Q2BCQ4 is a four bar linkage. Q2 and Q4 are fixed centers on a horizontal line 10 inches apart. Q2B is a link 5 inches long oscillating about Q2. Q4C is a crank 2 ½ inches long which rotates about Q4. BC is a connecting rod 11 ½ inches long. Q2 is left of Q4. A link, EF 6 inches long is pinned to Q2B at E, 1 ½ inches from B. Another link GF 3 ½ inches long is pinned to link BC, 4 inches from C. These links EF and GF are pinned together at F in their upper position. Trace the paths of the points F and G while Q4C makes 1 complete revolution. Find points for each 15 deg position of Q4C and any other necessary in order to secure smooth curve

Q: 2 3

A: The above-given mechanism is consists of N = 7 links as shown.  The mechanism has the number of…

Q: ecieved an answer to this question before, but I don't understand it. We're supposed to use vectors…

A: β=tan-13+OC.COSθ7-OC.SINθ  =tan-13+4.2×COSθ7-4.2×SINθl=2×2.8×SINθ2 =5.6 SINθ2

Q: The figure shows a linkage in one position. What is the instantaneous acceleration of point P if the…

A:

Q: Find the degrees of freedom of the following two different links Pin in slot b.

A: Solution:

Q: For the following mechanism, Given: . • Lengths: O₂A=4 in., O;B-8 in, BC=5 in., O₂O3-4 in. and…

A: “Since you have posted a question with multiple sub parts, we will provide the solution only to the…

Q: LO2: Perform kinematics analysis of different mechanisms. Q.1 Determine velocity of link 4 using…

A: Given r1=10cm=0.10r2=12 cm =0.12 mθ2=60°ω2=500 rpm Find the velocity link 4

Q: Identify the number of links, full joints and half joints, and then determine the degree of freedom…

A: Identify the number of links, full joints and half joints, and then determine the degree of freedom…

Q: P4.23, determine (a) the angular velocity of link 3 (b) the velocity of point C Use a complex number…

A: ro2b=5 cm=arbc=6 cm=crbd=10cm=b displacement1......aeiθ2+beiθ3=xvelocity…

Q: The mechanism below is analyzed as a pin-jointed four bar linkage. The link 2 (OA) is the input…

A:

Q: Analytically position the links for the shearing mech anism in the configuration shown in Figure…

A:

Q: The device shown in figure below can be analyzed as a pin-jointed fourbar mechanism in series with a…

A: The angle made by the link OC with the horizontal axis, The length of the link AB, The length of the…

Buckling of columns

The column is described as a vertical member of the structure that carries an axial compressive load, and buckling is a lateral deformation of the column under the application of load.