Q3) A convergent-divergent nozzle has a cross-sectional area at the throat of 0.1 m² Air enters the nozzle at a stagnation pressure of 101 kPa and a stagnation temperature of 15°C. The flow accelerates to sonic conditions at the throat and continues to accelerate in the divergent section of the nozzle until a normal shock wave is generated at a cross-sectional area of 0.1775 m² a) Determine the Mach number immediately upstream of the normal shock wave. b) Calculate the static pressure and static temperature immediately upstream of the normal shock wave. c) Determine the Mach number, static temperature and flow velocity immediately downstream of the normal shock wave. d) Calculate the mass flow rate through the nozzle using only values immediately downstream of the normal shock wave.

Q3) A convergent-divergent nozzle has a cross-sectional area at the throat of 0.1 m² Air enters the nozzle at a stagnation pressure of 101 kPa and a stagnation temperature of 15°C. The flow accelerates to sonic conditions at the throat and continues to accelerate in the divergent section of the nozzle until a normal shock wave is generated at a cross-sectional area of 0.1775 m² a) Determine the Mach number immediately upstream of the normal shock wave. b) Calculate the static pressure and static temperature immediately upstream of the normal shock wave. c) Determine the Mach number, static temperature and flow velocity immediately downstream of the normal shock wave. d) Calculate the mass flow rate through the nozzle using only values immediately downstream of the normal shock wave.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

How many passes will it take to reduce the diameter from 5 % (five and one fourth) inches into 3 % (three and three fourth) inch if the depth of cut is 1/16 inch.
Can someone show me how to do the roller, pin, and built-in supports( 2 each) and point them.
A six inch diameter cylinder with a two inch rod pushes out its full stroke of 20 inches in 1.5 seconds the pushing load is 750 pounds while the pulling load is 600 pounds. The pulling of the cylinder takes place in 1.2 seconds. What are the ranges of sizes of the valve that should be used?
What is the Falling Block?
the main diference between the prick punch and center punch?
Pitch characteristics
Hello, I was just wondering how you find hte angle of the blocks to 45 degrees? Thank you!
Sketch and explain any four Shaper operations?
In step 4, it should be the A and not the y right? So it should be FBD divided by 4.04 which is the cross-sectional area and not 6.9 which is the distance?
What firce is requure to punch off 5 mm hole out of a 4 mm thick plate if the ultimate punching stress is 200 MPa ?
What would a .010 - .020 cutback of a 14.500 Diameter be?
Solve it fast