Q2. Write either (T) for True or (F) for False on the followi1. The free running frequency of the LM565 FM demodulator circuit is set internally.2. For an FM carrier signal of frequency of 90 MHz, the local oscillator superheterodynereceiver is set to 107 MHz.3. For a carrier of 800 kHz, the output of the IF amplifier in AM receiver contains an imagefrequency of 1600 kHz.4. If the frequency band of the information signal extends to 10 kHz the upper limit of theoutput spectrum of the IF amplifier in AM receiver is 465 kHz.5.The frequency range of the LM386 audio amplifier can extends to more than 15 kHz.6. The voltage gain of the LM386 audio amplifier can be set to 120 dB by connecting a suitableresistor and capacitor between pins 1 and 8.

Q2. Write either (T) for True or (F) for False on the followi... 1. The free running frequency of the LM565 FM demodulator circuit is set internally. 2. For an FM carrier signal of frequency of 90 MHz, the local oscillator superheterodyne receiver is set to 107 MHz. 3. For a carrier of 800 kHz, the output of the IF amplifier in AM receiver contains an image frequency of 1600 kHz.

Q2. Write either (T) for True or (F) for False on the followi... 1. The free running frequency of the LM565 FM demodulator circuit is set internally. 2. For an FM carrier signal of frequency of 90 MHz, the local oscillator superheterodyne receiver is set to 107 MHz. 3. For a carrier of 800 kHz, the output of the IF amplifier in AM receiver contains an image frequency of 1600 kHz.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

4. The information in an analog voltage waveform is to be transmitted over a PCM system with a F 0.2% accuracy (full scale). The analog waveform has a bandwidth of 200 Hz, and an amplitude range of -5 to +5 V. determine the following: - The minimum sampling rate needed. - The number of bits needed in each PCM word. - The minimum bit rate in the PCM signal. - The minimum channel bandwidth for transmission of this PCM signal.
AF ADM system is designed to operate at 3 times the Nyquist rate for a signal with a 3 kHz bandwidth. The quantizing step size is 250 mV. *** (i) Determine the maximum amplitude of a 1-kHz input siinusoid for which the delta modulator does not show slope overload. (ii) Determine the posfiltered output part (i) signal-to-quantizing-noise ratio for the signal of
What is the main disadvantage of linear delta modulation? What is the solution for this problem? this question from digital communication course.
Give the formula for modulation index and explain its terms.
In an AM signal with peak amplitude of 400 volts and a peak modulating voltage of 100 volts, what is the modulation factor? a.0.33 b.0.6 c.0.5 d.0.55
The figure shows the AM modulated signal. What is modulation index?
5-If the FM modulating signal is 300 kHz, and the carrier swing is 300 kHz. Therefore, the value and the type of the modulation index are, a) 0.5 NBFM b) 0.5 WBFM c) 1 NBFM d) 1 WBFM 6- IF the modulation index of FM signal is 2, the number of significant sidebands which greater than 1% of unmodulated carrier is? (Follow the table in the last page) a) 4 sidebands b) 6 sidebands c) 8 sidebands d) 10 sidebands 7- Let the carrier given 10cos(2nd) and the message signal be 5cos(10mt). Assume the message is used to frequency modulate the carrier with ky-10, the modulation index is, a) 1 b) 5 c) 10 d) 15
If the amplitude of the modulation signal voltage was given to be -4v and +4v and carrier amplitude also given to be -22v and +22v, by suitable waveform diagram determine the Am modulated output. Remember to provide all necessary wave forms in practical terms.
Q. Suppose that you have an angle modulaton system with an input signal £01) s wiangle wave of fundamental frequency 5 kiz and its most power is concentrated in the frst third harmonics, the masimum and minimu voltage ae | and -1 espectively. where one period equation of theinput s o[BIl 0
C- Put TRUE or FALSE for only TWO of the following and say why: 1. PCM modulation is very complex technique compared to DM. 2. Envelope detection for PSK signal is possible via using DPSK. 3. A frequency reuse factor can be reached to "1" as a maximum value.
Type your question here Determine the saving, in signal power, in the case of 50% modulated AM signal, if the carrier is suppressed before transmission.
.