Q3: In the orifice meter experiment we found the following data of sample: The volume of water through 15 second is 315 mL, the diameter of the orifice meter is 6mm, and the height of the tank in (mm) is 300.the vertical distance of the needles (2) and (7) is 3 and 9 cm respectively. Find for two the needles listed above: 1-Cofficient of discharge 2- Coefficient of velocity. 3- Coefficient of contraction. 4- Comparison between coefficient of contraction and coefficient of discharge. 5-whate is the effect of high of tank with flow of orifice.

Q: For a 3D potential flow, use the continuity equation to show that the velocity potential o must…

A: For a 3D potential flow, use the continuity equation to show that the velocity potential o must…

Q: Use moment area method to determine the slopes and deflections at points asked? 2-a) find deflection…

A: Given Data Determine the slope and deflection at point B and C using moment area method.

Q: A cantilevered beam is subjected to a concentrated force and an uniform distributed load as shown…

A: For calculating the maximum slope in the cantilever beam, calculate the slope for different types of…

Q: In horizontal distance measurement, the slope is considered as an error which must be corrected.…

A:

Q: Use Richardson Extrapolation to solve the finite element method in engineering; refer to the…

A: Step 1: Step 2: Step 3: Step 4:

Q: A vector, F , has components F--286.9 N andF, = 410.6 N. What is the angle made with the horizontal?…

A:

Q: Determine the moments of inertia Ix and Iy of the area shown about vertical and horizontal axes…

A:

Q: From the measured values of distance AB, the following trials were recorded. DISTANCE (m) TRIALS 1 2…

A: Given,DistanceTrail      Distance 1.          120.682.           120.843.          120.764.…

Errors in surveying

An error in surveying is defined as the difference between two or more values of an identical quantity. However, the estimates are never accurate and there will always be a degree of variability regardless of the research tool or method used. These differences are known as errors that need to be reduced or eliminated to maintain certain levels of accuracy. Even if you carefully follow the prescribed test procedures, the considerations may contain errors.