Q4/ Draw the mohr's stress circle or the element of the beam as shown in Fig. 4, and determine the principal stresses, the principal planes (p), and the maximum shear stress. Also, find o, o, and try on element obtained by rotating the given element counterclockwise through 30°. Fig. 4 a=60 MPa T=48 MPa 0,-100 MPa

Q4/ Draw the mohr's stress circle or the element of the beam as shown in Fig. 4, and determine the principal stresses, the principal planes (p), and the maximum shear stress. Also, find o, o, and try on element obtained by rotating the given element counterclockwise through 30°. Fig. 4 a=60 MPa T=48 MPa 0,-100 MPa

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

From the stress states given, draw the 3D Mohr's circle (lable the principle normal stresses, maximum and absolute shear stresses), and sketch the principle and shear planes. σxx = 70 ksi, σzz = -50 ksi, ?xy = 50 ksi (counterclockwise)
There are forces acting in the Z and Y directions 1000N and 1500N please post your own correct answer everyone keeps copy and pasting an incorrect answer that neglects the stress acting in the y axis
2. A circular bracket with a diameter of 100 mm is fixed to a wall as shown in the figure. Determine and draw the state of stresses in small infinitesimal cubic elements located at points M and N on the cross section A. M 0.25 m 50 kNA 0.75 m 100 kN
A prismatic bar is subjected to an axial forcethat produces a tensile stress σθ = 65 u MPa and ashear stress τθ = 23 u MPa on a certain inclined plane(see figure). Determine the stresses acting on all facesof a stress element oriented at θ = 30°, and show thestresses on a sketch of the element.
Considering the original state of stress as shown in figure below and recalling the already developed equations for normal and shear stress at an angle Ɵ c.c.w from x-axis, mathematically prove that the planes of maximum in-plane shear stress are inclined at 45o to the principal planes.
3: T = 10.11 kN-m
For the beam shown in the figure: Determine the normal and shear stress at a point located at 4.5 ft from support B and 4 inches from the top of the section. Draw the Mohr's circle for the stresses at that point and calculate the principal stresses and the max in plane shear stress as well as their directions. Show these stresses on appropriately oriented elements. A 1600 lb 1.5 ft 80 lb/ft -9 ft B 1.5 in. 4 in 11.5 in.
PROBLEM 3. The stress condition at one point in the tail region of the National Combat Aircraft is shown in the figure. (a) Calculate the principal stresses (b) Calculate the maximum in-plane shear stress and the average normal stress by analytical method and plotting the Mohr's circle. For each case, determine the element orientation and plot the stress state. (c) Calculate the maximum absolute shear stress at the same point. 40 MPa TAI 200 MPa 80 MPa