Q4: From the collector characteristic curves and the dc load line when ßDc is 100 and alpha= 0.95 , in the figure below, determine the following:Ic (mA)60-600 μΑ500 µA50-400 µA40-30-300 µAQ-point20-200 µA10-100 μΑVCE (V)12346.7 8 9 10a) Collector saturation currentb) VCE at cutoffc) Q-point values of IB, IC, VCE, and IE.d) What is the operation mode of the transistor.

We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q4: From the collector characteristic curves and the dc load line when ßDC is 100 and alpha = 0.95 , in the figure below, determine the following: Ic (mA) 60- 600 μΑ 50- 500 µA 40- 400 μΑ 30- 300 μΑ Q-point 20- 200 μΑ 100 μΑ 10- VCE (V) 1 2 3 4 5 6 7 8 9 10 a) Collector saturation current b) VCE at cutoff c) Q-point values of IB, IC, VCE, and IE.

Q4: From the collector characteristic curves and the dc load line when ßDC is 100 and alpha = 0.95 , in the figure below, determine the following: Ic (mA) 60- 600 μΑ 50- 500 µA 40- 400 μΑ 30- 300 μΑ Q-point 20- 200 μΑ 100 μΑ 10- VCE (V) 1 2 3 4 5 6 7 8 9 10 a) Collector saturation current b) VCE at cutoff c) Q-point values of IB, IC, VCE, and IE.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

VZENER at D1 is 9.3V with an IZENER of 4mA when active. D2 is a silicon diode and the transistor has a β = ∞ and VBE = 0.7V.What is VA? What is VOUT? What is the power dissipated by the diode D1?
1- a. For the circuits given below calculate the currents through the zener diode (V5.1V) and the current through the Si-diode. 1k Ohm 1k Ohm -10V 1k Ohm 12V b. The emitter of an NPN type BJT is connected to ground. Its base is connected to a 5V supply with a 10K resistor. Its collector is connected to the same supply with a 6K resistor. Calculate the range of ß such that the transistor is not saturated.
Draw the n-p-n silicon bipolar junction transistor at zero bias and also in forward active mode with an aid of the energy band diagram. Please ensure to draw with careful detail, reflecting the doping density in each region.
An intrinsic semiconductor is neither a good conductor nor a good insulator. Select one: O True O False A varactor is a pn junction diode that always operates in reverse-bias and is doped to maximize the inherent capacitance of the depletion region. Select one: O True O False A simple diode rectifier has 'ripples' in the output wave which makes it unsuitable as a DC source. To overcor this on e can use
3. Circuit in Figure B.3 is designed to provide a DC voltage of 20 V to a load resistance, RL. The input voltage, Vi, varies from 30 in Table B.1, select one zener diode that is suitable for the above circuit operation. Show relevant calculation to justify your selection. UTM OV to 50 V. Based on the parameters given UTM Rs 0.75 k2 UTM & UTM UTM & UTM UTM UTM V, SUTM & UTM TM 2.5 k2 UTM UTM UTM Table B.1 Zener Diode Vz (V) UTM &UTM & UTM PDMAX (W) ZA UTM UTM ZB 0.5 5 ZC 1 15 ZD 0.5 15 JUTM UTM 5 UTM ZE 20 UTM UTM ZF 0.5 1 UTM UTM20 & UTM & UTM & UTM UTM UTM TM UTM TTM UTM
3phase half wave rectifier ,the line voltage(460v).load resistance(R-202).find Vdc, Vrms, PIV, RF, FF. Ans:
3. Circuit in Figure B.3 is designed to provide a DC voltage of 20 V to a load resistance, RL. UTM Show relevant calculation to justify your selection. The input voltage, Vi, varies from 30 V to 50 V. Based on the parameters given in Table B.1, select one zener diode that is suitable for the above circuit operation. 5 UTM Rs 0.75 k2 UTM & UTM UTM & UTM UTM 3 UTM TM Vi 2.5 ko 5 UTM 5 UTM VL UTM UTM UTM UTM UTM Pigure B 3 Table B.1 Vz (V) UTM UTM 3 UTM PDMAX (W) Zener Diode ZA UTM & UTM ZB 0.5 5 1 15 ZD 0.5 15 UTM UTM 5 UTM ZE 20 UTM UTM ZF 0.5 1 5 UTM UTM 20 5 UTM & UTM & UTM
In a Bread Board, the rows are shorted or the columns are shorted? The BJT is operated in The Zener diode may have a breakdown voltage from about mode. Transistor has doped regions. Which one is the full form of DMM? In forward region Zener diode Clipper Circuits When the diode is connected across a voltage source with positive polarity of source connected to P side of diode and negative polarity to N side, then the diode is in A rectifier converts an In Full-wave bridge rectifier how many diodes are needed? condition. signal into a signal.
2. sketch io and Vot for the notwork below for the input shown (Bßoth diodes are Si, Vo= 0,7v), 20V Vo! Vi -20 V 5.3U 7.3V
3. If the Zener diode in the circuit below has a FBV of 1V, plot the transfer function (Vout vs. Vin) for -20V
For the circuit given in figure below draw the collector characteristic curves for Ip= 50, 150 and 250 micro amperes on the same graph Re 220 A - Vec 10 V R 10 k Boc= 200 OV-5 V
In a common base configuration, collector current is 1.95 milliamperes and base current is 0.05 milliamperes. Find the value of alpha dc (adc)? Answer: