Q3: Design 5/16-in SMAW fillet welds for the plate shown in figure below if A36 steel and E70 Electrode are used, Dead Load=40 kips, Live Load-60 kips. PL x 12 PL x8

Q: C100 x 8 Angle 100 x 75 x 6 The composite shape shown below was manufactured by welding a structural…

A:

Q: All values of Stz are by the joint on the part indicated. What is the missing value? ? 0 O-6a²t 4a²t…

A: The given figure;

Q: The simple truss shown below has five members pin connected together. There is a pin support at A…

A:

Q: Problem 6.5 - Determine a) the magnitude and location of the resultant mijnímým mj of the…

A:

Q: What is the reference stress for bending about the Y -Y axis of a softwood glulam member from…

A: As per 2005 NDS supplement American Wood council Table 5A.

Q: 1. Calculate all the stresses in this truss. Using low carbon steel, calculate the minimum diameter…

A: Horizontal Spacing = 15 feet Height of truss = 12 feetF Factor of Safety = 2.0

Q: choose the W section of 50 ksi steel

A:

Q: Determine the shear Load that act on the fillet weld that joining two plates together if the working…

A: To find- Shear load

Q: Determine the forces in the following members of the roof truss shown. Indicate whether they are in…

A:

Q: Which of the following best describes a plastic hinge? Section where extreme fibers have yielded O…

A: Answer- MY < M > MP Explanation - Plastic hinge can be defined as yielded zone due to flexure…

Q: SF A D B' -B- A SM O Patm h₂ C+

A:

Q: Determine the (internal Di, external De and total D) static indeterminacy of the following…

A:

Bars

In civil engineering, bars refer to steel reinforcement bars or rebars. These are structural members primarily used for reinforcement purposes in masonry works. A bar is characterized by its cross-sectional area, which is negligible compared to its length. Bars are usually manufactured by steel which is uniform throughout the length, or by meshing multiple steel wires. Other materials of the bar include carbon steel, glass fiber, carbon fiber, and basalt fiber. The reinforcing bars are coated with epoxy resins and other materials to enhance some of their properties including corrosion resistance.