Q4.1 A 3-ph, 60 Hz, 500 kV TL is 300 km long. The line inductance is 0.97 mH/km and its capacitance is 0.0115 µF/km per phase. Assume a lossless line. (or assume characteristic impedance = 290.430 and Bl = 21.641°)| (a) Calculate the RE voltage when line is terminated in an open circuit and is energized with 500 kV at the SE. (b) Determine the reactance and the Mvar of 3- phase shunt reactor to be installed at the RE to keep the no-load RE voltage at the rated value.

Q4.1 A 3-ph, 60 Hz, 500 kV TL is 300 km long. The line inductance is 0.97 mH/km and its capacitance is 0.0115 µF/km per phase. Assume a lossless line. (or assume characteristic impedance = 290.430 and Bl = 21.641°)| (a) Calculate the RE voltage when line is terminated in an open circuit and is energized with 500 kV at the SE. (b) Determine the reactance and the Mvar of 3- phase shunt reactor to be installed at the RE to keep the no-load RE voltage at the rated value.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

The 50 ohm transmission line isterminated with an unknown load. The magnitude of the reflection coefficient is R=0.5.Thedistancebetween the voltage maximum and the load is0.15 lambda. What is the imaginary partof the load impedance?
Reconsider problern 4.28 with still another alternate phase placement given below. Physical Position 1 1' 2' 3' Phase Placement C A find the inductance reactance of the line in ?/mi/phase. Reference of problern 4.28 For the case of double-circuit, bundle-conductor lines, the sarme method indicated in Problem 4.27 applies with r'replaced by the bundle's GMR inthe calculation of the overall GMR. Now consider a double-circuit configuration shown in Figure 4.36 that belongs to a 500-kv, three-phase line with bundle conductors of three subconductors at 21 in. spacing. The GMR of each subconductor is givento be 0.0485 ft. Determine the inductive reactance of the line in ohms per mile per phase. You may use GMD X 0.2794 log 0/mi/phase GMR FIGURE 4.36 32 Configuration for Problem 4.28 1, A 3, C' 36" 2, B 3, C 1; A' 2, B' -32- -32 Reference of problem 4.27
Please help
5. A transmission line whose characteristic impedance is a pure resistance (a) Must be a lossless line (c) May not be a lossless line (b) Must be a distortion less line (d) May not be a distortion less line 6. When a transmission line has a load impedance same as that of the characteristic impedance, the line is said to be a) Parallel b) Perpendicular c) Polarized d) Matched 7. The leakage current in the transmission lines is referred to as the a) Resistance b) Radiation c) Conductance d) Polarization 8. Inverse Fourier Transform of u (w) is (a)1/2 8(t) + 1/at (b) 1/2 8(t) (c) 28(t) + 1/nt (d) 8(t) + sin(t) 9. The Fourier Transform of a real valued time signal has a) Odd symmetry b) Even symmetry c) Conjugate symmetry d) Real 10.For the given periodic function: f(t) = {2t for 0≤t≤2 for 2 ≤t≤ 6.T = 6) The coefficient b₂ is: a)-75.68 b)-7.568 c)-6.8968 d)-0.7468
A 3-phase transmission line using 20 mm diameter conductor. When these conductors are placed at the corners of an equilateral of each side 2.5 m, the inductance of the line per kilometer is O 0.97 H/km 1.15 H/km O 0.97 mH/km O 1.15 mH/km
b) A 6052 characteristic impedance transmission line is fed by a DC source of 100V with an internal resistance of 4002. The line is 200m long and has a dielectric constant of 2.25. The load impedance is 12002. Calculate: i. The load reflection coefficient. ii. The source reflection coefficient. iii. What is the voltage at the source terminals just before AND just after 2us?
"In medium transmission line modeling, which of the parameter is considered to be lumped?" Resistance Inductance Capacitance All options are correct
43
A lossless transmission line has a capacitance per unit length of 64pF/m and an inductance per unit length of 1µH/m. The load impedance ZL is purely resistive. Both the load impedance and the generator impedance are 50 Ohms. the characteristic impedance and the propagation velocity
A 470 kV, three phase transmission line with a 350 km length. The series impedance Z = (0.078+j0.34) 0/ph/km and shunt admittance y = (j2.8 x e(-6)) S/ph/km. Evaluate the equivalent Tt-model and T-model parameters.