Q3 Choose (Two only): A. Explain the stimulated emission? B. Explain the feedback mechanism by using the diagrum of laser resonator ? C. According the chart of four level system , show how laser emission?
Q: In a single-phase semi-controlled rectifier, if the firing angl degrees and the input voltage is…
A: To answer: obtain the Dc voltage
Q: Explain five (5) applications of the hall effects With the aid of a diagram, explain how a P-N…
A: Application of hall effect 1. By knowing the voltage through hall effect one can understand that…
Q: Q4) Briefly define the following terms : Generation and recombination, Mobility, Diffusion current…
A: Generation: It is a process by which electrons acquire energy and gets excited from valence band to…
Q: g a simplified diode model.
A:
Q: Q.5/ Refer to the class AB amplifier in figure below operating with a single power supply: a. Find…
A: Given:-
Q: 1- Mention three types of oscillators?
A: Note: Out of multiple questions , we solve only first question unless specified. You can resend the…
Q: Q1 using the curves of Fig. 1: a. Determine the voltage across Ge diode at a current of 2 mA. b.…
A: Given Data: (a) To determine the voltage across Ge diode at a current of 2mA. (b) To determine the…
Q: How is gain determined for operational transconductance amplifier? wwww ww wwww a) two rates of…
A: This is a question from Analog Electronics. Operational Transconductance Amplifier: It is a device…
Q: Project# 2 (Use a BJT op-amp) • You've been asked to build an alarm system using monstable…
A: b) Frequency = 10 kHz Duty cycle=50% The comparator is a circuit which can compare two voltages. The…
Q: ages and currents for the tra easured values.
A: To calculate the DC voltages and current as, As per protocol, allowed to answer first part and…
Q: Explain the difference between a MASER and a LASER. Who was the inventor of MASER? Explain both…
A: LASER stands for Light Amplification by Stimulated Emission of Radiation. MASER stands for Microwave…
Q: 1. What is Resonance? 2. At resonance, is XC a maximum or minimum? Explain. 3. Why is it that Z =…
A:
Q: Figure 13 AVout At what frequency is the ratio equal to half? AV tn a. 3n 2RC
A:
Q: Electronic components like diodes and cransistors are built with semiconductors. a) Explain the p…
A:
Q: 3.) Discuss the basic operation of a photodetector and an LED. Does each device rely on generation…
A:
Q: discuss how lasers are used today both in the scientific community and in everyday life.
A: Different uses of laser are marked below I for both scientific and everyday life
Q: 7. Calculate the signal to noise ratio of a system with output voltage of 15 V and noise of 0.015 V.…
A: Ratio (SNR) = 20log10 (voltage of signal/voltage of noise)
Q: 1. What is full wave rectifier? 2. What are the types of full Wave Rectifier? 3. What are the…
A: A rectifier is a device which is used to convert AC signal into DC signal There are mainly two types…
Q: Under what condition would the alarm sound? When it is BRIGHT or Dark in the room. Note, LDR stands…
A: In the first step well understand the circuit and what will happen if the circuit is in a dark room.…
Q: 130° C 500 N 50°
A:
Q: What initiates a "Laser action" as described by the makers of the first Ruby laser? O a. Light…
A: Ruby laser is the first working laser that was developed. It is a solid state laser.
Q: Define the limitations of difference amplifiers and explain that when it does not meet the…
A: Differential Amplifier is a device that is used to amplify the difference in voltage of the two…
Q: Explain why in optical fiber the higher TE and TM modes (m> 1) mixed into hybrid mode
A: Energy can propagate through a medium or a vacuum. Propagation modes vary depending upon the type…
Q: University of Management and Technology, Sialkot Campus (Mid – Term Spring- 2021) Department of…
A: Ques. 1. The angular momentum of electrons orbiting around the nucleus is quantized in Bohr's atomic…
Q: Explain the differences observed in the relationships between the lasing power and pump power for…
A: A laser could emit short pulses if the loss of an optical resonator is rapidly switched from a high…
Q: 2)- What are the loss mechanisms in a LED device? How can a double heterostructure (DHS) reduce the…
A: Answer: As per the above information, It is explained in detail below as follows: LED: Light…
Q: Q2) Explain the working of zener diode on both forward and reverse bias. From the circuit in the…
A:
Q: a) Using the concept of feedback, explain the working principle of an Oscillator b) When negative…
A: (a) An oscillator is defined as an electronic device that produces a periodic, oscillating…
Q: What is optical isolator? Why is it necessary from powerline while recording live data? Pr
A: Define: Optical isolator is an magneto-optical component which ensures the unidirectional flow of…
Q: Measuring Peak Voltage The peak voltage is the amplitude of the wave. To measure the peak voltage…
A:
Q: The magnetic moment u has 3 directions of orientation in the magnetic field (B). unidirectional,…
A:
Q: Q8: Find the wavefunction in the middle region (region I) for the potential shown in the figure…
A: The Schrodinger equation for region I is written as, -h22md2ψ1dx2+V0ψ1=Eψ1⇒d2ψ1dx2+2mh2E-V0ψ1=0
Q: .The Effect of Temperature on Conductivity of Superconductors
A: Given:- (1) The electrical conductivity of a conductor is decrease with an…
Q: Q Chose answer the following A single-phase half wave voltage controller consists of a) one SCR is…
A: Let's break down the components and their roles in a single-phase half-wave voltage…
Q: 4. From output characteristic, find the suitable operation point (Q) and draw the d.c. load line.
A: The Bipolar Transistor is a three terminal device, there are basically three possible ways to…
Step by step
Solved in 3 steps with 1 images