Q3:A) List the devises that used to measure the velocity, pressure, volume flow rate and sketch each of them with equations. Q3:B) A rectangular gate (length 3m, wide 1m) inclined at 50⁰ with the horizontal level and hinged at point to the bottom of the tank. The weight of the gate is 9000N; calculate the minimum height of the water (h) in the left side of the gate, which cause to open the gate automatically? WATER 1.2m. 3m 50 WATER

Q: Water with density 1000 kg/m3 flow in a 4-in ID pipe at 1,2 m/s, witch connect to a Venturi meter to…

A: Density of water = 1000Inner diameter of pipe = 4 in.Water velocity at the inlet of pipe = 1.2…

Q: Q2 // The diameter of a pipe at section 1 and 2 are 10 cm and 15 cm respectively. Given velocity of…

A: Given that, The diameter of the pipe at section 1 D1 = 10 cm = 0.1 m The diameter of the pipe at…

Q: For a flow over a flat plate the normalized velocity profile is --² where y is in mm 2 U a)…

A: Answer: a) we know that, Displacement Thickness = δ* = ∫0δ (1- uU) dy  Displacement Thickness = δ* =…

Q: 1-Water with kinetic viscosity v-0.494 mm2/s flow through a pipe with diameter 18mm with velocity…

A: Kinetic viscosity = 0.494 mm2 /sdiameter = 18 mm V= 0.1 m/sf  = 0.03 mm

Q: Q3) Water flows through a 10-mm diameter pipe at a flow rate of 1.33×104 m³/s. Find (a) Velocity (V)…

A: As water is flowing through the pipe with a flow rate of Q. Reynold's number is the dimensionless…

Q: Water is flowing through a 30-m-long and 5-cm-diameter horizontal pipe at a rate of 9 L/s. Using…

A:

Q: For the water flow at 20 °C, use the manometer measurement to estimate the (a) centerline velocity…

A:

Q: Determine diameter of galvanized pipe needed to make the water flow along 180m with flow rate 85L/s…

A: Given data: Length of pipe = 180 m Volumetric flow rate = 85 L/s Head loss = 9 m Kinematic viscosity…

Q: An oil (S = 0.85, v = 1.8×105 m²/s) flows through 0.1m diameter pipe at 2m³/sec, 150m long. Find the…

A:

Q: Q: An open cylindrical vessel of (20 cm) diameter and (100 cm) long contains water up to a height of…

A: Given diameter of open cylindrical vessel of =20 cm length of open cylindrical vessel of =100 cm…

Q: The velocity profile of a fluid in a horizontal circular pipe having a radius R is found as; Vz =0.4…

A: Given data: Velocity profile for a fluid in a circular horizontal pipe is given by the following…

Q: Q3: The flowrate of a fluid in a pipe is measured using a pitot tube which gives a pressure…

A: Perform force balances for streamline flow in pipe:

Q: a cubic reservoir has side of 10 meters. if it is initially half full with water by height,…

A: Given, Side=10 m Height of water, h=5 m

Q: A nozzle is bolted onto a pipe by the flanged joint as shown in the Agure. The flowing fluid is…

A:

Q: 8. Oil flows in the pipe shown in figure. The orifice in the pipe has a coefficient of discharge of…

A: The orifice meter is a flow measuring device. The difference in pressure gives the flow rate of the…

Q: 4. Water flows through a smooth horizontal 2 m long tube of 2 mm diameter with an average velocity…

A:

Q: Ex1: The 3-m wide barge shown in figure weight 20 kN while it empty. It is proposed that it carry a…

A:

Q: Unit for mass flow rate and molar flow rate

A: The mass flow rate is defined as the differential mass of the fluid flowing per unit of time. The…

Q: 1. A flow rate of 16 m/(m² h) is maintained through a 0.6-m-deep bed of filter sand. The sand is…

A: Given: Velocity in bed V = 16 (m3/m2.h) = 16 m/h = 163600m/s = 0.0044 m/s diameter d = 0.4 mm =…

Q: 10 ft 10 ft Very large Water 3-in steel pipe FIGURE 6.25 Tank draining by gravity, with pipe and…

A: Water is flowing from the bottom of a tank via 3 in steel pipe. Volumetric flow rate is to be…

Q: Calculate the kinetic energy changes

A:

Q: A straight pipe with an expansion in pipe from 6 to 11 cm transports water at a rate of 0.011 m /s.…

A:

Q: Shear stress of the fluid will be maximum at the a. Wall of the pipe O b. In between center and wall…

A: 1) Answer: a. wall of the pipe Shear stress of the fluid is maximum at the wall because at the wall…

Q: Q2: Determine the pressure drop across a pipeline carries 2.5 kg/s of crude oil to a storage tank…

A: Given: mass flow rate of crude oil m = 2.5 kg/s Tank diameter d = 80 mm = 0.08 m L = 100 m mean…

Q: In the Figure.Q3, The energy decline of the connections and the pipe before the pump is 3m.…

A:

Q: calculate the largest discharge for which the flow will be definitely laminar Water flows in a 2 cm…

A: This question is based on fluid mechanics. The flow in consideration is Laminar flow. Data given :…

Q: Sulphuric acid is flowing through a pipe (2.5 inch diameter, 50 ft length) in a velocity of 0.006 m3…

A: Given: diameter D = 2.5 inch = 0.0635 m, A = pi.D2/4 = 0.003165 m2 Thus, V = Q/A = 0.006/0.003165  =…

Q: As shown in the figure, the manometer reading is 15 cm of mercury when the tank is empty (water…

A:

Q: 9. The fixed parallel plates kept at 80 mm apart have laminar flow of oil between them with a…

A: Since you have posted a question with multiple sub parts, we will provide the solution only to the…

Q: 2.3 A 12mm diameter pipe 15m length is used to drain an oil tank. Determine the discharge when the…

A: given data:diameter=12mm=0.012mlength=5moil level in the tank 2m aboveh=2moil viscosityμ=0.01 pu…

Q: mine the change in length in metre due to work by surrounding on the system of 15 kJ with

A: Work done = 15KJ = 15*10³J = 15*10³kgm²/s² Force = 300N = 300kgm/s²