Q3:-The uniform 10 kg ladder in figure below rests against the smooth wall at B, and the end A rests on the rough horizontal plane for which the coefficient of static friction equals 0.3. Determine the angle of inclination of the ladder and the normal reaction at Bif the ladder on the verge of slipping. Bloky 4m

Q3:-The uniform 10 kg ladder in figure below rests against the smooth wall at B, and the end A rests on the rough horizontal plane for which the coefficient of static friction equals 0.3. Determine the angle of inclination of the ladder and the normal reaction at Bif the ladder on the verge of slipping. Bloky 4m

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

13 kN B Block A supports a pipe column and rests as shown on wedge B. Knowing that the coefficient of static friction at all surfaces of contact is 0.25 and that 0=45°, determine the smallest force P for which equilibrium is maintained.
4. The angle of inclination of the smooth surface is 30° from thehorizontal. The weight of the body is 236 kN and is supported by an external loadP for the body to be in equilibrium.Determine the following:a.) The Reaction at the Smooth Surface.b.) The Load P.
5. The uniform 7-m steel shaft has a mass of 200 kg and is supported by a ball-and-socket joint at A in the horizontal floor. The ball end B rests against the smooth vertical walls as shown. Compute the forces exerted by the walls and the floor on the ends of the shaft.
What is the Maximum moment in kN-m. Given: w = 12, a = 3, b = 5, and c = 2.
Input-271m
A uniform rigid bar which weighs 1000KN/m is supported by a cable at point B, a rough surface horizontal floor at point A, and a corner edgeof a rough surface wall at point C. If the coefficient of static friction on all contact surfaces is 0.10, determine the reaction at the supports of the uniform rigid bar. Neglect the weight of the cable.
Question #1 Determine the reactions at the supports using force method. El is constant. 50kg 20kg/m 1m 2m Question #2 Determine the reaction at each support using slope-deflection method. El is constant.
Q2/ Determine the reactions at the supports. Assume B is hinge connected. El is constant .Use Method of Slope Deflcction Equation.(. (P in kN/m)
please help...
A uniform 50-kgf board rests on rough supports located at A and B in the figure. Thefriction coefficient μs=0.60 on both contact surfaces. If a man weighing 80 kgfpulls on the rope with a force of 40 kgf, determine:a) The angles "min" minimum and "max" maximum for which the system is in equilibrium.b) The minimum coefficient of friction that must exist between the soles of the man's shoes andthe soil for each of the cases in section a.
A structures is subject to pressures in both slides as shown in the figure. The weight of the structure is 80KN. a. Assuming that the structure is pinned at D to the ground. Determine the tension AB at the reaction/s at D remain to the structure in equillibrium. b. Assuming that the structure is fixed at D and there is no tension anchor at A, determine the reaction/s at D.