Q3: The following consecutive staff readings were taken with a level: 1.895, 1.500, 1.865, 2.570m 2.990, 2.020, 2.410m 2.520, 2.960, 3.115, 3.115. The level was shifted after 4th, 6h and 9th readings. R.L. of the last point was 30.245m. Rule out a page of your answer book as level book and fill all columns. Use collimation system and apply the usual arithmetical checks.

Q: Fill out the differential leveling table with corresponding calculations (page check, misclosure,…

A: Fill out the differential leveling table with corresponding calculations (page check, misclosure,…

Q: Q1). The following consecutive readings were taken along a straight line from station (11+090) to…

A: As per bartleby guidelines, only 1st 3 parts among multiple parts questions need to be solved.…

Q: The following readings were taken with a level on a 5m staff in a levelling operation from points 1…

A: To Determine 1- Elevation of all points by rise and fall method and apply appropriate check. 2- The…

Q: Q1). The following consecutive readings were taken along a straight line from station (11+090) to…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: The following consecutive staff readings were taken with level and 5m staff at 70 m interval. The…

A: Given, Elevation at first point and last point= 80m and 84.96m

Q: 1.932 1.930 1.920 1.910 1.900 With reference to the figure above, the leveling rod reading equals: O…

A: The levelling rod reading equals to  1.932

Q: Q2) 1-Four stations C, A, B, and D were set out in a straight line such that CA = AB= BD = 30 m. A…

A: Given: CA = AB = BD = 30m level at C A1=2.135, B1= 1.823 level at D A2= 2.026, B2= 1.768 Required:…

Q: The following readings were taken B33 operation from points 1 to 12, (2.08, 1.625, 3.2, (1.67 and…

A:

Q: The following staff readings were observed successively with a level. The instrument has been…

A: The objective of the question is to calculate the Reduced Level (RL) of all points using the plane…

Q: PLEASE FIND SOLUTION THAT WILL COME UP WITH THE SAME ANSWER The two-peg test is used to determine…

A: Surveying is the technique of establishing the relative locations of various things on the earth's…

Q: The following readings were taken with a level on a 5m staff in a levelling operation from points 1…

A:

Unit Conversion

Standard units are also called SI units. SI units are used for measuring a physical quantity satisfying certain conditions. There are two types of units: fundamental units and derived units. Fundamental units are physical quantities that are independent, that is, they do not depend on other quantities like mass, length, or time. There are plenty of quantities in our lives which need to be measured and compared. Measuring is the comparison of a particular physical quantity with its reference value. A unit is a measure of a fixed physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.