Q23) What is the step size of the DAC shown below? Note that Vref= 16 volts. || + 16 Volts RD 184 K Rf Rc 92 K RB 46 K RA TAAA 23 K A. 1.067 V| B. 1.678 V C. - 1.067 V D. - 1.678 V

Q: load current is continuous current.

A: given full wave rectifier with L = 6.5 mH, R= 2.5 ohm, E= 10 V  frequency = 60 Hz assume that the…

Q: Vi Ru Ri Vz 2. I, R2 = 3837.79 Q. R1 = 3763.67 Q. R3 = 3989.3 Q. R4 = 2898.06 N. V1 = 4.8 V. V2 =…

A: L

Q: A dual slope A/D converter has a reference voltage  of 8.000 volts.  The time to charge the…

A: From the given data, Discharging time (t2) = 0.315ms Charging time (t1) = 0.516ms Reference Voltage…

Q: 6. A buck converter is to work from a 48 V input and supply a 15 V output at power levels from 5 W…

A:

Q: Q1 Analyse the circuit shown in Figure Q1, (а) Name the function of each Op-Amp, A1, A2, A3, and A4…

A:

Q: Clock Construct the State Transition Diagram for the following circuit. Please include all steps. 1…

A: Given

Q: Draw a chip layout/diagram for the image using a 74LS00 chip.

A: According to the question, for the given circuit shown below We need to draw a chip layout/diagram…

Q: A 4-bit DAC can be produced with a R-2R ladder method. a) Draw the circuit. b) Write down an…

A: The digital to analog circuit is used to convert the given digital value into analog value and one…

Q: (a) s²+2s +1' (b) 22. The input x and output y of a system are described by: $²+7s + 12' dy dx + 2y…

A:

Q: 15. For the following sequential circuit, Find the state table. FF0 FF1 Do 20 D₁ Q₁ C C Q₁

A: Step 1: To find the state table for the given sequential circuit, we need to first identify the…

Q: A 12 bit DAC has a lower reference voltage of OV and an upper reference voltage of 3.0V What is the…

A: Given Data: 12-Bit DAC Lower reference voltage=0V Upper reference voltage=3V Digital Input=0x74B…

Q: Anything AND'ed with its complement will give an output of a.0 b.1 c.Could be 1 or 0 d.This is not…

A: AND operation gives a output one only when the  two input are are logic 1 , otherwise gives zero in…

Digital to Analog Converters

Digital to analog converters are commonly known as DAC, digital analog converter, D2A, or Digital-to-Analog converters. DACs are one of the important devices used in the electronics and electrical domain. DACs are the systems that convert a digital signal into an analog signal, whereas an analog to digital converter or ADC performs the opposite function. Digital signals are those signals that can represent the information or data as a set of discrete values. At a particular instant of time, a digital signal can only take a particular value of data. A digital signal is characterized by two unique values; zeros and ones, or true and false, represented by the Boolean domain. These are also known as binary signals or logic signals. Unlike digital signals, an analog signal is represented by continuous values, where at any time instant, the analog signal is represented by a real number.