Q3/ Two 50 Hz generators of rating 100 MW and 300 MW are operating in parallel. Each of them has a speed regulation of 5%. They supply a total load of 320 MW. Assume that the speed changers are set to give rated frequency at 100% rated output power. Determine the output power of each generator and the operating frequency.

Q3/ Two 50 Hz generators of rating 100 MW and 300 MW are operating in parallel. Each of them has a speed regulation of 5%. They supply a total load of 320 MW. Assume that the speed changers are set to give rated frequency at 100% rated output power. Determine the output power of each generator and the operating frequency.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Describe the figures below and how each of figure below are working
READ THE PROBLEM AND JUST DRAW CIRCUIT DIAGRAM. NO NEED TO SOLVE ANYTHING. A short shunt compound generator delivers 150A at a terminal voltage is 230V.The shunt field current is 2.5A. The resistances of the armature, series field and diverterare 0.032 ohm, 0.015 ohm and 0.03 ohm respectively. Calculate the electrical efficiencyof the generator at this load. Modify the circuit diagram on the picture based on the problem. Answer: 95.7%
A 10-kW, 250-V compound (long-shunt) generator has a no-load voltage of 230 V. The shunt field has 800 turns per pole and the series field 8.5 turns per pole. The shunt- and the series-field resistances are 80 ohms and 0.07 ohm, respectively. In order to make the generator flat-compound, so that it will have a no-load voltage of 230 V and a full-load voltage of 230 V, the series must produce 225 amp-turns. Calculate: (a) the resistance of the diverter to accomplish this change; (b) the total number of ampere-turns produced by each pole at no-load and at full-load.
6
Determine the power angle characteristic for the system shown in figure. The generator is operating at a terminal voltage of 1.05p.u. and the infinite bus is at 1.p.u. voltage. The generator is supplying 0.7p.u power to the infinite bus. Draw the power angle curve in graph sheet.
Please solve this problem step by step and illustrate your answer properly. Write your answer in a piece of paper please. Box the final answer.
Q-4 100 MVA, 50 Hz alternator is operating at rated speed. The H constant of the machine is 5 MJMVA. The load suddenly increases by 50 MW. Due to delay in governor action, there is a delay of 0.5 sec in opening of steam value. The frequency deviation in percentage is
6 shunt generators are running in parallel in a curtain generating station. Each generator supplies a load current of 500 A at 220 V. The shunt field current of each generator is 5 A and the armature resistance of each machine is 0.05 ohm. If one generator is suddenly switched off determine the percentage change in terminal voltage, the total load current being kept uncharged. A: 3%-2%
In DC shunt generator, the load characteristics is drawn between
Two shunt generators A and B operates in parallel and their load characteristicsmay be taken us straight lines. The voltage of the generator A falls from 240 V atno-load to 220 V at 200 A while that of B falls from 245 V at no load to 220 V at150 A. Determine the current which each machine supplies to a common load of300 A and the bus-bar voltage at this load.
The armature reaction occurs when a separately excited generator supplies rated load: Is always present Is always absent May be sometimes present None of the above
In a separately excited generator supplying rated load the armature reaction. is always present is always absent O none of these may be sometimes present