Q3/ a) Determine the magnitude T of the tension in the supporting cable and the magnitude of the forces on the pin at A for the jib crane shown. The beam AB is a standard 0.5 m I-beam with a weight of 4.66 kN ?

Q: For the frame shown, determine the magnitude if the pin reaction at B. Neglect the weight of the…

A: Draw the free body diagram of the frame as shown below. Free body diagram 1. Free body diagram 2.…

Q: The thin steel plate, weighing 82, is being lifted slowly by the cable AC and BC. Compute the…

A:

Q: A bent pipe is connected by a thrust bearing and a cable as shown. If a Force, F = 184 lb, is…

A: There will be two reactions at thrust bearing and tension in the cable. Since Force F acts in single…

Q: In the figure below, the boom AC is supported in a ball and socket joint at C and by the cables AD…

A:

Q: Boom OAB is supported by a ball and socket at point O and two cables AC and AD. Determine the forces…

A:

Q: 30 kg 30 3/14: To facilitate shifting the position of a lifting hook when it is not under load, the…

A:

Q: Q.3) An airplane wing is supported by a truss structure as shown below. Three vertical forces are…

A:

Q: The homogeneous AB beam weighs 400 lbs. For each support condition in (a) a (d), plot the DCL of the…

A: (a) The DCL of the beam AB is given as, In this above diagram, two support reactions occur at the…

Q: Problem 4b: If the plate below weighs 500 N, find the tensions in the three cables. 1.5 m 1.6 m 2.5…

A: Given data: The weight of the plate, W=500 N Draw the free-body diagram of the plate.

Slope and Deflection

The slope in a deflected beam is described as an angle in radians made by the tangent of the section with the original axis of the beam. The deflection at any point on the axis of the beam is defined as the lateral displacement of the point before and after loading.