Q3. A well pumping from a unconfined aquifer at steady rate of 293 m³/hr. Two observational wells were installed at distances of 35 and 100 m form the pumping well. Assume h,-45 m Determine the: a. Drawdown (hz hı) if K = 0.25 m/hr b. Drawdown (h; hi) if K = 0.75 m/hr

Q3. A well pumping from a unconfined aquifer at steady rate of 293 m³/hr. Two observational wells were installed at distances of 35 and 100 m form the pumping well. Assume h,-45 m Determine the: a. Drawdown (hz hı) if K = 0.25 m/hr b. Drawdown (h; hi) if K = 0.75 m/hr

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: 2. In an unconfined aquifer, the drawdown is 2m at a radial distance of 9m from a well after two…

A: Given:- The drawdown from the unconfined aquifer = 2 m The radial distance from a well = 9 m Time…

Q: A field pumping test was conducted from an aquifer of sandy soil of 4 m thickness confined between…

Q: 1. Three wells each having a diameter of 250mm are installed at the vertices of an equilateral…

A: Given Diameter of well =250mmrwell=2502=125 mm=.125mVertices of an equilateral triangle=18 m∆h=2.5…

Q: A well in an unconfined aquifer is pumped at the rate of 50 L/s ( 800 gal/min.). The thickness of…

Q: Assume that an aquifer being pumped at a rate of 40 cubic feet per minute is confined and pumping…

Q: For steady state flow to a fully penetrating well in a confined aquifer, the drawdown at radial…

A: Solution is attached below as

Q: A 50 dm diameter well gives a discharge of 0.05 m³/sec. Two observations well were made at a…

A: Given data, q = 0.05 m³/s B = 10 m Diameter of well = 5 meter

Q: A well is constructed to pump water from a confined aquifer. Two observation wells, MW1 and MW2, are…

Q: a 45-cm well in an unconfined aquifer of saturated thickness of 48 m yields 701 lpm (liters per…

Q: The following criteria are needed to reach the "steady state" EXCEPT.. i. The water level in the…

A: The following criteria are needed to reach the "steady state" EXCEPT.. iv. The water level in all…

Q: In an unconfined aquifer, the drawdown is 2.5m at a radial distance of 10m from a well after three…

Q: Problem 1 A field test is conducted in a confined aquifer by pumping a constant discharge of 525…

Q: 0cm diameter well fully penetrates an unconfined aquifer with saturate thickness ho-60m and…

A: GIVEN DATA:-⇒Diameter of well dw= 30 cm⇒radius of well rw= 302⇒rw=15 cm⇒Thickness ho= 60m⇒ro= 120…

Q: A pump out test is carried out in a perforated well of 30 cm in diameter, extending into an…

Q: QI) An unconfined aquifer has a thickness of 33 m. A fully penetration 20 cm diameter well in the…

A: Considering the Thickness of Unconfined Aquifer from the Water Table.The Diagram is Given Below:2-…

Q: The static level of water table in an unconfined aquifer was 35m above the underlying impermeable…

Q: A 50 dm diameter well gives a discharge of 0.05 m³/sec. Two observations well were made at a…

Q: (b) Give the characteristics of different formations in which groundwater exists. A fully…

A: Given- Artesian well-discharge-Q=25 l/s=2160 m3/daystorage coefficient S=4.5×10-4transmissivity…

Q: A field pumping test was conducted from an aquifer of sandy soil of 4 m thickness confined between…

A: To Find :- Permeability K of the soil in m/sec.

Q: A field pumping test was conducted from an aquifer of sandy soil of 4 m thickness confined between…

Q: A 30 cm well is pumped at the rate of 1000 1pm. The transmissibility of the aquifer is o.015 m²/s.…

A: The given data is: Q=1000 Lps Q=1/60 m3/s x=120 m a=120 m T=0.015 m2/s r=80 m

Q: A community of 15,000 capita and fire demand of 35 L/s for six hours is to be served by a 50 cm…

A: Given data, Hydraulic conductivity K = 100 m/d Radial distance r1 = 150 m Radial distance r2 = 50 m…

Q: Answer both 1 (i) and (ii) 1) i) A 6 inch diameter well that fully penetrates a 40ft thick open…

Q: What will be the average velocity ( Darcy velocity ) of flow in the aquifer at a distance 20 ft from…

A: Given Data:Thickness of aquifer = 85 ftDiameter of well drilled = 86 inTo determine:Maximum rate of…

Q: A field pumping test was conducted from an aquifer of sandy soil of 4 m thickness confined between…

Q: 26: ( ) A 40 cm well fully penetrated an unconfined aquifer of saturated depth 15 m. when a…

A: We have to estimate the coefficient of permeability of the aquifer and also have to determine the…

Q: The discharge from a fully penetrating well operating under steady state in a confined fer of 35 m…

A: Given:- thickness=B=35m discharge = q=2000 l/min drawdown observation = 12m and 120m away are 3.0…

Q: A 300 mm diameter test well penetrates 24 m below the static water table. After 24 hours of pumping…

A: GivenH=24ms1=1.2ms2=0.6mr1=34mr2=96mQ=69ls=0.069m3sh1=24-1.2=22.8mh2=24-0.6=23.4so,For unconfined…

Q: Transmissibility

A: Given data : For well at 20 m water is lowered (dw1)=2.11For well at 80 m water is lowered…

Q: A fully penetrating well of diameter 0.3 m is located in an unconfined aquifer of saturated depth 45…

Q: a 30 cm well penetrates an unconfined aquifer of saturated depth 25m. When a discharged of 2100 lpm…

A: Given:The diameter of the well is 30 cm.The depth is 25 m.The discharge is 2100 lpm.The radial…

Q: Yield of a well is 10 lit/sec under a depression head of 4m. The value of specific capacity per unit…

Concept explainers

Pressurized pipe flow

A 15-kilometer-long pipe with a pipe diameter of one meter transports water at a speed of one meter per second. The pipe has a friction coefficient of 0.005. Calculate the frictional head loss?

Question

Q3. A well pumping from a unconfined aquifer at steady rate of 293 m³/hr. Two observational
wells were installed at distances of 35 and 100 m form the pumping well. Assume h,=45 m
Determine the:
a. Drawdown (hz' hı) if K = 0.25 m/hr
b. Drawdown (hz hj) if K = 0.75 m/hr

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1 Introduction:-

VIEW

Step 2 Calculation:-

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Need answer ASAP
i need the answer quickly
Plz answer ASAP
Q3. A 200 mm diameter well which fully penetrating a confined aquifer of thickness 25 m is pumped at a constant rate of 2000 m3/day. The steady state drawdown in the well is 8 m and the drawdown in a piezometer 100 m from the well is 1.4 m.(a) Ignoring well losses, calculate the transmissivity of the aquifer, the hydraulic conductivity of the aquifer material and the radius of influence of the well.(b) Repeat the calculation for an unconfined aquifer with saturated thickness 25 m
A confined aquifer with T = 7.0 x 10-3 m2/s and S = 5 x 10-4 is pumped by two wells, 35 m apart. One well is pumped at 7.6 L/s and one at 15.2 L/s. Plot the drawdown h0-h versus distance along a line joining the wells, 4 hours after the start of pumping. Use 5 m increments along the line. How would I go about this question if my initial r1 would equal 0 and and r2 would equal 35m additionally how would I get the pumping rates at each 5 m increments. overall please give a step by step on how I Would go about this question
18. A well that pumps at a constant rate of 0.5m/s fully penetrates a confined aquifer of 34 m thickness. After a long period of pumping, near steady-state conditions, the measured drawdowns at two observations wells 50 and 100 m from the pumping well are 0.9 and 0.4m respectively. a) Calculate the hydraulic conductivity and transmissivity of the aquifer. b) Estimate the radius of influence of the pumping well c) Calculate the expected drawdown in the pumping well if the radius of well is 0.4m
Please Include every stepThank You
Problem 3.5 A well of diameter 0.3 m is constructed to the full depth of an unconfined aquifer of thickness of 150 m. The water table is 10 m below the ground surface. A pumping test of 12 m'/hour has resulted a drawdown of 10 m. Assuming ro = 400 m; calculate the coefficient of permeability of the aquifer. If the flow rate increases to 18 m'/hour, and in the absence of any other data, what will be the best estimate for the drawdown in the well?
QUESTION 1 Calculate the transmissivity of an artesian aquifer that has a thickness of 5.5 m and is pumped at a rate of 1.52 m³/min. There are two observation wells located at 150 m and 280 m away with drawdowns of 0.8 and 0.72 m respectively. (15) QUESTION 2 An aquifer has T = 175 m²/day, S = 1.3 x104, and provides a flow of 20 L/s to a well. Find the drawdown at the two observation wells located 15 and 65 m from the producing well after 1 day, 2 months, 10 months and 2 years. (15)