Q3- Design a BPF FIR filter that will have a-3 dB cutoff at 20x and 25x rad/sec. and an attenuation of 40 dB at x and 45 x rad/sec. The system will use a sampling rate of 100 samples/sec., then find h(0), h(a) and h(10).

Q: question 3B  Construct an excitation table to enable implementation using J-K flip-flops and a Next…

A:

Q: Construct a common circuit with 2 outputs for the given two functions f(a,b,c)-Σ(13,4,5), g(a,b,c) -…

A: The given functions have 3 variables. So I am using k-map for 3-variables to get the output of the…

Q: Q1\ Design and find frequency passband of analog Butterworth filter that has -2dB passband…

A: To design an analog Butterworth filter and find its frequency passband given the following…

Q: simplify the following equation using boolean algebra and draw the circuit diagra ply NOR gate:…

A:

Q: 1. Design 6th order Butterworth band-pass filter with cut-off frequency is 4KHz and 7KHz and pass-…

A: Planning a sixth request Butterworth band-pass channel includes a few stages, including deciding the…

Q: to X2 X3 The signal flow graph above has Select one: a. (3) Forward paths and (2) non touching loops…

A: Find the answer with explanation given as below :

Q: value of x(t) = rect (t/4) cos(0.5πt) will be

A: It is defined as the value required for the system to perform the functions.

Q: Q1: A Si sample is doped with 1017 cm-3 As. What is the equilibrium hole concentration at 300 k?…

A: Solution of the given question is:-

Q: For F (A, B, C, D) = Σm(0, 1, 2, 3, 4, 5, 7, 9, 11, 13, 14, 15) (a) Find a minimum circuit of…

A: To implement the Boolean function we'll first find a minimum circuit using two-input AND and OR…

Q: Design characteristics table and Excitation table for D- FlipFlop and SR-FlipFlop using their truth…

A: Need to Design Characteristic table, Excitation table for D flip flop and SR flip flop along with…

Q: Q1-A Simplify the following Boolean function F(A,B,C,D) = E(1,3,5,7,9,15,4,6,12,13) Q1-B Design an…

A: 1 A Given minterms are 1,3,4,5,6,7,9,12,13,15 By using k map simplification we get F = A'D + C'D +…

Q: An optical waveguide which consists of cladding, core with refractive index n(clad) -1.19,…

A: Step 1: To determine whether the beam of light will achieve total internal reflection (TIR) or will…

Q: (a) An aperiodic signal is defined as x(t) = sin(at) u(t), where u(t) is the continuous time step…

A: Question:

Q: Frequency-Shift Keying (FSK) A.7 To generate the continuous phase FSK signal sf, with mark and space…

A: There are three basic ways to modulate a sine wave radio carrier: modifying the amplitude,…

Q: Problem 4 Implement the following Boolean function using an active-low decoder and a NAND gate. F…

A:

Q: Given the circuit with input of 80HZ, • Find the turns ratio • Find Vp(sec) • Find Vo when capacitor…

A: Solution for above problem is given below -

Q: The gates in the exclusive-OR circuit below have delays of 2 ns for the inverter, 5 ns for the AND…

A: To determine the signals at the output of each gate in the exclusive-OR circuit, we need to follow…

Q: you are going to implement finite state machine for traffic light 4way 6 input ( c1,c2,c3,c4, S and…

A: S = south N = north W = west E= east Time to reach from any one state to other is 1 sec Time to…

Q: Having the following function: F(A,B,C,D) = Em(2,3,6,7,8,9,12,13) and Ed(0,1,5,10) 1) Minimize F…

A: Since you are asking multiple questions, we are doing first question for you. If you want solution…

Q: Given an armature-controlled DC motor has the following transfer function K G(s): (s + 10)(s + 1) S.

A: On expanding the denominator,we get s2+11s+10. we take the value of k as 10, since it is a…

Q: JESTION 2 (a) Design the circuit with the function F = AC + BC using

A: Multiplexers in Digital Logic:It is a combinational circuit which have many data inputs and single…

Q: Write a algorithm for 2-D steady state heat transfer where all walls are subjected to Diritchlet…

A: Algorithm  pdepe(m,@heatpde,@heatic,@heatbc,x,t); colormap hot imagesc(x,t,sol) colorbar…

Q: Write down the truth tables for AND, OR and XOR gates

A: AND Gate is an digital logic gate that combines two signals so that the output is on if both signals…

Q: Q; For a unity feedback control system the open loop transfer function G(S)= 10(s+2)/s2(s+1), Find…

A: solution for this question is provided below in step 2.

Q: Consider the following R-L circuit: Rs iz(t) vz(t) If t, = 0 and initial current through the…

A:

Q: 7- A certain TTL gate has IH =20 µA, IL =0.1 mA, IoH =0.4 mA and IoL = 4 mA. Determine the input and…

A: Given that A certain TTL gate has I_{IH}=20 μAIIH ​=20μA, I_{IL}=0.1IIL​=0.1 mA,I_{OH}=0.4IOH =0.4…

Q: FIND THE SOLUTION USING K-MAPPING AND FIND THE EQUIVALENT LOGIC CIRCUIT GATE.

A:

Q: Q3: Design an op amp circuit to provide an output =-[41+ (2/3)]. Choose relatively low values of…

A: AMP Circuit Diagram given below

Q: the circuit with a decoder and external gates

A: A combinational circuit has 2 outputs F1 and F2 the circuit with a decoder and external gates

Q: Q4: Design SPWM inverter with sinusoidal output voltage Vdc = 311 V, R = 8.8 0, output power Po =…

A: ANSWER:-

Q: 4. Draw a JK Flip Flop circuit configured to automatically toggle between the outputs every 0.5…

A: According to bartleby guidelines we are supposed to answer only 1 question So question 4 has been…

Q: a. Calculate the filter coefficients for a 5-tap FIR bandpass filter with a lower cutoff frequency…

A: The questions asks:a. Calculate the filter coefficients for a 5-tap FIR bandpass filter with a lower…

Q: Implement the following Boolean function with a (4 X 1) multiplexer and external gates. F(A, B, C,…

A:

Q: O Reference pulse gen O LPF and multiplier ci O LPF and holding circ

A: given - PAM Demodulator consists ofComparator and SawtoothFlip flop and LPF Reference pulse…

Q: 9- Figure below shows a tri-state NAND gate driving a standard TTL.AND gate. Determine the output X…

A: H i please find the solution below and I hope it would be helpful for you.

Q: Вз Аз || FA S3 В2А2 B1A1 Во о 2 2 | | | | | | FA FA FA S2 S1 So M

A: Given Data : Carry propagation delay of FA = 12 ms Gate propagation delay of XOR Gate = 4 ms

Q: Design a combinational circuit defined by the Boolean function F(X,Y,Z) = (X'+Y)(X'+Z')(X'+Y'+Z),…

A: Given:   We have to design combinational circuit defined by the Boolean function F(X,Y,Z) =…

Q: gnetic Pulse propagating at oblique angle to a dielectric interface Consider a gaussian wave pulse…

A: It is defined as a packet whose initial state is one of the few states for which both the {|x i} and…

Q: Q. No. 7- Describe the method of designing a linear phase FIR filter using windows

A: Linear phase is a property of a filter where the phase response of the filter is linear function of…

Q: X, X2 X3 The signal flow graph above has Select one: a. (3) Forward paths and (2) non touching loops…

A: Forward path: The forward path is the path from the starting node to the final node, where the…