Q6: Two mutually coupled coils, A and B, are connected in series to a 360 V d.c. supply. Coil A has a resistance 6 52 and an inductance 4 H. Coil B has a resistance 112 and inductance 9 H. At a certain instant after the circuit is energized. The current is 10 A increasing at the rate 10 A/sec. calculate: (a) The mutual inductance between the coils. (b) The coefficient of coupling.

Q6: Two mutually coupled coils, A and B, are connected in series to a 360 V d.c. supply. Coil A has a resistance 6 52 and an inductance 4 H. Coil B has a resistance 112 and inductance 9 H. At a certain instant after the circuit is energized. The current is 10 A increasing at the rate 10 A/sec. calculate: (a) The mutual inductance between the coils. (b) The coefficient of coupling.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

3. A resistor and a capacitor are connected in parallel across a 120 V DC source. Determine the voltages across the resistor and the capacitor.
Which of the following is true about all series ac circuits?(a) The voltage across any circuit element is a maximumwhen the current is a maximum in that circuit element.(b) The current at any point in the circuit is always thesame as the current at any other point in the circuit.(c) The current in the circuit is a maximum when thesource ac voltage is a maximum.(d) Resistors, capacitors, and inductors can all change thephase of the current.
A 750-ohm resistor, an uncharged 1.50 uF capacitor, and a 8.00-V emf are connected in series. (a) What is the current after one time constant? (b) What is the voltage on the capacitor after one time constant?
C) A 25 A electrodynamic ammeter is controlled by a spring having a constant of 5.7295x 10-6 Nm/rad. The full scale deflection is 110°. Determine the inductance of the instrument while measuring a current of 20 A. The mutual inductance at 0° deflection is 4 u H and the change in mutual inductance is linear with the deflection.
14: Which of the following circuit elements will oppose the change in circuit current? A)Capacitance, B) Inductance, C) Resistance, D) All of the above. 15: If the current in one coil is steady, what happens to the mutual inductance? C) Doubles, D) Halves. 16. If the flux linkage in coil l is 3Wb and it has S00 turns and the current in coil 2 is 2A. A) Zero, B) Infinity. calculate the mutual inductance. A) 750H, B) SOOH, C) 450H, D) 900H. 17: As Faraday's laws of electromagnetic induction, an em.f. is induced in a conductor whenever it. (A) Lies perpendicular to the magnetic flux, (B) Lies in a magnetic field. (C) Cuts magnetic flux, 18: Calculate the emf when the flux is given by 3sin t + Scos t A) 3cos t - Ssin t. B) -3cos t + 5sint. C)-3sin t - Scos t, D) 3cos t + Ssin t. D) Moves parallei to the direction of the magnetic field.
AC Circuits Sine-wave generator f- 25 kHz V₁ = 3.0 V VR 888 100 mH Figure 6-Test Circuit 3. Using a two-channel oscilloscope, measure the peak-to-peak voltage VR across the resistor and the peak-to-peak voltage VL across the inductor. Measure the voltage across the inductor using the difference technique described in a previous experiment. Record the voltage readings in Table 2. VL 10 k 1 XL Table 2- Measured and Calculated Values (f = 25 kHz) ZT
Determine the equivalent inductance of the inductive network with coupled coils shown in Figure. 2H le 3H 6 H 3H 4 H 5H
A utility company plans to connected a total of 20uF of capacitance to a 7,200 volt line. To make this connection, four capacitors will be connected in series. What is the capacitance of each capacitor?
An inductor and a 470 ohm resistor are connected in series with a function generator. The current is 53.7mA RMS 8kHz. The reactive power is 2.32 var. Find the value of the inductance.
An inductor is connected to a 240-V, 1000-Hz line. The circuit current is 0.6 A. What is the inductance of the inductor?
For the series-parallel inductor circuit shown in figure B19, answer the following questions. 2mH 4mH SmH 3.5mH 8mH 8mH n2mH Figure B19 Determine the inductance, L value. If E is the energy stored in inductor for current, I. Calculate the energy if the current value is increased twice.
i. The equivalent inductance between A and B of the circuit shown in figure B2 is 4.67mH. Find the value of unknown inductor, L. L1 L4 2mH 1.5mH L3 7mH L5 14mH A LT -4.67MH B Figure B2 ii. Consider a coil with inductance, L'. Number of turns, 'N' and length of the coil, l". If the length of the coil is halved and number of turns is doubled, what will be the new value of inductance?