniform pressure, P=5×104 Pa The initial volume of the Cu block, V=10-3m3 We have the…

Q: Pressure in the spinal fluid is measured as shown in the figure, by connecting a small tube between…

A: The objective of this question is to convert the pressure in the spinal fluid from mm Hg to cm of…

Q: Three liquids that don't mix (much like oil and water don't mix) are poured into a cylindrical…

A: Given that Given that one liter =1000cm3 The acceleration due to gravity is (g) =9.81m/s2 Three…

Q: In this experiment, you are going to measure the buoyant force on an aluminum block partially…

A: The part of the cuboidal block immersed in water has the length, breadth, and height l, w, and dim,…

Q: a. The barometer is a device to measure atmospheric pressure. If you plan to make a barometer by…

A: (a) A barometer is a scientific instrument used to measure atmospheric pressure. It consists of a…

Q: A rock with a mass of 580 g in air is found to have an apparent mass of 365 g when submerged in…

Q: 1. When a block of an unknown material is placed in a fluid with a density of 1253- kg it was…

A: Given: ρf=1253kg/m3 (a) Let the density and volume of the block of unknown material be ρ and V…

Q: A horizontal pipeline enlarges from a diameter of 6 in. at point A to a diameter of 12 in. at p B.…

A: Given that;At A:Diameter of pipe = 6 in.Water flow rate vA = 20 cu.ft per sec, 34560 cu. in. per…

Q: A solid block is attached to a spring scale. When the block is suspended in air, the scale reads…

A: Given that weight of the block in a air and weight of the block, when it is completely immersed in…

Q: Consider the sealed containers (same fluid and on the same ground level) below with heights given in…

A: Given that, the same amount of liquid is poured into different containers which have different base…

Q: Water is moving at a speed of 2.2 m/s through a hose with an internal diameter of 1.55 cm. a.…

Q: You can chew through very tough objects with your incisors because they exert a large force on the…

A: The objective of this question is to calculate the pressure exerted by a tooth when a force is…

Q: A hose has a radius r=3 cm is filling a storage dam that can accommodate a volume V=919 liters. The…

A: V=Volume of water=919 LA=Area=πr2r=Radius of hose=3 cmt=Time taken=7 minutesv=Velocity of…

Q: A 100 mL beaker holds 120 g of liquid. What is the liquid’s density in SI units?

Q: 9. A fountain shoots water 8 m straight up. a. What is the pressure at the point where the water…

A: Given : Height of the fountain, h = 8m Determine : a) the pressure at the point where…

Q: Water flows through a horizontal pipe with a cross- sectional area of 4 m2 at a speed of 5 m/s with…

A: Here given the horizontal zontal pipe at initial cross section is 4 m² where speed is 5m/s and…

Q: You can chew through very tough objects with your incisors because they exert a large force on the…

A: The objective of this question is to calculate the pressure exerted by a tooth when a force is…

Q: The depth of water behind the Hoover dam is 393 m. The density of water is 1,000 kg/m³. What is the…

A: Given Depth h = 393 m Density = d = 1000 kg/m3 Acceleration due to gravity g = 9.8 m/s2

Q: 1. When a block of an unknown material is placed in a fluid with a density of 1253 it was observed…

Q: A piece of copper has a mass of 2.6 kg. a. What is the volume of this piece of copper? b. The copper…

Q: D1 = 0.80 in D2 = 0,04 in A syringe in the figure contains fluid of s.g. 1.05. If the plunger is…

A: Disclaimer: “Since you have asked multiple question, we will solve the first question for you. If…

Q: A tank 14.0 m deep is filled with water. The top of tank is open to the air. What is the absolute…

Concept explainers

Density of Solids

The density of a substance refers to how much matter is present in a given amount of space. It is expressed as the ratio of the mass of the substance to its volume.

Question

Q7. The pressure is 1642 bar and 1 meter below the surface of a
water-filled tank is: what is the density?
h = 3 m
g = 9.81 m/ s2
°K = °C + 273°,/ P1 T2 = P2 T1,/ Q= (M) X (Cp) x (AT),/ P
=p xh x g
°C = oK – 273,/ °C 5/9 x (°F- 32),/ °F = 32° + 9/5
°C,/ PE = m x g x h,/ Ek = ½ mv2

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

5. You are designing a diving bell to withstand the pressure of seawater at a depth of 250 m. a. What is the gauge pressure at that depth? b. What is the net force due to the water outside and the air inside the bell on a circular glass window 30.0 cm in diameter if there is 1.00 atm of pressure inside the bell.
An airplane is pressurized with air to 650 mmHg. a. If air is 21% oxygen, what is the partial pressure of oxygen on the plane? b. If the partial pressure of oxygen drops below 100 mmHg, passengers become drowsy. If this happens, oxygen masks are released. What is the total cabin pressure at which oxygen masks are dropped?
An open-top tank has an opening at point 2, 2.56 cm in diameter, and is 5 below the tank's water level. What is the volume of water that will escape through the opening per minute? Round your answer to 2 decimal places.
Bird bones have air pockets in them to reduce their weight—this also gives them an average density significantly less than that of the bones of other animals. Suppose an ornithologist weighs a bird bone in air and in water and finds its mass is 45.0 g and its apparent mass when submerged is 3.60 g (the bone is water light) a. What mass of water is displaced? b. What is the volume of the bone? c. What is its average density?
A piece of copper has a mass of 2.6 kg. a.What is the volume of this piece of copper? b.The copper is then totally submerged in water. What is the buoyant force acting on it? c. What is the piece of copper’s apparent weight in the water?
Water is pumped through a vertical 5.0 cm cement-lined steel pipe to an elevated tank on the roof of a building. The measured pressure at the discahrge side of the pump is 1380 kPa. What pressure can be expected at a point in the pipe 76 m above the pump when the flow is 9.5 L/s? Use f= 0.023 Include your free body diagram. a.100 kPa b.225 kPa c.150 kPa d.75 kPA
1.
Suppose the aqueous humor in a person’s eye exerts a force of 0.315 N on the 1.05-cm2 area of the cornea. a. What is the pressure, in mm Hg, on the cornea?
A 57kg object with a volume of 0.04m3 is dropped into a fresh water lake, which has a density of 1000kg/m3. a. What is the object's force of gravity? b. What is the buoyant force on the object? c. Based on your answers from a) and b), will it float or sink?
A raft has dimensions 7.0 m x 7.0 m with a thickness of 1.0 m and made of material with average density 650 kg/m3. a. When floating in water, what percentage of the volume is under water? b. What is the pressure underneath the raft? c. How heavy of a load is necessary to cause the raft to be 80% submerged in water? d. If the raft is made with a different material of lower density and 80% of it is still submerged, how if at all would your answers to (a), (b) and (c) change? e. , explain how, if at all, the answer to (b) is related to the buoyant force. f. Imagine that the load increases enough to fully submerge and then sinks the raft to the bottom of the lake. How, if at all, does the buoyant force vary during this process?
A Moving to another question will save this response. Quèstion 1 An open-tube manometer is used to measure the pressure in an oxygen tank. when the atmospherric pressure is 1,025 mbar. What is the absolute pressure (in Pa) in the tank if the height of the mercury in the open tube is 4.1 cm lower. (1bar = 1 x 105Pa Density of mercury is 13.6 x 10³kg/m3.) A Moving to another question will save this response.
The same fluid (density unknown) fills three depressions on an alien planet. Depression #1 is a small pond. Depression #2 is a large lake. Depression #3 is a very large ocean. All of these depressions have the same depth. Gravity g is the same at all three locations. However the value of gravity is unknown. How do the gauge pressures at the bottoms of the three depressions compare? A. P3 > P2 > P1 B. They are the same C. P1 > P2 > P3 D. Can't tell without knowing the dimensions of the depressions.