Q3: A television signal (video and audio) has bandwidth of 4.5 MHz This signal is sampled, quantized ,and binary coded to obtain a PCM signal, i) Determine the sampling rate if the signal is to be sampled at a rate 20% above the Nyquist rate. ii) If the samples are quantized into 1024 levels, determine the number of binary pulses required to encode each sample. iii) Determine the binary pulse rate (bits per second) of the binary coded signal.

Q3: A television signal (video and audio) has bandwidth of 4.5 MHz This signal is sampled, quantized ,and binary coded to obtain a PCM signal, i) Determine the sampling rate if the signal is to be sampled at a rate 20% above the Nyquist rate. ii) If the samples are quantized into 1024 levels, determine the number of binary pulses required to encode each sample. iii) Determine the binary pulse rate (bits per second) of the binary coded signal.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

4. The information in an analog voltage waveform is to be transmitted over a PCM system with a F 0.2% accuracy (full scale). The analog waveform has a bandwidth of 200 Hz, and an amplitude range of -5 to +5 V. determine the following: - The minimum sampling rate needed. - The number of bits needed in each PCM word. - The minimum bit rate in the PCM signal. - The minimum channel bandwidth for transmission of this PCM signal.
An analog television signal containing frequencies up to 4.5MHz is to be coded by an ADC. The sampling frequency is 20% above the Nyquist rate. If there are 1024 quantizing levels, determine the rate of transmission.
The Nyquist rate for sampling an analog electrocardiogram (ECG) signal with 80 Hz highest frequency is 150 Hz. True False
Digital communications Encoding and Decoding of Information Signal 1- Discuss the effect of varying the frequency of the sampling signal on the output.
What is a minimum number of sampling frequency required to have distortion free reconstruction of a digital signal from its samples?
7. Why does PTM require a higher sampling frequency than PAM? a. The amplitude of PTM signals is constant. b. There are more sidebands in the first replica of a PTM c. Signal than in a PAM signal. d. A sample/hold circuit requires a higher sampling frequency. e. There are fewer sidebands in the first replica of a PTM signal f. Than in a PAM signal.
3. Define aliasing, and suggest the methods to avoid aliasing problem. The spectrum of selected CT signal is given below. Draw the spectrum of the sampled signal with critical sampling, under sampling by 20%, and oversampling by 50%. Discuss the result. 10 -100 100 f (kHz)
2. Define aliasing, and why it should be avoided? The spectrum of selected CT signal is given below. Draw the spectrum of the sampled signal with critical sampling, undersampling by 30%, and oversampling by 50%. Discuss the result. 1.0 -100 100 f (kHz)