Q3: Tikrit University has been implemented a project of an electrical portable station. This project includes installing two towers each of them has a hight of 39 m to cary the overhead transmission line from outside to inside the University. And the distance between the towers is 300 m. But, the transmission line flow-through a ground has a gradient (slope) of 1/15. After calculating the sag, find the distance (clearance) between the orginal point and the ground. The tensile strength in the wire is 2500 N/cm2. The weight of one meter of the conductor is 9 N. The cross-section area of the conductor is 4 cm2.

Q3: Tikrit University has been implemented a project of an electrical portable station. This project includes installing two towers each of them has a hight of 39 m to cary the overhead transmission line from outside to inside the University. And the distance between the towers is 300 m. But, the transmission line flow-through a ground has a gradient (slope) of 1/15. After calculating the sag, find the distance (clearance) between the orginal point and the ground. The tensile strength in the wire is 2500 N/cm2. The weight of one meter of the conductor is 9 N. The cross-section area of the conductor is 4 cm2.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

one circuit of a sinlge phase transmission line is composed of three solid 0.5 cm radius wires. the return circuit is the composed of two solid 2.5 cm radius wire . the arrangement of conductors is as shwon in figure below. applying the concept of GMD and GMR , find the inductance of the complete line in millihenry per kilometer
The following figure illustrates the configuration of a two-bundle and completely transposed transmission line system operating at 50 Hz. The transmission line length is 100 km, and each bundle consists of conductors with a diameter of 6.0 mm. The resistance of each bundle is 0.12 22 per kilometer. Answer the following questions. a) The inductance in H/m for each phase of the transmission line. b) The total inductive reactance in 2 for each phase of the transmission line. c) The capacitance in F/m for each phase of the transmission line. d) The total capacitive reactance in 92 for each phase of the transmission line. e) Sketch the nominal- circuit of the line 3m 3m 0.06 m 8m
d) Calculate the per unit voltage drop on the transmission line e) Calculate also the sending end voltage Use an overall base of 100 MVA.
Give an Introduction about the performance of different types of transmission lines used to transfer bulk power, in different countries.
A transmission line has a span of 150m between level supports of 10 meter height. The ground clearance is 85 % of the tower height. The difference in level between the points of supports and the lowest point on the conductor in meters is
A single circuit 60 Hz transmission line. the conductors are Linnet type with flat horizontal spacing of 17.46 feet between conductors. Determine: (a) Assume that the line is short with a length of 50 miles, calculate the parameters of the line and draw the equivalent circuit. (b) Assume that the line is average with length of 150 miles (Pi-nominal model). draw the pi-nominal circuit for the transmission line and calculate its parameters (Z and Y/2 values, where Z is the series impedance of the transmission line and Y is the shunt admittance).
Compute up to 4 decimal places but only encode your final answers with only 3 decimal digits
For a 80 km transmission line given the values of R=0.5 22/km and X= 7 22/km. Find the admittance of the transmission line in per unit. Take base values as 125 MVA and tos kV.
1. The transmission system has two types; 2. For the extra high voltage transmission 3. ACSR stands for and and are usually used, 4. In case of the unsymmetrical spacing, the line is transposed in symmetrical spacing, the line is transposed in 5. Main components of a transmission line are ..... .. times, where in the times. ...... ..... and
b) Ghana Grid Company (GRIDCo) designed a short transmission line using the A, B, C, D line constant of a transmission line parameters in its analysis. The engineering planning department came up with the design and said that when they computed the line performance using the equation AD – BC the answer was equal to 1.As an employee at the Ministry of Energy (MoEn) having oversight responsibility over GRIDCo, how would you accept the answer and recommend the Government of Ghana (GoG) to go ahead to implement the short transmission line?
A transmission line has a span of 150m between level supports of 18 meter height. The ground clearance is 85 % of the tower height. The difference in level between the points of supports and the lowest point on the conductor in meters is
1. Following are types of Transmission Lines EXCEPT A. Medium Line B. Long Line C. Capavitive Line D. Short Line 2. What is the theory used to express the voltage and current relations? A. Per-Phase B. Equavalent Transmission Line Model C. Two Ports Network 3. A 300km transmission line is considered as A. Long Line B. Medium Line C. Short Line 4. For a short transmission line, values for element A B C and D are A. A=1, B=0, C=Z, D=1 B. A=1, B=Z, C=0, D=1 C. A=0, B=Z, C=1, D=1