Q3: Material A and Material B are collected in a tank as shown where the system consists of three Push-Button, three Level Sensors, two Inlet valve, one Outlet valve, Heater, Temperature Sensor, Agitator Motor, and Alarm Light. Material A and Material B are to be mixed and heated until it reaches 90°C temperature, and it will be drain using outlet valve also high-level Alarm Light will come ON when the tank is full and stay on even if the tank level drops until the operator press Reset Push-Button. Implement automation of this system in PLC using Ladder Diagram programming language (Note: The tank is fed with Material A before B and the temperature sensor can withstand 200°C and it gives voltage from 0 to 10 volts) (25 Marks) Valve A Agitator Motor Valve B Level B Heater E Level A Low Level Sta Start Push-Button Stop Push-Button 36. ویر نکند Temperature sensor Outlet Valve Reset Push-Button Alarm Light

Post Test Choose the letter of the correct answer. Write the chosen letter on a separate sheet of paper. 1. It is a smail component that lights up when current flows through it. a. Capacitor 2. It regulates the amount of current flowing in an electronic circuit. a. Capacitor 3. These are devices or components which do not require an external source to their operation. b. Fuse c. LED d. Resistor b IC c. Inductors d. Resistor c. passive devices d. electrical devices a. active devices b. electronic components 4. It is a three-terminal active component that is used mainly in boosting or amplifying electrical signals; both AF and RF ranges. a. Capacitor 5. it is necessary to turn the electrical circuit "on" or "off" a. Fuse 6. Testing tools that are capable of executing tests, reporting outcomes, and comparing results with earlier test runs a. Automated 7. The testing method that starts a soon as code is written and continues in successive stages as code is combined with other units of…

please provide correct solution for the question

26 CHAPTER 2 Symbols and Schematic Diagrams REVIEW QUESTIONS 7. Referring to the circuit in Figure 2-22, should the float switch be connected as a normally open or normally closed switch? 8. Referring to the circuit in Figure 2-22, what circuit component controls the actions of the two CR contacts? 1. The symbol shown is a a. polarized capacitor. b. normally closed switch. c. normally open, held closed switch. d. normally open contact. 2. The symbol shown is a a. normally closed float switch. b. normally open, held closed float switch. C. normally open float switch. d. normally closed, held open float switch. 9. Why is a circle most often used to represent a coil in a motor control schematic? 10. When reading a schematic diagram, are the control components shown as they should be when the machine is turned off or de-en- 3. The symbol shown is a(n) a. iron core transformer. ergized, or are they shown as they should be when the machine is in operation? b. auto transformer. c. current…

Fill in the blanks: Given the model for position control system, find the value for K1 and K2 so that the peak time is equal to 0.5 s and the %OS is equal to 3%. K1= 93.2070 K2= 0.129 I 446 23

I need the answer as soon as possible

Answer all the items. Thanks!

Electronic communications field i need for my today class work please give me details information

Describe the operation of Figure 325 (B) by adding jumper wire A to the original circuit.

QUESTION 5 We would like to run the power wires for both cooling pumps in the same RMC from the Breaker panel to a junction box above the control panel. What size ungrounded conductors do we need for the 100 amp load? All conductors have typeTHHN insulation. A #6 AWG    B #3 AWG    C #4 AWG    D #1 AWG