Q6) If R= 2i -4j +k and F = 3i+j-5k and t = R × F , find the following 1- The value of R × F , 2- the value of ORF. . ( R× F )= 27 , 0rF. = 84° ) %3D

Q: Let Zeq be the equivalent impedance of a parallel connection of an inductor with inductance L and a…

A:

Q: Determine Voltage Vout and the Current on the 0.01micro farad capacitance. * c, -0.01 uF R, -1 ka V-…

A:

Q: Find the charge q(t) on the capacitor and the current i(t) in the given LRC-series circuit. 1 L = h,…

A: The value of the inductor, The resistor, The cpacitor,The voltage, The initial

Q: (b) Given the signal x(t) in Figure 3, sketch the signal for x(-2t-2): 2.5. 1.5 05 -0.5- 0.5 1.5 2.5…

A: To sketch any signal : First step is shifting  Second step is scaling  Third step is reversal and…

Q: 5) Write the mesh current equations for the circuit shown below. 10 2 ww- 6 V ww 12 42 A8

A:

Q: Find the effective noise temperture and noise figure where Tx is the physical temperture 10 dB atten…

A:

Q: The rectangular form of the complex number 56/35° 7.5-j10 + j2 is +j

A:

Q: Find the following convolutions: (a) sinc(t)*sinc(t) (b) sinc (t)*sinc(t) (c) sinc(t)*esinc(t)

A: According to the question we have to calculate the convolution of given terms.

Q: 66.A capacitor is connected to a 108V supply. If the capacitor is being charged to 0.54W-s. What is…

A: Note: According to the guidelines of the company if the questions are of different then we supposed…

Q: The subplot function in MATLAB/OCTAVE is used to O put a title for the plot. O put label…

A: As per Bartleby guidelines we are allowed to solve only one question, please ask the rest again.

Q: The waveforms in the figure below are applied to a comparator. (This might typically be used in an…

A:

Q: I hope you can clarify how to draw a small triangle accurately.

A: Step 1:The transconductance (gm) of a JFET can be calculated using the following formula: gm = 2…

Q: product of (7(cos70+jsin70))(6(cos150+jsin150)) in polar form

A: Given: x=(7(cos70+jsin70)) ×(6(cos150+jsin150))

Q: he tuner knob on an FM radio moves the plates of an adjustable capacitor that is in series with a…

A: Given Data: Inductor L = 0.3 microH Resistance R = 1000 ohm Capacitance C = 5.50 pF Operating…

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.